Commit eb798c64 authored by Vinit Shenoy's avatar Vinit Shenoy Committed by Grant Likely

spi/pl022: Fix range checking for bits per word

pl022 ssp controller supports word lengths from 4 to 16 (or 32) bits.
Currently implemented checks were incorrect. It has following check

if (pl022->vendor->max_bpw >= 32)

which must be checking for <=.

Also error print message is incorrect, that prints "range is from 1 to
16".

Fix both these issues.
Signed-off-by: default avatarVinit Shenoy <vinit.shenoy@st.com>
Acked-by: default avatarLinus Walleij <linus.walleij@linaro.org>
Signed-off-by: default avatarGrant Likely <grant.likely@secretlab.ca>
parent e816b57a
...@@ -1823,9 +1823,12 @@ static int pl022_setup(struct spi_device *spi) ...@@ -1823,9 +1823,12 @@ static int pl022_setup(struct spi_device *spi)
} else } else
chip->cs_control = chip_info->cs_control; chip->cs_control = chip_info->cs_control;
if (bits <= 3) { /* Check bits per word with vendor specific range */
/* PL022 doesn't support less than 4-bits */ if ((bits <= 3) || (bits > pl022->vendor->max_bpw)) {
status = -ENOTSUPP; status = -ENOTSUPP;
dev_err(&spi->dev, "illegal data size for this controller!\n");
dev_err(&spi->dev, "This controller can only handle 4 <= n <= %d bit words\n",
pl022->vendor->max_bpw);
goto err_config_params; goto err_config_params;
} else if (bits <= 8) { } else if (bits <= 8) {
dev_dbg(&spi->dev, "4 <= n <=8 bits per word\n"); dev_dbg(&spi->dev, "4 <= n <=8 bits per word\n");
...@@ -1838,20 +1841,10 @@ static int pl022_setup(struct spi_device *spi) ...@@ -1838,20 +1841,10 @@ static int pl022_setup(struct spi_device *spi)
chip->read = READING_U16; chip->read = READING_U16;
chip->write = WRITING_U16; chip->write = WRITING_U16;
} else { } else {
if (pl022->vendor->max_bpw >= 32) { dev_dbg(&spi->dev, "17 <= n <= 32 bits per word\n");
dev_dbg(&spi->dev, "17 <= n <= 32 bits per word\n"); chip->n_bytes = 4;
chip->n_bytes = 4; chip->read = READING_U32;
chip->read = READING_U32; chip->write = WRITING_U32;
chip->write = WRITING_U32;
} else {
dev_err(&spi->dev,
"illegal data size for this controller!\n");
dev_err(&spi->dev,
"a standard pl022 can only handle "
"1 <= n <= 16 bit words\n");
status = -ENOTSUPP;
goto err_config_params;
}
} }
/* Now Initialize all register settings required for this chip */ /* Now Initialize all register settings required for this chip */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment