scsi/ufs: qcom: Set phy mode based on the controllers HS MODE

Set the phy mode based on the UFS HS PA mode. This lets the
controller let phy know the mode in which the PHY Adapter is
running and set the phy rates accordingly.
Signed-off-by: Vivek Gautam <vivek.gautam@codeaurora.org>
Reviewed-by: Subhash Jadavani <subhashj@codeaurora.org>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>

drivers/scsi/ufs/ufs-qcom.c

@@ -273,6 +273,9 @@ static int ufs_qcom_power_up_sequence(struct ufs_hba *hba)
 	bool is_rate_B = (UFS_QCOM_LIMIT_HS_RATE == PA_HS_MODE_B)
 							? true : false;
 
+	if (is_rate_B)
+		phy_set_mode(phy, PHY_MODE_UFS_HS_B);
+
 	/* Assert PHY reset and apply PHY calibration values */
 	ufs_qcom_assert_reset(hba);
 	/* provide 1ms delay to let the reset pulse propagate */