sky2: phy irq on shutdown

When PHY is turned off on shutdown, it causes the IRQ to get stuck on.
Make sure and disable the IRQ first, and if IRQ occurs when device
is not running, don't access PHY because that will hang.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>

drivers/net/sky2.c

@@ -1499,6 +1499,11 @@ static int sky2_down(struct net_device *dev)
 	/* Stop more packets from being queued */
 	netif_stop_queue(dev);
 
+	/* Disable port IRQ */
+	imask = sky2_read32(hw, B0_IMSK);
+	imask &= ~portirq_msk[port];
+	sky2_write32(hw, B0_IMSK, imask);
+
 	sky2_gmac_reset(hw, port);
 
 	/* Stop transmitter */
@@ -1549,11 +1554,6 @@ static int sky2_down(struct net_device *dev)
 	sky2_write8(hw, SK_REG(port, RX_GMF_CTRL_T), GMF_RST_SET);
 	sky2_write8(hw, SK_REG(port, TX_GMF_CTRL_T), GMF_RST_SET);
 
-	/* Disable port IRQ */
-	imask = sky2_read32(hw, B0_IMSK);
-	imask &= ~portirq_msk[port];
-	sky2_write32(hw, B0_IMSK, imask);
-
 	sky2_phy_power(hw, port, 0);
 
 	/* turn off LED's */
@@ -1750,13 +1750,13 @@ static void sky2_phy_intr(struct sky2_hw *hw, unsigned port)
 	struct sky2_port *sky2 = netdev_priv(dev);
 	u16 istatus, phystat;
 
+	if (!netif_running(dev))
+		return;
+
 	spin_lock(&sky2->phy_lock);
 	istatus = gm_phy_read(hw, port, PHY_MARV_INT_STAT);
 	phystat = gm_phy_read(hw, port, PHY_MARV_PHY_STAT);
 
-	if (!netif_running(dev))
-		goto out;
-
 	if (netif_msg_intr(sky2))
 		printk(KERN_INFO PFX "%s: phy interrupt status 0x%x 0x%x\n",
 		       sky2->netdev->name, istatus, phystat);