net: altera: tse: convert to phylink

Convert the Altera Triple Speed Ethernet Controller to phylink.
This controller supports MII, GMII and RGMII with its MAC, and
SGMII + 1000BaseX through a small embedded PCS.

The PCS itself has a register set very similar to what is found in a
typical 802.3 ethernet PHY, but this register set memory-mapped instead
of lying on an mdio bus.
Signed-off-by: Maxime Chevallier <maxime.chevallier@bootlin.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/altera/Kconfig

@@ -3,6 +3,8 @@ config ALTERA_TSE
 	tristate "Altera Triple-Speed Ethernet MAC support"
 	depends on HAS_DMA
 	select PHYLIB
+	select PHYLINK
+	select PCS_ALTERA_TSE
 	help
 	  This driver supports the Altera Triple-Speed (TSE) Ethernet MAC.
 

drivers/net/ethernet/altera/altera_tse.h

@@ -27,6 +27,7 @@
 #include <linux/list.h>
 #include <linux/netdevice.h>
 #include <linux/phy.h>
+#include <linux/phylink.h>
 
 #define ALTERA_TSE_SW_RESET_WATCHDOG_CNTR	10000
 #define ALTERA_TSE_MAC_FIFO_WIDTH		4	/* TX/RX FIFO width in
@@ -109,17 +110,6 @@
 #define MAC_CMDCFG_DISABLE_READ_TIMEOUT_GET(v)	GET_BIT_VALUE(v, 27)
 #define MAC_CMDCFG_CNT_RESET_GET(v)		GET_BIT_VALUE(v, 31)
 
-/* SGMII PCS register addresses
- */
-#define SGMII_PCS_SCRATCH	0x10
-#define SGMII_PCS_REV		0x11
-#define SGMII_PCS_LINK_TIMER_0	0x12
-#define SGMII_PCS_LINK_TIMER_1	0x13
-#define SGMII_PCS_IF_MODE	0x14
-#define SGMII_PCS_DIS_READ_TO	0x15
-#define SGMII_PCS_READ_TO	0x16
-#define SGMII_PCS_SW_RESET_TIMEOUT 100 /* usecs */
-
 /* MDIO registers within MAC register Space
  */
 struct altera_tse_mdio {
@@ -423,6 +413,9 @@ struct altera_tse_private {
 	void __iomem *tx_dma_csr;
 	void __iomem *tx_dma_desc;
 
+	/* SGMII PCS address space */
+	void __iomem *pcs_base;
+
 	/* Rx buffers queue */
 	struct tse_buffer *rx_ring;
 	u32 rx_cons;
@@ -480,6 +473,10 @@ struct altera_tse_private {
 	u32 msg_enable;
 
 	struct altera_dmaops *dmaops;
+
+	struct phylink *phylink;
+	struct phylink_config phylink_config;
+	struct phylink_pcs *pcs;
 };
 
 /* Function prototypes

drivers/net/ethernet/altera/altera_tse_ethtool.c

@@ -221,6 +221,22 @@ static void tse_get_regs(struct net_device *dev, struct ethtool_regs *regs,
 		buf[i] = csrrd32(priv->mac_dev, i * 4);
 }
 
+static int tse_ethtool_set_link_ksettings(struct net_device *dev,
+					  const struct ethtool_link_ksettings *cmd)
+{
+	struct altera_tse_private *priv = netdev_priv(dev);
+
+	return phylink_ethtool_ksettings_set(priv->phylink, cmd);
+}
+
+static int tse_ethtool_get_link_ksettings(struct net_device *dev,
+					  struct ethtool_link_ksettings *cmd)
+{
+	struct altera_tse_private *priv = netdev_priv(dev);
+
+	return phylink_ethtool_ksettings_get(priv->phylink, cmd);
+}
+
 static const struct ethtool_ops tse_ethtool_ops = {
 	.get_drvinfo = tse_get_drvinfo,
 	.get_regs_len = tse_reglen,
@@ -231,8 +247,8 @@ static const struct ethtool_ops tse_ethtool_ops = {
 	.get_ethtool_stats = tse_fill_stats,
 	.get_msglevel = tse_get_msglevel,
 	.set_msglevel = tse_set_msglevel,
-	.get_link_ksettings = phy_ethtool_get_link_ksettings,
-	.set_link_ksettings = phy_ethtool_set_link_ksettings,
+	.get_link_ksettings = tse_ethtool_get_link_ksettings,
+	.set_link_ksettings = tse_ethtool_set_link_ksettings,
 	.get_ts_info = ethtool_op_get_ts_info,
 };