Commit f9db5069 authored by SZ Lin (林上智)'s avatar SZ Lin (林上智) Committed by David S. Miller

net: ethernet: ti: cpsw: add check for in-band mode setting with RGMII PHY interface

According to AM335x TRM[1] 14.3.6.2, AM437x TRM[2] 15.3.6.2 and
DRA7 TRM[3] 24.11.4.8.7.3.3, in-band mode in EXT_EN(bit18) register is only
available when PHY is configured in RGMII mode with 10Mbps speed. It will
cause some networking issues without RGMII mode, such as carrier sense
errors and low throughput. TI also mentioned this issue in their forum[4].

This patch adds the check mechanism for PHY interface with RGMII interface
type, the in-band mode can only be set in RGMII mode with 10Mbps speed.

References:
[1]: https://www.ti.com/lit/ug/spruh73p/spruh73p.pdf
[2]: http://www.ti.com/lit/ug/spruhl7h/spruhl7h.pdf
[3]: http://www.ti.com/lit/ug/spruic2b/spruic2b.pdf
[4]: https://e2e.ti.com/support/arm/sitara_arm/f/791/p/640765/2392155Suggested-by: default avatarHolsety Chen (陳憲輝) <Holsety.Chen@moxa.com>
Signed-off-by: default avatarSZ Lin (林上智) <sz.lin@moxa.com>
Signed-off-by: default avatarSchuyler Patton <spatton@ti.com>
Reviewed-by: default avatarGrygorii Strashko <grygorii.strashko@ti.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent d61d263c
......@@ -1014,7 +1014,8 @@ static void _cpsw_adjust_link(struct cpsw_slave *slave,
/* set speed_in input in case RMII mode is used in 100Mbps */
if (phy->speed == 100)
mac_control |= BIT(15);
else if (phy->speed == 10)
/* in band mode only works in 10Mbps RGMII mode */
else if ((phy->speed == 10) && phy_interface_is_rgmii(phy))
mac_control |= BIT(18); /* In Band mode */
if (priv->rx_pause)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment