Commit e4e449e8 authored by Mark Brown's avatar Mark Brown Committed by Grant Likely

gpiolib: Add comments explaining the _cansleep() WARN_ON()s

I've seen users getting very confused by the WARN_ON()s for can_sleep
GPIOs in the atomic-safe paths, the discoverability of the non-atomic
version of the API seems to be hampered by the fact that it's defined
in a header file not the .c file where the warnings are.

Add a couple of comments next to the warnings to help people on their
way.
Signed-off-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
Reviwed-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: default avatarGrant Likely <grant.likely@secretlab.ca>
parent 25553ff0
......@@ -1581,6 +1581,7 @@ int __gpio_get_value(unsigned gpio)
int value;
chip = gpio_to_chip(gpio);
/* Should be using gpio_get_value_cansleep() */
WARN_ON(chip->can_sleep);
value = chip->get ? chip->get(chip, gpio - chip->base) : 0;
trace_gpio_value(gpio, 1, value);
......@@ -1653,6 +1654,7 @@ void __gpio_set_value(unsigned gpio, int value)
struct gpio_chip *chip;
chip = gpio_to_chip(gpio);
/* Should be using gpio_set_value_cansleep() */
WARN_ON(chip->can_sleep);
trace_gpio_value(gpio, 0, value);
if (test_bit(FLAG_OPEN_DRAIN, &gpio_desc[gpio].flags))
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment