Commit f276aacf authored by Janne Grunau's avatar Janne Grunau Committed by Mark Brown

spi: Use a 32-bit DT property for spi-cs-setup-delay-ns

65us is not a reasonable maximum for this property, as some devices
might need a much longer setup time (e.g. those driven by firmware on
the other end). Plus, device tree property values are in 32-bit cells
and smaller widths should not be used without good reason.

Also move the logic to a helper function, since this will later be used
to parse other CS delay properties too.

Fixes: 33a2fde5 ("spi: Introduce spi-cs-setup-ns property")
Signed-off-by: default avatarJanne Grunau <j@jannau.net>
Signed-off-by: default avatarHector Martin <marcan@marcan.st>
Link: https://lore.kernel.org/r/20230113102309.18308-2-marcan@marcan.stSigned-off-by: default avatarMark Brown <broonie@kernel.org>
parent e0fe6a31
...@@ -2220,11 +2220,26 @@ void spi_flush_queue(struct spi_controller *ctlr) ...@@ -2220,11 +2220,26 @@ void spi_flush_queue(struct spi_controller *ctlr)
/*-------------------------------------------------------------------------*/ /*-------------------------------------------------------------------------*/
#if defined(CONFIG_OF) #if defined(CONFIG_OF)
static void of_spi_parse_dt_cs_delay(struct device_node *nc,
struct spi_delay *delay, const char *prop)
{
u32 value;
if (!of_property_read_u32(nc, prop, &value)) {
if (value > U16_MAX) {
delay->value = DIV_ROUND_UP(value, 1000);
delay->unit = SPI_DELAY_UNIT_USECS;
} else {
delay->value = value;
delay->unit = SPI_DELAY_UNIT_NSECS;
}
}
}
static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi, static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi,
struct device_node *nc) struct device_node *nc)
{ {
u32 value; u32 value;
u16 cs_setup;
int rc; int rc;
/* Mode (clock phase/polarity/etc.) */ /* Mode (clock phase/polarity/etc.) */
...@@ -2310,10 +2325,8 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi, ...@@ -2310,10 +2325,8 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi,
if (!of_property_read_u32(nc, "spi-max-frequency", &value)) if (!of_property_read_u32(nc, "spi-max-frequency", &value))
spi->max_speed_hz = value; spi->max_speed_hz = value;
if (!of_property_read_u16(nc, "spi-cs-setup-delay-ns", &cs_setup)) { /* Device CS delays */
spi->cs_setup.value = cs_setup; of_spi_parse_dt_cs_delay(nc, &spi->cs_setup, "spi-cs-setup-delay-ns");
spi->cs_setup.unit = SPI_DELAY_UNIT_NSECS;
}
return 0; return 0;
} }
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment