bus: ti-sysc: Enable interconnect target module autoidle bit on enable

For interconnect target modules with autoidle bit wired, we need to manage
it for enable and disable.
Tested-by: Keerthy <j-keerthy@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

drivers/bus/ti-sysc.c

@@ -893,7 +893,7 @@ static int sysc_enable_module(struct device *dev)
 	/* Set MIDLE mode */
 	idlemodes = ddata->cfg.midlemodes;
 	if (!idlemodes || regbits->midle_shift < 0)
-		return 0;
+		goto set_autoidle;
 
 	best_mode = fls(ddata->cfg.midlemodes) - 1;
 	if (best_mode > SYSC_IDLE_MASK) {
@@ -905,6 +905,14 @@ static int sysc_enable_module(struct device *dev)
 	reg |= best_mode << regbits->midle_shift;
 	sysc_write(ddata, ddata->offsets[SYSC_SYSCONFIG], reg);
 
+set_autoidle:
+	/* Autoidle bit must enabled separately if available */
+	if (regbits->autoidle_shift >= 0 &&
+	    ddata->cfg.sysc_val & BIT(regbits->autoidle_shift)) {
+		reg |= 1 << regbits->autoidle_shift;
+		sysc_write(ddata, ddata->offsets[SYSC_SYSCONFIG], reg);
+	}
+
 	return 0;
 }
 
@@ -966,6 +974,9 @@ static int sysc_disable_module(struct device *dev)
 
 	reg &= ~(SYSC_IDLE_MASK << regbits->sidle_shift);
 	reg |= best_mode << regbits->sidle_shift;
+	if (regbits->autoidle_shift >= 0 &&
+	    ddata->cfg.sysc_val & BIT(regbits->autoidle_shift))
+		reg |= 1 << regbits->autoidle_shift;
 	sysc_write(ddata, ddata->offsets[SYSC_SYSCONFIG], reg);
 
 	return 0;