thermal: imx: add i.MX7 thermal sensor support

This patch adds i.MX7 thermal sensor support, most
of the i.MX7 thermal sensor functions are same with
i.MX6 except the registers offset/layout, so we move
those registers offset/layout definitions to soc data
structure.

i.MX7 uses single calibration data @25C, the calibration
data is located at OCOTP offset 0x4F0, bit[17:9], the
formula is as below:

Tmeas = (Nmeas - n1) + 25; n1 is the fuse value for 25C.
Signed-off-by: Anson Huang <Anson.Huang@nxp.com>
Signed-off-by: Bai Ping <ping.bai@nxp.com>
Acked-by: Dong Aisheng <aisheng.dong@nxp.com>
Acked-by: Shawn Guo <shawnguo@kernel.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Eduardo Valentin <edubezval@gmail.com>

Documentation/devicetree/bindings/thermal/imx-thermal.txt

 * Temperature Monitor (TEMPMON) on Freescale i.MX SoCs
 
 Required properties:
-- compatible : "fsl,imx6q-tempmon" for i.MX6Q, "fsl,imx6sx-tempmon" for i.MX6SX.
-  i.MX6SX has two more IRQs than i.MX6Q, one is IRQ_LOW and the other is IRQ_PANIC,
+- compatible : must be one of following:
+  - "fsl,imx6q-tempmon" for i.MX6Q,
+  - "fsl,imx6sx-tempmon" for i.MX6SX,
+  - "fsl,imx7d-tempmon" for i.MX7S/D.
+- interrupts : the interrupt output of the controller:
+  i.MX6Q has one IRQ which will be triggered when temperature is higher than high threshold,
+  i.MX6SX and i.MX7S/D have two more IRQs than i.MX6Q, one is IRQ_LOW and the other is IRQ_PANIC,
   when temperature is below than low threshold, IRQ_LOW will be triggered, when temperature
   is higher than panic threshold, system will auto reboot by SRC module.
 - fsl,tempmon : phandle pointer to system controller that contains TEMPMON