mt76: mt7615: introduce LED support

Initialize brightness_set and blink_set callbacks to
mt7615_led_set_brightness and mt7615_led_set_blink in order to enable
LED support in mt7615 driver
Tested-by: Deng Qingfang <dengqf6@mail2.sysu.edu.cn>
Signed-off-by: Lorenzo Bianconi <lorenzo@kernel.org>
Signed-off-by: Felix Fietkau <nbd@nbd.name>

drivers/net/wireless/mediatek/mt76/mt7615/init.c

@@ -208,6 +208,58 @@ static const struct ieee80211_iface_combination if_comb[] = {
 	}
 };
 
+static void
+mt7615_led_set_config(struct led_classdev *led_cdev,
+		      u8 delay_on, u8 delay_off)
+{
+	struct mt7615_dev *dev;
+	struct mt76_dev *mt76;
+	u32 val, addr;
+
+	mt76 = container_of(led_cdev, struct mt76_dev, led_cdev);
+	dev = container_of(mt76, struct mt7615_dev, mt76);
+	val = FIELD_PREP(MT_LED_STATUS_DURATION, 0xffff) |
+	      FIELD_PREP(MT_LED_STATUS_OFF, delay_off) |
+	      FIELD_PREP(MT_LED_STATUS_ON, delay_on);
+
+	addr = mt7615_reg_map(dev, MT_LED_STATUS_0(mt76->led_pin));
+	mt76_wr(dev, addr, val);
+	addr = mt7615_reg_map(dev, MT_LED_STATUS_1(mt76->led_pin));
+	mt76_wr(dev, addr, val);
+
+	val = MT_LED_CTRL_REPLAY(mt76->led_pin) |
+	      MT_LED_CTRL_KICK(mt76->led_pin);
+	if (mt76->led_al)
+		val |= MT_LED_CTRL_POLARITY(mt76->led_pin);
+	addr = mt7615_reg_map(dev, MT_LED_CTRL);
+	mt76_wr(dev, addr, val);
+}
+
+static int
+mt7615_led_set_blink(struct led_classdev *led_cdev,
+		     unsigned long *delay_on,
+		     unsigned long *delay_off)
+{
+	u8 delta_on, delta_off;
+
+	delta_off = max_t(u8, *delay_off / 10, 1);
+	delta_on = max_t(u8, *delay_on / 10, 1);
+
+	mt7615_led_set_config(led_cdev, delta_on, delta_off);
+
+	return 0;
+}
+
+static void
+mt7615_led_set_brightness(struct led_classdev *led_cdev,
+			  enum led_brightness brightness)
+{
+	if (!brightness)
+		mt7615_led_set_config(led_cdev, 0, 0xff);
+	else
+		mt7615_led_set_config(led_cdev, 0xff, 0);
+}
+
 static void
 mt7615_init_txpower(struct mt7615_dev *dev,
 		    struct ieee80211_supported_band *sband)
@@ -402,6 +454,12 @@ int mt7615_register_device(struct mt7615_dev *dev)
 	mt7615_cap_dbdc_disable(dev);
 	dev->phy.dfs_state = -1;
 
+	/* init led callbacks */
+	if (IS_ENABLED(CONFIG_MT76_LEDS)) {
+		dev->mt76.led_cdev.brightness_set = mt7615_led_set_brightness;
+		dev->mt76.led_cdev.blink_set = mt7615_led_set_blink;
+	}
+
 	ret = mt76_register_device(&dev->mt76, true, mt7615_rates,
 				   ARRAY_SIZE(mt7615_rates));
 	if (ret)

drivers/net/wireless/mediatek/mt76/mt7615/regs.h

@@ -351,6 +351,24 @@
 
 #define MT_TX_AGG_CNT(n)		MT_WF_MIB(0xa8 + ((n) << 2))
 
+#define MT_LED_BASE_PHYS		0x80024000
+#define MT_LED_PHYS(_n)			(MT_LED_BASE_PHYS + (_n))
+
+#define MT_LED_CTRL			MT_LED_PHYS(0x00)
+
+#define MT_LED_CTRL_REPLAY(_n)		BIT(0 + (8 * (_n)))
+#define MT_LED_CTRL_POLARITY(_n)	BIT(1 + (8 * (_n)))
+#define MT_LED_CTRL_TX_BLINK_MODE(_n)	BIT(2 + (8 * (_n)))
+#define MT_LED_CTRL_TX_MANUAL_BLINK(_n)	BIT(3 + (8 * (_n)))
+#define MT_LED_CTRL_TX_OVER_BLINK(_n)	BIT(5 + (8 * (_n)))
+#define MT_LED_CTRL_KICK(_n)		BIT(7 + (8 * (_n)))
+
+#define MT_LED_STATUS_0(_n)		MT_LED_PHYS(0x10 + ((_n) * 8))
+#define MT_LED_STATUS_1(_n)		MT_LED_PHYS(0x14 + ((_n) * 8))
+#define MT_LED_STATUS_OFF		GENMASK(31, 24)
+#define MT_LED_STATUS_ON		GENMASK(23, 16)
+#define MT_LED_STATUS_DURATION		GENMASK(15, 0)
+
 #define MT_EFUSE_BASE			0x81070000
 #define MT_EFUSE_BASE_CTRL		0x000
 #define MT_EFUSE_BASE_CTRL_EMPTY	BIT(30)