Commit e9d76c2d authored by Michael Hennerich's avatar Michael Hennerich Committed by Bryan Wu

[Blackfin] arch: Add Support for ISP1362

Signed-off-by: default avatarMichael Hennerich <michael.hennerich@analog.com>
Signed-off-by: default avatarBryan Wu <bryan.wu@analog.com>
parent c8279023
......@@ -92,6 +92,47 @@ void __exit bfin_isp1761_exit(void)
arch_initcall(bfin_isp1761_init);
#endif
#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
#include <linux/usb/isp1362.h>
static struct resource isp1362_hcd_resources[] = {
{
.start = 0x2c060000,
.end = 0x2c060000,
.flags = IORESOURCE_MEM,
}, {
.start = 0x2c060004,
.end = 0x2c060004,
.flags = IORESOURCE_MEM,
}, {
.start = IRQ_PF8,
.end = IRQ_PF8,
.flags = IORESOURCE_IRQ,
},
};
static struct isp1362_platform_data isp1362_priv = {
.sel15Kres = 1,
.clknotstop = 0,
.oc_enable = 0,
.int_act_high = 0,
.int_edge_triggered = 0,
.remote_wakeup_connected = 0,
.no_power_switching = 1,
.power_switching_mode = 0,
};
static struct platform_device isp1362_hcd_device = {
.name = "isp1362-hcd",
.id = 0,
.dev = {
.platform_data = &isp1362_priv,
},
.num_resources = ARRAY_SIZE(isp1362_hcd_resources),
.resource = isp1362_hcd_resources,
};
#endif
/*
* USB-LAN EzExtender board
* Driver needs to know address, irq and flag pin.
......@@ -359,6 +400,11 @@ static struct platform_device *ezkit_devices[] __initdata = {
#if defined(CONFIG_I2C_GPIO) || defined(CONFIG_I2C_GPIO_MODULE)
&i2c_gpio_device,
#endif
#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
&isp1362_hcd_device,
#endif
&ezkit_flash_device,
};
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment