drm/amd/display: 3.2.204

This version brings along following fixes:
- Fix urgent latency override for DCN32/DCN321
- Correct hostvm flag in DCN31
- Added new Asic Id for DCN301
- Adjust to 2 phys in DCN301
- Update dummy P-state search to use DCN32 DML
- Increase dcn315 pstate change latency
- Disable OTG WA for the plane_state NULL case on DCN314
- Update dccg based on HW delta
- Correct num_dsc for DCN314
- Fix DP DSC compliance failure with DCN314
- Refactor edp power sequencer codes
- update gamut remap if plane has changed
- Skip audio setup when audio stream is enabled
- Display distortion after hotplug LG Ultrafine 5K tiled display
- Fix DP MST timeslot issue when fallback happened
- Uncomment SubVP pipe split assignment in driver
- Enable committing subvp config
- Do second pass through DML for DET calculation
- Don't allocate DET for phantom pipes
- Modify DML to adjust Vstartup Position
- Ignore k1/k2 values for virtual signal to avoid assert
- Fix failures of disabling primary planes
- Do not compare integers of different widths
- Fix empty slot problem of EDID management
- Revise Sink device string ID width in dmub psr
- Log vertical interrupt 1 for debug
Acked-by: Wayne Lin <wayne.lin@amd.com>
Signed-off-by: Aric Cyr <aric.cyr@amd.com>
Tested-by: Daniel Wheeler <daniel.wheeler@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

drivers/gpu/drm/amd/display/dc/dc.h

@@ -47,7 +47,7 @@ struct aux_payload;
 struct set_config_cmd_payload;
 struct dmub_notification;
 
-#define DC_VER "3.2.203"
+#define DC_VER "3.2.204"
 
 #define MAX_SURFACES 3
 #define MAX_PLANES 6