Identical named files renamed to <name>_32.S
Refactored Makefile to prepare for unification.

Linking order was altered slightly - but this is a lib.a file so
it should not matter.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

- all files with identical names copied and renamed to *_64.c
- the remaning files copied as is
- added sparc64 specific files to sparc/prom/Makefile
- teach sparc64 Makefile to look into sparc/prom/
- delete unused Makefile from sparc64/prom/

linking order was not kept for sparc64 with this change.
It was not possible to keep linking order for both sparc and sparc64
and as sparc64 see more testing than sparc it was natural to
break linking order on sparc64. Should it have any effect it
would be detected sooner this way.

printf_32.c and printf_64.c are obvious candidates to be merged
but they are not 100% equal so that was left for later
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

- rename files where sparc64 uses identical names to *_32.c
- refactor Makefile (but keep linking order)
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

To unify Makefile for sparc and sparc64 a few other steps was needed:
1) separate defconfig files for sparc and sparc64 is required,
   so locate these in arch/sparc/configs
2) removoval of hack in toplevel Makefile to deal with that
   headers was in a separate directory compared to the rest

The unification of the Makefile required usage of several

    foo-$(CONFIG_SPARCnn) +=

due to a few directories pending unification.
This will be cleaned up when we unify the remaining directories.

Included in this patch are the deletion of a few files in
sparc64 as they are no longer needed: Makefile + Kconfig.
arch/sparc64/ will after this patch is applied only
have four directories (prom, lib, kernel, boot)
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

With this 'git status' no longer reports any new files
At least not for a sparc allnoconfig build
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Leave all cleaning to boot/Makefile
and delete zImage too when we do a 'make clean'
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

The btfixup step needs knowledge of all the .o files,
but there is no need to pass them in independent variables.
Simplify it to use only two variables.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

sparc64 does not use constants generated from asm-offsets
but to prepare it to do so the parts that could be
shared do now generate constants for sparc64 too.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Previous commit made them identical so use the sparc version
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

This patch makes the two vmlinux.lds.S files identical
and serve as documentation for the changes in each file.

This mainly add stuffs to sparc32 that is otherwise only
used by sparc64 and thus it should have no effect.

Build tested only.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

And this allows us to indicate HAVE_LATENCYTOP_SUPPORT.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

Just do it once.

Pointed out by Al Viro.
Signed-off-by: David S. Miller <davem@davemloft.net>

This is complicated a little because compat_audit.c wants to see only
the 32bit syscall numbers, but is being built in a 64bit compile.
Signed-off-by: Stephen Rothwell <sfr@canb.auug.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>

We use clock cycle counter, adjusted to HZ.

This can be extended to sun4v based processors as well, as they
also have a proper overflow interrupt facility for the performance
counters.
Signed-off-by: David S. Miller <davem@davemloft.net>

It writes the %pic register, keeping mind of processor bugs.

Implement reset_pic() in terms of it.
Signed-off-by: David S. Miller <davem@davemloft.net>

In these instructions we load the new thread register, switch
the register window, and setup the new frame pointer.

All of these must appear atomic, and things will explode if
we take a PIL=15 NMI interrupt in the middle of this sequence.
Signed-off-by: David S. Miller <davem@davemloft.net>

We don't want the rtrap path to try and run softirqs or
anything like that when returning from a PIL==15 NMI.
Signed-off-by: David S. Miller <davem@davemloft.net>

So that we can profile code even in a local_irq_disable() section,
only write 14 (instead of 15) into the %pil register to disable IRQs.

This allows PIL level 15 to serve as a pseudo NMI.
Signed-off-by: David S. Miller <davem@davemloft.net>

Stephen Rothwell pointed out that pcmcia can't be enabled on sparc64.

There is an empty non-prompt PCMCIA explicit entry in
arch/sparc/Kconfig but that doesn't do anything.

32-bit sparc needs a small hack to make this work, since it doesn't
use the generic IRQ layer yes.  We have to provide a dummy definition
of probe_irq_mask(), since this is used by the yenta socket driver.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

Add a sysctl to tweak the RSS limit used to decide when to grow
the TSB for an address space.

In order to avoid expensive divides and multiplies only simply
positive and negative powers of two are supported.

The function computed takes the number of TSB translations that will
fit at one time in the TSB of a given size, and either adds or
subtracts a percentage of entries.  This final value is the
RSS limit.

See tsb_size_to_rss_limit().
Signed-off-by: David S. Miller <davem@davemloft.net>

- move all sparc64/mm/ files to arch/sparc/mm/
- commonly named files are named _64.c
- add files to sparc/mm/Makefile preserving link order
- delete now unused sparc64/mm/Makefile
- sparc64 now finds mm/ in sparc
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

- rename files where sparc64 has similar files to _32.c
- Restructure Makefile
- Sneak in -Werror as we have for sparc64
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

A simple:

   diff arch/sparc64/oprofile/init.c arch/sparc/oprofile/init.c
   diff arch/sparc64/oprofile/Makefile arch/sparc/oprofile/Makefile

revealed that the directories were equal.
So let sparc64 point to the sparc version and drop the sparc64 oprofile dir
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Move relavent files to sparc/math-emu and
adjust path/include accordingly.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Add _32 to filenames to make them 32 bit unique
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

- Drop unused assignment from Makefile
- Replace EXTRA_CFLAGS with ccflags-y
- Delete unused file
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

BITS will be used to simplify unified Makefiles
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Merge all of sparc64 Kconfig to sparc Kconfig.
The merge was checked by:
- visual inspection in menuconfig
- result of allnoconfig, allmodconfig, allyesconfig was checked before and after
- result of a number of randconfig was checked before and after

scripts/diffconfig was used to check if the config differed before and after

The validity of the test was checked by on purpose introducing
a few bugs - and they were all caught by first run.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

To align with sparc64 add a "Bus options" menu
This has the additiona advantage that all
bus options are kept together
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

This is what we use in sparc64 - make sparc equal
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

We already has the proper definition in place in param.h.
So use the common Kconfig.hz file
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

We have it in drivers/char/Kconfig
There is no need to ask twice
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

moved a few config entries inside a menu so we
do not clutter the first screen up with a lot of detailed
config options.
The structure now remotely resemble the structure for i386
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Mode declaration of SPARC up in the top
to match the structure of sparc64 Kconfig
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Let sparc and sparc64 use the same Kconfig.debug
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

The kernel always executes in the TSO memory model now,
so none of this stuff is necessary any more.

With helpful feedback from Nick Piggin.
Signed-off-by: David S. Miller <davem@davemloft.net>