MIPS: boot: Support specifying UART port on Ingenic SoCs

Allow specifying from the config the UART to use on Ingenic SoCs when
compressed kernel debugging is enabled.
Signed-off-by: Paul Cercueil <paul@crapouillou.net>
Signed-off-by: Thomas Bogendoerfer <tsbogend@alpha.franken.de>

arch/mips/Kconfig.debug

@@ -102,6 +102,14 @@ config DEBUG_ZBOOT
 	  to reduce the kernel image size and speed up the booting procedure a
 	  little.
 
+config ZBOOT_INGENIC_UART
+	int "UART to use for compressed kernel debugging"
+	depends on DEBUG_ZBOOT && MACH_INGENIC_SOC
+	default 0
+	range 0 4
+	help
+	  Specify the UART that should be used for compressed kernel debugging.
+
 config SPINLOCK_TEST
 	bool "Enable spinlock timing tests in debugfs"
 	depends on DEBUG_FS

arch/mips/boot/compressed/uart-16550.c

@@ -19,8 +19,8 @@
 #endif
 
 #ifdef CONFIG_MACH_INGENIC
-#define INGENIC_UART0_BASE_ADDR	0x10030000
-#define PORT(offset) (CKSEG1ADDR(INGENIC_UART0_BASE_ADDR) + (4 * offset))
+#define INGENIC_UART_BASE_ADDR	(0x10030000 + 0x1000 * CONFIG_ZBOOT_INGENIC_UART)
+#define PORT(offset) (CKSEG1ADDR(INGENIC_UART_BASE_ADDR) + (4 * offset))
 #endif
 
 #ifdef CONFIG_CPU_XLR