- 17 Oct, 2015 40 commits
-
-
Amitoj Kaur Chawla authored
The semantic patch used to find this is: @r@ expression x; void* e; type T; identifier f; @@ ( *((T *)e) | ((T *)x)[...] | ((T *)x)->f | - (T *) e ) Signed-off-by:
Amitoj Kaur Chawla <amitoj1606@gmail.com> Signed-off-by:
Greg Kroah-Hartman <gregkh@linuxfoundation.org>
-
Amitoj Kaur Chawla authored
The semantic patch used to find this is: @r@ expression x; void* e; type T; identifier f; @@ ( *((T *)e) | ((T *)x)[...] | ((T *)x)->f | - (T *) e ) Signed-off-by:
-
Amitoj Kaur Chawla authored
The semantic patch used to find this is: @r@ expression x; void* e; type T; identifier f; @@ ( *((T *)e) | ((T *)x)[...] | ((T *)x)->f | - (T *) e ) Signed-off-by:
-
Amitoj Kaur Chawla authored
The semantic patch used to find this is: @r@ expression x; void* e; type T; identifier f; @@ ( *((T *)e) | ((T *)x)[...] | ((T *)x)->f | - (T *) e ) Signed-off-by:
-
Amitoj Kaur Chawla authored
The semantic patch used to find this is: @r@ expression x; void* e; type T; identifier f; @@ ( *((T *)e) | ((T *)x)[...] | ((T *)x)->f | - (T *) e ) Signed-off-by:
-
Amitoj Kaur Chawla authored
The semantic patch used to find this is: @r@ expression x; void* e; type T; identifier f; @@ ( *((T *)e) | ((T *)x)[...] | ((T *)x)->f | - (T *) e ) Signed-off-by:
-
Shivani Bhardwaj authored
The variable frame_authorized is declared and mentioned in the code but is not used anywhere so, it should be removed. Also, two case statements are merged by removing an extra break. Semantic patch used: @@ type T; identifier i; constant C; position p != e.p; @@ - T i@p; <+... when != i - i = C; ...+> Signed-off-by:
Shivani Bhardwaj <shivanib134@gmail.com> Signed-off-by:
-
Shivani Bhardwaj authored
Remove NULL check on a variable as it is already preceded by one. Signed-off-by:
-
Punit Vara authored
This patch is to the rtl871x_ioctl_linux.c file that fixes up following warnings reported by checkpatch.pl : -Block comments use * on subsequent lines -Block comments use a trailing */ on a separate line Signed-off-by:
Punit Vara <punitvara@gmail.com> Signed-off-by:
-
Punit Vara authored
This patch is to the rtl871x_ioctl_linux.c file that fixes up following warning reported by checkpatch.pl : -Prefer ether_addr_equal() or ether_addr_equal_unaligned() over memcmp() bssid and pnetwork->network.MacAddress both are 6 byte array which aligned with u16 Signed-off-by:
-
Punit Vara authored
This patch is to the rtl871x_ioctl_linux.c that fixes up following warning by checkpatch.pl: -Prefer eth_broadcast_addr() over memset() Signed-off-by:
-
Amitoj Kaur Chawla authored
Remove intialisation of a variable that is immediately reassigned. The semantic patch used to find this is: // <smpl> @@ type T; identifier x; constant C; expression e; @@ T x - = C ; x = e; // </smpl> Signed-off-by:
-
Shivani Bhardwaj authored
Explicit type conversion is not required and should be removed. Semantic patch used: @@ type T; T e; identifier x; @@ * T x = (T)e; Signed-off-by:
-
Shivani Bhardwaj authored
Explicit typecasting is not required and should be removed. Semantic patch used: @@ type T; T e; identifier x; @@ * T x = (T)e; Signed-off-by:
-
Shivani Bhardwaj authored
Explicit typecasting of variables is not required and should be removed. Semantic patch used: @@ type T; T e; identifier x; @@ * T x = (T)e; Signed-off-by:
-
Shivani Bhardwaj authored
Typecasting should be removed from variables as it is not required. Semantic patch used: @@ type T; T e; identifier x; @@ * T x = (T)e; Signed-off-by:
-
Shivani Bhardwaj authored
Explicit type conversions are not required so, remove them. Semantic patch used: @@ type T; T e; identifier x; @@ * T x = (T)e; Signed-off-by:
-
Shivani Bhardwaj authored
Explicit type conversions are not required and so, they should be removed. Semantic patch used: @@ type T; T e; identifier x; @@ * T x = (T)e; Signed-off-by:
-
Amitoj Kaur Chawla authored
Remove intialisation of a variable that is immediately reassigned. The semantic patch used to find this is: // <smpl> @@ type T; identifier x; constant C; expression e; @@ T x - = C ; x = e; // </smpl> Signed-off-by:
-
Amitoj Kaur Chawla authored
Remove intialisation of a variable that is immediately reassigned. The semantic patch used to find this is: // <smpl> @@ type T; identifier x; constant C; expression e; @@ T x - = C ; x = e; // </smpl> Signed-off-by:
-
Amitoj Kaur Chawla authored
