Commit f161ead7 authored by Mathias Nyman's avatar Mathias Nyman Committed by Greg Kroah-Hartman

xhci: Check if slot is already in default state before moving it there

Solves xhci error cases with debug messages:
xhci_hcd 0000:00:14.0: Setup ERROR: setup context command for slot 1.
usb 1-6: hub failed to enable device, error -22

xhci will give a context state error if we try to set a slot in default
state to the same default state with a special address device command.

Turns out this happends in several cases:
- retry reading the device rescriptor in hub_port_init()
- usb_reset_device() is called for a slot in default state
- in resume path, usb_port_resume() calls hub_port_init()

The default state is usually reached from most states with a reset device
command without any context state errors, but using the address device
command with BSA bit set (block set address) only works from the enabled
state and will otherwise cause context error.

solve this by checking if we are already in the default state before issuing
a address device BSA=1 command.

Fixes: 48fc7dbd ("usb: xhci: change enumeration scheme to 'new scheme'")
Cc: <stable@vger.kernel.org> # v3.14+
Signed-off-by: default avatarMathias Nyman <mathias.nyman@linux.intel.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 24c498df
...@@ -3803,6 +3803,15 @@ static int xhci_setup_device(struct usb_hcd *hcd, struct usb_device *udev, ...@@ -3803,6 +3803,15 @@ static int xhci_setup_device(struct usb_hcd *hcd, struct usb_device *udev,
return -EINVAL; return -EINVAL;
} }
if (setup == SETUP_CONTEXT_ONLY) {
slot_ctx = xhci_get_slot_ctx(xhci, virt_dev->out_ctx);
if (GET_SLOT_STATE(le32_to_cpu(slot_ctx->dev_state)) ==
SLOT_STATE_DEFAULT) {
xhci_dbg(xhci, "Slot already in default state\n");
return 0;
}
}
command = xhci_alloc_command(xhci, false, false, GFP_KERNEL); command = xhci_alloc_command(xhci, false, false, GFP_KERNEL);
if (!command) if (!command)
return -ENOMEM; return -ENOMEM;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment