Bluetooth: Get MWS transport configuration of the controller

If the Bluetooth controller supports Get MWS Transport Layer
Configuration command, then issue it during initialization.
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>

include/net/bluetooth/hci.h

@@ -1172,6 +1172,8 @@ struct hci_rp_write_remote_amp_assoc {
 	__u8     phy_handle;
 } __packed;
 
+#define HCI_OP_GET_MWS_TRANSPORT_CONFIG	0x140c
+
 #define HCI_OP_ENABLE_DUT_MODE		0x1803
 
 #define HCI_OP_WRITE_SSP_DEBUG_MODE	0x1804

net/bluetooth/hci_core.c

@@ -1690,6 +1690,10 @@ static void hci_init4_req(struct hci_request *req, unsigned long opt)
 	if (hdev->commands[29] & 0x20)
 		hci_req_add(req, HCI_OP_READ_LOCAL_CODECS, 0, NULL);
 
+	/* Get MWS transport configuration if the HCI command is supported */
+	if (hdev->commands[30] & 0x08)
+		hci_req_add(req, HCI_OP_GET_MWS_TRANSPORT_CONFIG, 0, NULL);
+
 	/* Check for Synchronization Train support */
 	if (lmp_sync_train_capable(hdev))
 		hci_req_add(req, HCI_OP_READ_SYNC_TRAIN_PARAMS, 0, NULL);