remoteproc/keystone: Add a remoteproc driver for Keystone 2 DSPs

The Texas Instrument's Keystone 2 family of SoCs has 1 or more
TMS320C66x DSP Core Subsystems (C66x CorePacs). Each subsystem has
a C66x Fixed/Floating-Point DSP Core, with 32KB of L1P and L1D SRAMs,
that can be configured and partitioned as either RAM and/or Cache,
and 1 MB of L2 SRAM. The CorePac also includes an Internal DMA (IDMA),
External Memory Controller (EMC), Extended Memory Controller (XMC)
with a Memory Protection and Address Extension (MPAX) unit, a Bandwidth
Management (BWM) unit, an Interrupt Controller (INTC) and a Powerdown
Controller (PDC).

A new remoteproc module is added to perform the device management of
these DSP devices. The driver expects the firmware names to be of the
form "keystone-dsp<X>-fw", where X is the corresponding DSP number, and
uses the standard remoteproc core ELF loader. The support is limited
to images only using the DSP internal memories at the moment. This
remoteproc driver is also designed to work with virtio, and uses the
IPC Generation registers for performing the virtio signalling and
getting notified of exceptions.

The driver currently supports the 66AK2H/66AK2K, 66AK2L and 66AK2E
SoCs.
Signed-off-by: Suman Anna <s-anna@ti.com>
Signed-off-by: Sam Nelson <sam.nelson@ti.com>
Signed-off-by: Andrew F. Davis <afd@ti.com>
Acked-by: Santosh Shilimkar <ssantosh@kernel.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>

drivers/remoteproc/Kconfig

@@ -71,6 +71,19 @@ config DA8XX_REMOTEPROC
 	  It's safe to say n here if you're not interested in multimedia
 	  offloading.
 
+config KEYSTONE_REMOTEPROC
+	tristate "Keystone Remoteproc support"
+	depends on ARCH_KEYSTONE
+	depends on RESET_CONTROLLER
+	depends on REMOTEPROC
+	select RPMSG_VIRTIO
+	help
+	  Say Y here here to support Keystone remote processors (DSP)
+	  via the remote processor framework.
+
+	  It's safe to say N here if you're not interested in the Keystone
+	  DSPs or just want to use a bare minimum kernel.
+
 config QCOM_ADSP_PIL
 	tristate "Qualcomm ADSP Peripheral Image Loader"
 	depends on OF && ARCH_QCOM

drivers/remoteproc/Makefile

@@ -11,6 +11,7 @@ remoteproc-y				+= remoteproc_elf_loader.o
 obj-$(CONFIG_OMAP_REMOTEPROC)		+= omap_remoteproc.o
 obj-$(CONFIG_WKUP_M3_RPROC)		+= wkup_m3_rproc.o
 obj-$(CONFIG_DA8XX_REMOTEPROC)		+= da8xx_remoteproc.o
+obj-$(CONFIG_KEYSTONE_REMOTEPROC)	+= keystone_remoteproc.o
 obj-$(CONFIG_QCOM_ADSP_PIL)		+= qcom_adsp_pil.o
 obj-$(CONFIG_QCOM_RPROC_COMMON)		+= qcom_common.o
 obj-$(CONFIG_QCOM_Q6V5_PIL)		+= qcom_q6v5_pil.o