Commit f7a35df1 authored by Mauro Carvalho Chehab's avatar Mauro Carvalho Chehab

[media] stv090x: Don't use dynamic static allocation

Dynamic static allocation is evil, as Kernel stack is too low, and
compilation complains about it on some archs:
       drivers/media/dvb-frontends/stv090x.c:750:1: warning: 'stv090x_write_regs.constprop.6' uses dynamic stack allocation [enabled by default]
Instead, let's enforce a limit for the buffer. Considering that I2C
transfers are generally limited, and that devices used on USB has a
max data length of 64 bytes for	the control URBs.
So, it seem safe to use 64 bytes as the hard limit for all those devices.
 On most cases, the limit is a way lower than that, but	this limit
is small enough to not affect the Kernel stack, and it is a no brain
limit, as using smaller ones would require to either carefully each
driver or to take a look on each datasheet.
Signed-off-by: default avatarMauro Carvalho Chehab <m.chehab@samsung.com>
Reviewed-by: default avatarHans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: default avatarMauro Carvalho Chehab <m.chehab@samsung.com>
parent 9aca4fb0
......@@ -35,6 +35,9 @@
#include "stv090x.h"
#include "stv090x_priv.h"
/* Max transfer size done by I2C transfer functions */
#define MAX_XFER_SIZE 64
static unsigned int verbose;
module_param(verbose, int, 0644);
......@@ -722,9 +725,16 @@ static int stv090x_write_regs(struct stv090x_state *state, unsigned int reg, u8
{
const struct stv090x_config *config = state->config;
int ret;
u8 buf[2 + count];
u8 buf[MAX_XFER_SIZE];
struct i2c_msg i2c_msg = { .addr = config->address, .flags = 0, .buf = buf, .len = 2 + count };
if (2 + count > sizeof(buf)) {
printk(KERN_WARNING
"%s: i2c wr reg=%04x: len=%d is too big!\n",
KBUILD_MODNAME, reg, count);
return -EINVAL;
}
buf[0] = reg >> 8;
buf[1] = reg & 0xff;
memcpy(&buf[2], data, count);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment