Commit f6c11c18 authored by Jamie Iles's avatar Jamie Iles Committed by David Woodhouse

mtd: scx200_docflash: convert to mtd_device_register()

Convert to mtd_device_register() and remove the CONFIG_MTD_PARTITIONS
preprocessor conditionals as partitioning is always available.
Signed-off-by: default avatarJamie Iles <jamie@jamieiles.com>
Signed-off-by: default avatarArtem Bityutskiy <Artem.Bityutskiy@nokia.com>
Signed-off-by: default avatarDavid Woodhouse <David.Woodhouse@intel.com>
parent 2fe2e24e
......@@ -184,7 +184,7 @@ config MTD_VMAX
config MTD_SCx200_DOCFLASH
tristate "Flash device mapped with DOCCS on NatSemi SCx200"
depends on SCx200 && MTD_CFI && MTD_PARTITIONS
depends on SCx200 && MTD_CFI
help
Enable support for a flash chip mapped using the DOCCS signal on a
National Semiconductor SCx200 processor.
......
......@@ -44,7 +44,6 @@ static struct resource docmem = {
static struct mtd_info *mymtd;
#ifdef CONFIG_MTD_PARTITIONS
static struct mtd_partition partition_info[] = {
{
.name = "DOCCS Boot kernel",
......@@ -68,8 +67,6 @@ static struct mtd_partition partition_info[] = {
},
};
#define NUM_PARTITIONS ARRAY_SIZE(partition_info)
#endif
static struct map_info scx200_docflash_map = {
.name = "NatSemi SCx200 DOCCS Flash",
......@@ -198,24 +195,17 @@ static int __init init_scx200_docflash(void)
mymtd->owner = THIS_MODULE;
#ifdef CONFIG_MTD_PARTITIONS
partition_info[3].offset = mymtd->size-partition_info[3].size;
partition_info[2].size = partition_info[3].offset-partition_info[2].offset;
add_mtd_partitions(mymtd, partition_info, NUM_PARTITIONS);
#else
add_mtd_device(mymtd);
#endif
mtd_device_register(mymtd, partition_info, NUM_PARTITIONS);
return 0;
}
static void __exit cleanup_scx200_docflash(void)
{
if (mymtd) {
#ifdef CONFIG_MTD_PARTITIONS
del_mtd_partitions(mymtd);
#else
del_mtd_device(mymtd);
#endif
mtd_device_unregister(mymtd);
map_destroy(mymtd);
}
if (scx200_docflash_map.virt) {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment