- 30 Aug, 2015 40 commits
-
-
Bart Van Assche authored
Introduce the variable srp_device.use_fmr. Leave out the dev->has_fr / dev->has_fmr and ch->fr_pool / ch->fmr_pool checks since these are redundant. This patch does not change any functionality but makes the source code easier to read. Signed-off-by:
Bart Van Assche <bart.vanassche@sandisk.com> Signed-off-by:
Doug Ledford <dledford@redhat.com>
-
Bart Van Assche authored
Move the srp_map_desc() call from inside srp_map_sg_entry() to srp_map_sg() such that the use_mr argument can be removed from srp_map_sg_entry(). Signed-off-by:
-
Bart Van Assche authored
Mapping a discontiguous sg-list requires multiple memory regions and hence can exhaust the memory region pool. The SRP initiator already handles this by temporarily reducing the queue depth. This means that it is safe to remove the memory registration backtracking code. This patch has been tested with direct I/O sizes up to 256 MB. Signed-off-by:
-
Bart Van Assche authored
Although most paths through which a request is submitted check block layer parameters like the max_segments limit, these are not checked when an SG_IO or direct I/O request is submitted. Hence add a range check for the memory descriptor array pointer. Signed-off-by:
-
Bart Van Assche authored
Instead of using the global rkey for large memory regions, use multiple registrations. See also the while (dma_len) loop further down in srp_map_sg_entry(). Signed-off-by:
-
Bart Van Assche authored
During a discussion in 2011 nobody recalled why FMR was not used for non-page aligned buffers (see also http://thread.gmane.org/gmane.linux.drivers.rdma/7149). Re-enable FMR for such buffers. For the reason why the srp_map_fmr() function needs to be modified, see also patch "IB/srp: rework mapping engine to use multiple FMR entries" (commit ID 8f26c9ff; January 2011). Signed-off-by:
-
Jason Gunthorpe authored
The pd now has a local_dma_lkey member which completely replaces ib_get_dma_mr, use it instead. Signed-off-by:
Jason Gunthorpe <jgunthorpe@obsidianresearch.com> Signed-off-by:
-
Jason Gunthorpe authored
The pd now has a local_dma_lkey member which completely replaces ib_get_dma_mr, use it instead. Signed-off-by:
Dominique Martinet <dominique.martinet@cea.fr> Signed-off-by:
-
Jason Gunthorpe authored
The pd now has a local_dma_lkey member which completely replaces ib_get_dma_mr, use it instead. Signed-off-by:
Sagi Grimberg <sagig@mellanox.com> Signed-off-by:
-
Jason Gunthorpe authored
Replace all leys with pd->local_dma_lkey. This driver does not support iWarp, so this is safe. The insecure use of ib_get_dma_mr is thus isolated to an rkey, and will have to be fixed separately. Signed-off-by:
-
Jason Gunthorpe authored
The pd now has a local_dma_lkey member which completely replaces ib_get_dma_mr, use it instead. Signed-off-by:
-
Jason Gunthorpe authored
Replace all leys with pd->local_dma_lkey. This driver does not support iWarp, so this is safe. The insecure use of ib_get_dma_mr is thus isolated to an rkey, and this looks trivially fixed by forcing the use of registration in a future patch. Signed-off-by:
-
Jason Gunthorpe authored
The pd now has a local_dma_lkey member which completely replaces ib_get_dma_mr, use it instead. Signed-off-by:
-
Jason Gunthorpe authored
The pd now has a local_dma_lkey member which completely replaces ib_get_dma_mr, use it instead. Signed-off-by:
-
Jason Gunthorpe authored
The pd now has a local_dma_lkey member which completely replaces ib_get_dma_mr, use it instead. Signed-off-by:
-
Jason Gunthorpe authored
The pd now has a local_dma_lkey member which completely replaces ib_get_dma_mr, use it instead. Signed-off-by:
-
Jason Gunthorpe authored
Every single ULP requires a local_dma_lkey to do anything with a QP, so let us ensure one exists for every PD created. If the driver can supply a global local_dma_lkey then use that, otherwise ask the driver to create a local use all physical memory MR associated with the new PD. Signed-off-by:
Sagi Grimberg <sagig@dev.mellanox.co.il> Acked-by:
Christoph Hellwig <hch@infradead.org> Reviewed-by:
Steve Wise <swise@opengridcomputing.com> Reviewed-by:
Ira Weiny <ira.weiny@intel.com> Tested-by:
-
Sagi Grimberg authored
Chaning of send work requests benefits performance by reducing the send queue lock contention (acquired in ib_post_send) and saves us HW doorbells which is posted only once. Currently, in normal IO flows iser does not chain the CDB send work request with the registration work request. Also in PI flows, signature work requests are not chained as well. Lets chain those and post only once. Signed-off-by:
-
Sagi Grimberg authored
Easier to debug when we have the registration details. This patch does not change any functionality. Signed-off-by:
Adir Lev <adirl@mellanox.com> Signed-off-by:
-
Sagi Grimberg authored
iser support up to 512KB data transfer in a single scsi command. This means that larger IOs will split to different request. While iser can easily saturate FDR/EDR wires, some arrays are fine tuned for 1MB (or larger) IO sizes, hence add an option to support larger transfers (up to 8MB) if the device allows it. Given that a few target implementations don't support data transfers of more than 512KB by default and the fact that larger IO sizes require more resources, we introduce a module parameter to determine the maximum number of 512B sectors in a single scsi command. Users that are interested in larger transfers can change this value given that the target supports larger transfers. At the moment, iser works in 4K pages granularity, In a later stage we will get it to work with system page size instead. IO operations that consists of N pages will need a page vector of size N+1 in case the first SG element contains an offset. Given that some devices allocates memory regions in powers of 2, this means that allocating a region with N+1 pages, will result in region resources allocation of the next power of 2. Since we don't want that to happen, in case we are in the limit of IO size supported and the first SG element has an offset, we align the SG list using a bounce buffer (which is OK given that this is not likely to happen a lot). Signed-off-by:
