spi_txx9 controller driver

This is a driver for SPI controller built into TXx9 MIPS SoCs.
This driver is derived from arch/mips/tx4938/toshiba_rbtx4938/spi_txx9.c.
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

drivers/spi/Kconfig

@@ -174,6 +174,12 @@ config SPI_S3C24XX_GPIO
 	  the inbuilt hardware cannot provide the transfer mode, or
 	  where the board is using non hardware connected pins.
 
+config SPI_TXX9
+	tristate "Toshiba TXx9 SPI controller"
+	depends on SPI_MASTER && GENERIC_GPIO && CPU_TX49XX
+	help
+	  SPI driver for Toshiba TXx9 MIPS SoCs
+
 config SPI_XILINX
 	tristate "Xilinx SPI controller"
 	depends on SPI_MASTER && XILINX_VIRTEX && EXPERIMENTAL

drivers/spi/Makefile

@@ -25,6 +25,7 @@ obj-$(CONFIG_SPI_MPC52xx_PSC)		+= mpc52xx_psc_spi.o
 obj-$(CONFIG_SPI_MPC83xx)		+= spi_mpc83xx.o
 obj-$(CONFIG_SPI_S3C24XX_GPIO)		+= spi_s3c24xx_gpio.o
 obj-$(CONFIG_SPI_S3C24XX)		+= spi_s3c24xx.o
+obj-$(CONFIG_SPI_TXX9)			+= spi_txx9.o
 obj-$(CONFIG_SPI_XILINX)		+= xilinx_spi.o
 # 	... add above this line ...