ARM: at91: fix at91sam9261ek Ethernet dm9000 irq

You need to setup the dm9000 irq via gpio_to_irq() since
d0fbda9a (ARM: at91/gpio: drop PIN_BASE).
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Cc: stable <stable@vger.kernel.org>	[3.2+]

arch/arm/mach-at91/board-sam9261ek.c

@@ -85,8 +85,6 @@ static struct resource dm9000_resource[] = {
 		.flags	= IORESOURCE_MEM
 	},
 	[2] = {
-		.start	= AT91_PIN_PC11,
-		.end	= AT91_PIN_PC11,
 		.flags	= IORESOURCE_IRQ
 			| IORESOURCE_IRQ_LOWEDGE | IORESOURCE_IRQ_HIGHEDGE,
 	}
@@ -130,6 +128,8 @@ static struct sam9_smc_config __initdata dm9000_smc_config = {
 
 static void __init ek_add_device_dm9000(void)
 {
+	struct resource *r = &dm9000_resource[2];
+
 	/* Configure chip-select 2 (DM9000) */
 	sam9_smc_configure(0, 2, &dm9000_smc_config);
 
@@ -139,6 +139,7 @@ static void __init ek_add_device_dm9000(void)
 	/* Configure Interrupt pin as input, no pull-up */
 	at91_set_gpio_input(AT91_PIN_PC11, 0);
 
+	r->start = r->end = gpio_to_irq(AT91_PIN_PC11);
 	platform_device_register(&dm9000_device);
 }
 #else