This patch pulls the PCI-related junk out of struct device_node and
puts it in a separate structure, struct pci_dn.  The device_node now
just has a void * pointer in it, which points to a struct pci_dn for
nodes that represent PCI devices.  It could potentially be used in
future for device-specific data for other sorts of devices, such as
virtual I/O devices.
Signed-off-by: Paul Mackerras <paulus@samba.org>

Remove asm-ppc64/segment.h now that all users are gone.
Signed-off-by: Kumar Gala <kumar.gala@freescale.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

In PPC64 there are number of problems in arch/ppc64/boot/main.c that
prevent a kernel from making use of a large (greater than ~16MB) INITRD.
This is 64 bit architecture and really large INITRD images should be
possible.

Simply put the existing code has a fixed reservation (claim) address and
once the kernel plus initrd image are large enough to pass this address
all sorts of bad things occur. The fix is the dynamically establish the
first claim address above the loaded kernel plus initrd (plus some
"padding" and rounding). If PROG_START is defined this will be used as
the minimum safe address - currently known to be 0x01400000 for the
firmwares tested so far.
Signed-off-by: Mark Bellon <mbellon@mvista.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

Fix __power64__ typo that should be __powerpc64__ instead.
Signed-off-by: Jon Loeliger <jdl@freescale.com>
Signed-off-by: Kumar Gala <kumar.gala@freescale.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

This patch cleans up the output generated by ppc64 builds.
Signed-off-by: Geoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

Signed-off-by: Geoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

Merge a few asm-ppc and asm-ppc64 header files.
Note: the merge of setup.h intentionally does not carry
forward the m68k cruft.  That means this patch continues
to break the already broken amiga on the ppc32.
Signed-off-by: Jon Loeliger <jdl@freescale.com>
Signed-off-by: Kumar Gala <kumar.gala@freescale.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

Make check_bugs() static inline and remove it from syscalls.c.
Signed-off-by: Jon Loeliger <jdl@freescale.com>
Signed-off-by: Kumar Gala <kumar.gala@freescale.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

Standardize on _ASM_POWERPC_... prefix for all #include
exclusion symbols.  Fixup all the non-compilers.
Signed-off-by: Jon Loeliger <jdl@freescale.com>
Signed-off-by: Kumar Gala <kumar.gala@freescale.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

The earlier commit 8d927391
(Consolidate early console and PPCDBG code) broke iSeries because
it caused unregister_console(&udbg_console) to be called
unconditionally.  iSeries never registers the udbg_console.

This just reverts part of the change.
Signed-off-by: Stephen Rothwell <sfr@canb.auug.org.au>
Signed-off-by: Paul Mackerras <paulus@samba.org>

The SPARSEMEM EXTREME code (802f192e) that
went in yesterday broke PPC64 for !CONFIG_NUMA.

The problem is that (free|reserve)_bootmem don't take a page number as their
first argument, they take an address. Ruh roh.

Booted on P5 LPAR, iSeries and G5.
Signed-off-by: Michael Ellerman <michael@ellerman.id.au>
Signed-off-by: Paul Mackerras <paulus@samba.org>

This fixes a severe bug in the bpa_iic driver that caused
all sorts of problems.

We had been using incorrect priority values for inter processor
interrupts, which resulted in always doing CALL_FUNCTION
instead of RESCHEDULE or DEBUGGER_BREAK.

The symptoms cured by this patch include bad performance on
SMP systems spurious kernel panics in the IPI code.
Signed-off-by: Arnd Bergmann <arndb@de.ibm.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

* sata_mv: remove pci_intx(), now that the same function is in PCI core
* sata_sis: fix variable initialization bug, trim trailing whitespace

Signed-off-by: Nathan Scott <nathans@sgi.com>

Rework the 68x328 configuration and setup code. All 68x328 varients
share the same timer hardware. So extract that into its own file,
instead of keeping copies in each processors setup code.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Include the ColdFire 523x register definitions when compiling
for that target processor.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Create common timer code for all 68x328 processor varients.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

The boot loader on the MOD5272 board doesn't set the register maping,
so set it in the 5272 init code. There was code in there to support
this, but we had never needed to use it before.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Add timer support for the ColdFire 523x processor family.
(It uses the ColdFire PIT timer hardware, so we just build that in).
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Add support definitions for the integrated UARTs on the 523x ColdFire
processor family.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Rework the 68x328 configuration and setup code. All 68x328 varient
share the same timer hardware, so extract that into its own file,
instead of keeping copies in each processors setup code.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Create common 68VZ328 config code. It is essentially the same for
all boards that use this, so no point having a version of it for
each.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Remove DragonEngine2 specific config code. Use common 68VZ328 config
code now.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Remove uCdimm specific config code. Use common 68VZ328 config code now.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Add processor level and clock support defines for the ColdFire 523x
processor.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

ColdFire 523x processor hardware register definitions.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Henk Vergonet <henk.vergonet@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

sparse still complains about the htons usage, but I'll leave that for
others to fix.
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

This patch aggregates all modifications in the -mm tree and adds
complete ringtone support.

The following features are supported:
  - keyboard          full support
  - LCD               full support
  - LED               full support
  - dialtone          full support
  - ringtone          full support
  - audio playback    via generic usb audio diver
  - audio record      via generic usb audio diver

For driver documentation see: Documentation/input/yealink.txt
For vendor documentation see: http://yealink.comSigned-off-by: Henk <Henk.Vergonet@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

As sugested by Alan Stern here are a few code cleanups for onetouch.c:

-Check number of endpoints before directly referencing intf->endpoint[2]
-Use defined constants instead of magic numbers
-Revmove the non-ascii characters from copyright notice
-Make registration and deregistration messages more similar
Signed-off-by: Nick Sillik <n.sillik@temple.edu>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

This code looks at urb->transfer_dma, maps the page and takes the data.
I am looking for volunteers to contribute architectures other than i386
or to develop an architecure-neutral API for it (or point me that it
was done already).
Signed-off-by: Pete Zaitcev <zaitcev@redhat.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

This adds the field tt_usecs to ehci_qh and ehci_iso_stream, and sets it
appropriately when setting them up as periodic endpoints.  It records
the transation translator's think_time (added in last patch) plus the
downstream (i.e. low or full speed) bustime of the transfer associated
with each interrupt or iso frame, as calculated by usb_calc_bus_time.
Signed-off-by: Dan Streetman <ddstreet@ieee.org>
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

This adds think_time to the usb_tt struct and sets it appropriately
(measured in ns); this can help us implement better split transaction
scheduling.
Signed-off-by: Dan Streetman <ddstreet@ieee.org>
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>