-
Sagi Grimberg authored
Hard coded for now. This will allow to allocate different sized MRs depending on the IO size needed (and device capabilities). This patch does not change any functionality. Signed-off-by:
-
Sagi Grimberg authored
iser_reg_rdma_mem_[fastreg|fmr] share a lot of code, and logically do the same thing other than the buffer registration method itself (iser_fast_reg_mr vs. iser_fast_reg_fmr). The DIF logic is not implemented in the FMR flow as there is no existing device that supports FMRs and Signature feature. This patch unifies the flow in a single routine iser_reg_rdma_mem and just split to fmr/frwr for the buffer registration itself. Also, for symmetry reasons, unify iser_unreg_rdma_mem (which will call the relevant device specific unreg routine). Signed-off-by:
-
Sagi Grimberg authored
As for fmrs we will hold a single registration descriptor as no need for multiple like in the frwr mode (descriptor for each task). This change helps unifying the duplicate registration code paths. Signed-off-by:
-
Sagi Grimberg authored
Also, change a name of a local variable. This patch does not change any functionality. Signed-off-by:
-
Adir Lev authored
This will allow us to unify the memory registration code path between the various methods which vary by the device capabilities. This change will make it easier and less intrusive to remove fmr_pools from the code when we'd want to. The reason we use a single descriptor is to avoid taking a redundant spinlock when working with FMRs. We also change the signature of iser_reg_page_vec to make it match iser_fast_reg_mr (and the future indirect registration method). Signed-off-by:
-
Sagi Grimberg authored
Instead of having it a part of the connection structure, have it be under a dedicated (embedded) structure in the connection. A logical separation of the registration pool and the connection structure. Signed-off-by:
-
Sagi Grimberg authored
Don't have the caller allocate the structure and worry about freeing it in case the routine failed. This patch does not change any functionality. Signed-off-by:
-
Sagi Grimberg authored
Move all the per-device function pointers to an easy extensible iser_reg_ops structure that contains all the iser registration operations. Signed-off-by:
-
Sagi Grimberg authored
In the past the we always tried to allocate an fmr_pool and if it failed on ENOSYS (not supported) then we continued with dma mr. This is not the case anymore and if we tried to allocate an fmr_pool then it is supported and we expect to succeed. Also, the check if fmr_pool is allocated when free is called is redundant as well as we are guaranteed it exists. Signed-off-by:
-
Sagi Grimberg authored
Avoid struct names without iser_ prefix. This patch does not change any functionality. Signed-off-by:
-
Sagi Grimberg authored
Have fast_reg_descriptor hold struct iser_reg_resources (mr, frpl, valid flag). This will be useful when the actual buffer registration routines will be passed with the needed registration resources (i.e. iser_reg_resources) without being aware of their nature (i.e. data or protection). In order to achieve this, we remove reg_indicators flags container and place specific flags (mr_valid) within iser_reg_resources struct. We also place the sig_mr_valid and sig_protcted flags in iser_pi_context. This patch also modifies iser_fast_reg_mr to receive the reg_resources instead of the fast_reg_descriptor and a data/protection indicator. Signed-off-by:
-
Sagi Grimberg authored
We can do it in iser_aligned_data_len instead and it will save us an argument that is passed to fall_to_counce_buf just for the print. Signed-off-by:
-
Sagi Grimberg authored
We always call iser_initialize_task_headers() and set the header tx_sg.lkey to the device mr lkey, so no point in checking it in iser_create_send_desc(). Signed-off-by:
-
Sagi Grimberg authored
If iser_initialize_task_headers() routine failed before dma mapping, we should not attempt to unmap in cleanup_task(). Fixes: 7414dde0 (IB/iser: Fix race between iser connection ...) Signed-off-by:
-
Sagi Grimberg authored
We don't update those anywhere in the code and they seem pretty useless (no one seem to care about those). qp_tx_queue_full: We never should get this fmr_map_not_avail: We can never get to this eh_abort_cnt: We don't monitor aborts Go ahead and remove them. Signed-off-by:
-
Sagi Grimberg authored
Since commit "IB/iser: Fix race between iser connection teardown..." iser_initialize_task_headers() might fail, so we need to check that. Fixes: 7414dde0 (IB/iser: Fix race between iser connection ...) Signed-off-by:
-
Sagi Grimberg authored
Signed-off-by:
-
Sagi Grimberg authored
Signed-off-by:
-
Jenny Falkovich authored
While we're at it, use permission defines instead of octal values and rearrange a little bit. Signed-off-by:
Jenny Derzhavetz <jennyf@mellanox.com> Signed-off-by:
-
Kaike Wan authored
This patch routes a SA pathrecord query to netlink first and processes the response appropriately. If a failure is returned, the request will be sent through IB. The decision whether to route the request to netlink first is determined by the presence of a listener for the local service netlink multicast group. If the user-space local service netlink multicast group listener is not present, the request will be sent through IB, just like what is currently being done. Signed-off-by:
Kaike Wan <kaike.wan@intel.com> Signed-off-by:
John Fleck <john.fleck@intel.com> Signed-off-by:
-
