Commit e5f710cf authored by Maxim Levitsky's avatar Maxim Levitsky Committed by David Woodhouse

mtd: nand: split out ECC module

This way drivers could use ecc routines without depedency on whole nand
Signed-off-by: default avatarMaxim Levitsky <maximlevitsky@gmail.com>
Signed-off-by: default avatarDavid Woodhouse <David.Woodhouse@intel.com>
parent ca7081d9
......@@ -307,8 +307,9 @@ config SSFDC
config SM_FTL
tristate "SmartMedia/xD new translation layer"
depends on EXPERIMENTAL && BLOCK && MTD_NAND
depends on EXPERIMENTAL && BLOCK
select MTD_BLKDEVS
select MTD_NAND_ECC
help
This enables new and very EXPERMENTAL support for SmartMedia/xD
FTL (Flash translation layer).
......
......@@ -2,11 +2,23 @@ menuconfig MTD_NAND
tristate "NAND Device Support"
depends on MTD
select MTD_NAND_IDS
select MTD_NAND_ECC
help
This enables support for accessing all type of NAND flash
devices. For further information see
<http://www.linux-mtd.infradead.org/doc/nand.html>.
config MTD_NAND_ECC
tristate
config MTD_NAND_ECC_SMC
bool "NAND ECC Smart Media byte order"
depends on MTD_NAND_ECC
default n
help
Software ECC according to the Smart Media Specification.
The original Linux implementation had byte 0 and 1 swapped.
if MTD_NAND
config MTD_NAND_VERIFY_WRITE
......@@ -18,13 +30,6 @@ config MTD_NAND_VERIFY_WRITE
device thinks the write was successful, a bit could have been
flipped accidentally due to device wear or something else.
config MTD_NAND_ECC_SMC
bool "NAND ECC Smart Media byte order"
default n
help
Software ECC according to the Smart Media Specification.
The original Linux implementation had byte 0 and 1 swapped.
config MTD_SM_COMMON
tristate
default n
......
......@@ -2,7 +2,8 @@
# linux/drivers/nand/Makefile
#
obj-$(CONFIG_MTD_NAND) += nand.o nand_ecc.o
obj-$(CONFIG_MTD_NAND) += nand.o
obj-$(CONFIG_MTD_NAND_ECC) += nand_ecc.o
obj-$(CONFIG_MTD_NAND_IDS) += nand_ids.o
obj-$(CONFIG_MTD_SM_COMMON) += sm_common.o
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment