Commit f7b6985c authored by Eric Auger's avatar Eric Auger Committed by Christoffer Dall

KVM: arm/arm64: vgic-new: Add vgic_v2/v3_enable

Enable the VGIC operation by properly initialising the registers
in the hypervisor GIC interface.
Signed-off-by: default avatarEric Auger <eric.auger@linaro.org>
Signed-off-by: default avatarAndre Przywara <andre.przywara@arm.com>
Reviewed-by: default avatarChristoffer Dall <christoffer.dall@linaro.org>
parent b0442ee2
......@@ -206,9 +206,18 @@ void vgic_v2_get_vmcr(struct kvm_vcpu *vcpu, struct vgic_vmcr *vmcrp)
GICH_VMCR_PRIMASK_SHIFT;
}
/* not yet implemented */
void vgic_v2_enable(struct kvm_vcpu *vcpu)
{
/*
* By forcing VMCR to zero, the GIC will restore the binary
* points to their reset values. Anything else resets to zero
* anyway.
*/
vcpu->arch.vgic_cpu.vgic_v2.vgic_vmcr = 0;
vcpu->arch.vgic_cpu.vgic_v2.vgic_elrsr = ~0;
/* Get the show on the road... */
vcpu->arch.vgic_cpu.vgic_v2.vgic_hcr = GICH_HCR_EN;
}
/* check for overlapping regions and for regions crossing the end of memory */
......
......@@ -186,9 +186,30 @@ void vgic_v3_get_vmcr(struct kvm_vcpu *vcpu, struct vgic_vmcr *vmcrp)
vmcrp->pmr = (vmcr & ICH_VMCR_PMR_MASK) >> ICH_VMCR_PMR_SHIFT;
}
/* not yet implemented */
void vgic_v3_enable(struct kvm_vcpu *vcpu)
{
struct vgic_v3_cpu_if *vgic_v3 = &vcpu->arch.vgic_cpu.vgic_v3;
/*
* By forcing VMCR to zero, the GIC will restore the binary
* points to their reset values. Anything else resets to zero
* anyway.
*/
vgic_v3->vgic_vmcr = 0;
vgic_v3->vgic_elrsr = ~0;
/*
* If we are emulating a GICv3, we do it in an non-GICv2-compatible
* way, so we force SRE to 1 to demonstrate this to the guest.
* This goes with the spec allowing the value to be RAO/WI.
*/
if (vcpu->kvm->arch.vgic.vgic_model == KVM_DEV_TYPE_ARM_VGIC_V3)
vgic_v3->vgic_sre = ICC_SRE_EL1_SRE;
else
vgic_v3->vgic_sre = 0;
/* Get the show on the road... */
vgic_v3->vgic_hcr = ICH_HCR_EN;
}
/* check for overlapping regions and for regions crossing the end of memory */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment