be2net: use adapter->flags to track SRIOV state

The driver so far used adapter->num_vfs value to check if SR-IOV is enabled
or not. But, the patch bec84e6b("create optimal number of queues on SR-IOV
config") changed this logic. The adapter->num_vfs value is validated and set
much before SR-IOV is enabled. So, we now use an explicit flag to track
SR-IOV enabled state.
Signed-off-by: Vasundhara Volam <vasundhara.volam@emulex.com>
Signed-off-by: Sathya Perla <sathya.perla@emulex.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/emulex/benet/be.h

@@ -372,6 +372,7 @@ enum vf_state {
 };
 
 #define BE_FLAGS_LINK_STATUS_INIT		1
+#define BE_FLAGS_SRIOV_ENABLED			(1 << 2)
 #define BE_FLAGS_WORKER_SCHEDULED		(1 << 3)
 #define BE_FLAGS_VLAN_PROMISC			(1 << 4)
 #define BE_FLAGS_MCAST_PROMISC			(1 << 5)
@@ -525,7 +526,8 @@ struct be_adapter {
 
 #define be_physfn(adapter)		(!adapter->virtfn)
 #define be_virtfn(adapter)		(adapter->virtfn)
-#define sriov_enabled(adapter)		(adapter->num_vfs > 0)
+#define sriov_enabled(adapter)		(adapter->flags &	\
+					 BE_FLAGS_SRIOV_ENABLED)
 
 #define for_all_vfs(adapter, vf_cfg, i)					\
 	for (i = 0, vf_cfg = &adapter->vf_cfg[i]; i < adapter->num_vfs;	\

drivers/net/ethernet/emulex/benet/be_main.c

@@ -3049,6 +3049,7 @@ static void be_vf_clear(struct be_adapter *adapter)
 done:
 	kfree(adapter->vf_cfg);
 	adapter->num_vfs = 0;
+	adapter->flags &= ~BE_FLAGS_SRIOV_ENABLED;
 }
 
 static void be_clear_queues(struct be_adapter *adapter)
@@ -3241,6 +3242,8 @@ static int be_vf_setup(struct be_adapter *adapter)
 			goto err;
 		}
 	}
+
+	adapter->flags |= BE_FLAGS_SRIOV_ENABLED;
 	return 0;
 err:
 	dev_err(dev, "VF setup failed\n");