mlxbf_gige: clear valid_polarity upon open

The network interface managed by the mlxbf_gige driver can
get into a problem state where traffic does not flow.
In this state, the interface will be up and enabled, but
will stop processing received packets.  This problem state
will happen if three specific conditions occur:
    1) driver has received more than (N * RxRingSize) packets but
       less than (N+1 * RxRingSize) packets, where N is an odd number
       Note: the command "ethtool -g <interface>" will display the
       current receive ring size, which currently defaults to 128
    2) the driver's interface was disabled via "ifconfig oob_net0 down"
       during the window described in #1.
    3) the driver's interface is re-enabled via "ifconfig oob_net0 up"

This patch ensures that the driver's "valid_polarity" field is
cleared during the open() method so that it always matches the
receive polarity used by hardware.  Without this fix, the driver
needs to be unloaded and reloaded to correct this problem state.

Fixes: f92e1869 ("Add Mellanox BlueField Gigabit Ethernet driver")
Reviewed-by: Asmaa Mnebhi <asmaa@nvidia.com>
Signed-off-by: David Thompson <davthompson@nvidia.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/mellanox/mlxbf_gige/mlxbf_gige_main.c

@@ -142,6 +142,13 @@ static int mlxbf_gige_open(struct net_device *netdev)
 	err = mlxbf_gige_clean_port(priv);
 	if (err)
 		goto free_irqs;
+
+	/* Clear driver's valid_polarity to match hardware,
+	 * since the above call to clean_port() resets the
+	 * receive polarity used by hardware.
+	 */
+	priv->valid_polarity = 0;
+
 	err = mlxbf_gige_rx_init(priv);
 	if (err)
 		goto free_irqs;