i2c: designware: Use pci_get_drvdata()

Use the wrapper function for getting the driver data using pci_dev
instead of using dev_get_drvdata() with &pdev->dev, so we can directly
pass a struct pci_dev. This is a purely cosmetic change.
Reviewed-by: Andi Shyti <andi.shyti@kernel.org>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Andi Shyti <andi.shyti@kernel.org>

drivers/i2c/busses/i2c-designware-pcidrv.c

@@ -102,7 +102,7 @@ static u32 mfld_get_clk_rate_khz(struct dw_i2c_dev *dev)
 
 static int mfld_setup(struct pci_dev *pdev, struct dw_pci_controller *c)
 {
-	struct dw_i2c_dev *dev = dev_get_drvdata(&pdev->dev);
+	struct dw_i2c_dev *dev = pci_get_drvdata(pdev);
 
 	switch (pdev->device) {
 	case 0x0817:
@@ -152,7 +152,7 @@ static u32 navi_amd_get_clk_rate_khz(struct dw_i2c_dev *dev)
 
 static int navi_amd_setup(struct pci_dev *pdev, struct dw_pci_controller *c)
 {
-	struct dw_i2c_dev *dev = dev_get_drvdata(&pdev->dev);
+	struct dw_i2c_dev *dev = pci_get_drvdata(pdev);
 
 	dev->flags |= MODEL_AMD_NAVI_GPU | ACCESS_POLLING;
 	dev->timings.bus_freq_hz = I2C_MAX_STANDARD_MODE_FREQ;