Remove intialisation of a variable that is immediately reassigned. The semantic patch used to find this is: // <smpl> @@ type T; identifier x; constant C; expression e; @@ T x - = C ; x = e; // </smpl> Signed-off-by:
-
Amitoj Kaur Chawla authored
Remove intialisation of a variable that is immediately reassigned. The problem was found using coccinelle semantic patch and further opportunities were identified by hand. The semantic patch used to find this is: // <smpl> @@ type T; identifier x; constant C; expression e; @@ T x - = C ; x = e; // </smpl> Signed-off-by:
-
Shivani Bhardwaj authored
Logical and-ing of a struct and its member should be replaced by the member only as the struct has already been NULL tested before. Signed-off-by:
Daniel Baluta <daniel.baluta@intel.com> Signed-off-by:
-
Shivani Bhardwaj authored
A variable is initialized and then assigned values in the code but is never used and therefore, should be removed. Semantic patch used: @@ type T; identifier i; constant C; position p != e.p; @@ - T i@p; <+... when != i - i = C; ...+> Signed-off-by:
-
Shivani Bhardwaj authored
The variable ret is only declared and initialized to 0, but never referenced, so remove it. Signed-off-by:
-
Mike Rapoport authored
The clock divisor calculations in setMasterClock and setMemoryClock unnecessaryly cast unsigned int to unsigned int. Removing the casting. Signed-off-by:
Mike Rapoport <mike.rapoport@gmail.com> Signed-off-by:
-
Mike Rapoport authored
The getChipClock is used to detect MXCLK frequency. Make it's name reflect what the function is actually doing. Signed-off-by:
-
Mike Rapoport authored
The getChipClock function is used only to get MXCLK frequency, which makes most of getPllValue function unused and thus. The detection of MXCLK frequency may be implemented directly in getChipClock rendering getPllValue and calcPLL unused. Signed-off-by:
-
Arnd Bergmann authored
My first attempt to fix the Kconfig logic for wilc1000 was incomplete, as it missed the case where SPI is built-in while SDIO is modular and wilc1000 is configured as built-in in SPI mode (or vice versa), which would still lead to a link failure. This works around the problem by adding an intermediate Kconfig symbol "WILC1000_DRIVER" that controls visibility of the SDIO and SPI sub-drivers, so we can control the dependencies better. Signed-off-by:
Arnd Bergmann <arnd@arndb.de> Fixes: 9535ebc5 ("staging/wilc1000: fix Kconfig dependencies") Signed-off-by:
-
Arnd Bergmann authored
A recent change to wilc1000 accidentally deleted an important variable, so we now get a build error when the SPI mode is selected: ERROR: "wilc_spi_dev" [drivers/staging/wilc1000/wilc1000.ko] undefined! This partially reverts the broken commit to put the variable back. Signed-off-by:
-
Luis de Bethencourt authored
Boolean tests do not need explicit comparison to true or false. Signed-off-by:
Luis de Bethencourt <luisbg@osg.samsung.com> Signed-off-by:
-
Shraddha Barke authored
Replace kmalloc followed by memcpy with kmemdup Problem found using coccicheck Signed-off-by:
Shraddha Barke <shraddha.6596@gmail.com> Signed-off-by:
-
Amitoj Kaur Chawla authored
Remove intialisation of a variable that is immediately reassigned. The semantic patch used to find this is: // <smpl> @@ type T; identifier x; constant C; expression e; @@ T x - = C ; x = e; // </smpl> Signed-off-by:
-
Amitoj Kaur Chawla authored
Remove intialisation of a variable that is immediately reassigned. The semantic patch used to find this is: // <smpl> @@ type T; identifier x; constant C; expression e; @@ T x - = C ; x = e; // </smpl> Signed-off-by:
-
kbuild test robot authored
Signed-off-by:
Fengguang Wu <fengguang.wu@intel.com> Signed-off-by:
-
Leo Kim authored
This patch renames variable gu8FlushedJoinReqDrvHandler to join_req_drv to avoid CamelCase naming convention. Signed-off-by:
Leo Kim <leo.kim@atmel.com> Signed-off-by:
Tony Cho <tony.cho@atmel.com> Signed-off-by:
-
kbuild test robot authored
Signed-off-by:
-
Leo Kim authored
This patch renames variable gu32FlushedInfoElemAsocSize to info_element_size to avoid CamelCase naming convention. Signed-off-by:
-
Leo Kim authored
This patch renames variable gu32FlushedJoinReqSize to join_req_size to avoid CamelCase naming convention. Signed-off-by:
-
Leo Kim authored
This patch renames variable gu8FlushedAuthType to auth_type to avoid CamelCase naming convention. Signed-off-by:
-
