Skip to content

L
linux
Switch branch/tag
  1. 09 Jul, 2011 3 commits
    • Stefan Richter's avatar
      firewire: ohci: fix PHY reg access after card ejection · 215fa444
      Stefan Richter authored 
      Detect and handle ejection of FireWire CardBus cards in PHY register
accesses:

  - The last attempt of firewire-core to reset the bus during shutdown
    caused a spurious "firewire_ohci: failed to write phy reg" error
    message in the log.  Skip this message as well as the prior retry
    loop that needlessly took 100 milliseconds.

  - In the unlikely case that a PHY register was read right after card
    ejection, a bogus value was obtained and possibly acted upon.
    Instead, fail the read attempt.
Signed-off-by: default avatarStefan Richter <stefanr@s5r6.in-berlin.de>
      215fa444
    • Stefan Richter's avatar
      firewire: ohci: add a comment on PHY reg access serialization · b14c369d
      Stefan Richter authored 
      Signed-off-by: default avatarStefan Richter <stefanr@s5r6.in-berlin.de>
      b14c369d
    • Stefan Richter's avatar
      firewire: ohci: reduce potential context_stop latency · 9ef28ccd
      Stefan Richter authored 
      Stopping an isochronous reception DMA context takes two loop iterations
in context_stop on several controllers (JMicron, NEC, VIA).  But there
is no extra delay necessary between these two reg_read trials; the MMIO
reads themselves are slow enough.  Hence bring back the behavior from
before commit dd6254e5 "firewire: ohci:
remove superfluous posted write flushes" on these controllers by means
of an "if (i)" condition.

Isochronous context stop is performed in preemptible contexts (and only
rarely), hence this change is of little impact.  (Besides, Agere and TI
controllers always, or almost always, have the context stopped already
at the first ContextControl read.)

More important is asynchronous transmit context stop, which is performed
while local interrupts are disabled (on the two AT DMAs in
bus_reset_tasklet, i.e. after a self-ID-complete event).  In my
experience with several controllers, tested with a usermode AT-request
transmitter as well as with FTP transmission over firewire-net, the AT
contexts were luckily already stopped at the first ContextControl read,
i.e. never required another MMIO read let alone mdelay.  A possible
explanation for this is that the controllers which I tested perhaps stop
AT DMA before they perform the self-ID reception DMA.

But we cannot be sure about that and should keep the interrupts-disabled
busy loop as short as possible.  Hence, query the ContextControl
register in 1000 udelay(10) intervals instead of 10 udelay(1000)
intervals.  I understand from an estimation by Clemens Ladisch that
stopping a busy DMA context should take microseconds or at worst tens of
microseconds, not milliseconds.
Signed-off-by: default avatarStefan Richter <stefanr@s5r6.in-berlin.de>
      9ef28ccd
  3. 02 Jun, 2011 2 commits
  5. 10 May, 2011 9 commits
    • Stefan Richter's avatar
      firewire: sbp2: parallelize login, reconnect, logout · 105e53f8
      Stefan Richter authored 
      The struct sbp2_logical_unit.work items can all be executed in parallel
but are not reentrant.  Furthermore, reconnect or re-login work must be
executed in a WQ_MEM_RECLAIM workqueue.

Hence replace the old single-threaded firewire-sbp2 workqueue by a
concurrency-managed but non-reentrant workqueue with rescuer.
firewire-core already maintains one, hence use this one.

In earlier versions of this change, I observed occasional failures of
parallel INQUIRY to an Initio INIC-2430 FireWire 800 to dual IDE bridge.
More testing indicates that parallel INQUIRY is not actually a problem,
but too quick successions of logout and login + INQUIRY, e.g. a quick
sequence of cable plugout and plugin, can result in failed INQUIRY.
This does not seem to be something that should or could be addressed by
serialization.

Another dual-LU device to which I currently have access to, an
OXUF924DSB FireWire 800 to dual SATA bridge with firmware from MacPower,
has been successfully tested with this too.

This change is beneficial to environments with two or more FireWire
storage devices, especially if they are located on the same bus.
Management tasks that should be performed as soon and as quickly as
possible, especially reconnect, are no longer held up by tasks on other
devices that may take a long time, especially login with INQUIRY and sd
or sr driver probe.
Signed-off-by: default avatarStefan Richter <stefanr@s5r6.in-berlin.de>
      105e53f8
    • Stefan Richter's avatar
      firewire: sbp2: octlet AT payloads can be stack-allocated · 81bf52d8
      Stefan Richter authored 
      We do not need slab allocations for ORB pointer write transactions
anymore in order to satisfy streaming DMA mapping constraints, thanks to
commit da28947e "firewire: ohci: avoid separate DMA mapping for
small AT payloads".

(Besides, the slab-allocated buffers that firewire-sbp2 used to provide
for 8-byte write requests were still not fully portable since they
shared a cacheline with unrelated CPU-accessed data.)
Signed-off-by: default avatarStefan Richter <stefanr@s5r6.in-berlin.de>
      81bf52d8
    • Stefan Richter's avatar
      firewire: sbp2: omit Scsi_Host lock from queuecommand · b75ca5ea
      Stefan Richter authored 
      firewire-sbp2 already takes care for internal serialization where
required (ORB list accesses), and it does not use cmd->serial_number
internally.  Hence it is safe to not grab the shost lock around
queuecommand.

While we are at housekeeping, drop a redundant struct member:
sbp2_command_orb.done is set once in a hot path and dereferenced once in
a hot path.  We can as well dereference sbp2_command_orb.cmd->scsi_done
instead.
Signed-off-by: default avatarStefan Richter <stefanr@s5r6.in-berlin.de>
      b75ca5ea
    • Stefan Richter's avatar
      firewire: core: use non-reentrant workqueue with rescuer · 6ea9e7bb
      Stefan Richter authored 
      firewire-core manages the following types of work items:

fw_card.br_work:
  - resets the bus on a card and possibly sends a PHY packet before that
  - does not sleep for long or not at all
  - is scheduled via fw_schedule_bus_reset() by
      - firewire-ohci's pci_probe method
      - firewire-ohci's set_config_rom method, called by kernelspace
        protocol drivers and userspace drivers which add/remove
	Configuration ROM descriptors
      - userspace drivers which use the bus reset ioctl
      - itself if the last reset happened less than 2 seconds ago

fw_card.bm_work:
  - performs bus management duties
  - usually does not (but may in corner cases) sleep for long
  - is scheduled via fw_schedule_bm_work() by
      - firewire-ohci's self-ID-complete IRQ handler tasklet
      - firewire-core's fw_device.work instances whenever the root node
        device was (successfully or unsuccessfully) discovered,
	refreshed, or rediscovered
      - itself in case of resource allocation failures or in order to
        obey the 125ms bus manager arbitration interval

fw_device.work:
  - performs node probe, update, shutdown, revival, removal; including
    kernel driver probe, update, shutdown and bus reset notification to
    userspace drivers
  - usually sleeps moderately long, in corner cases very long
  - is scheduled by
      - firewire-ohci's self-ID-complete IRQ handler tasklet via the
        core's fw_node_event
      - firewire-ohci's pci_remove method via core's fw_destroy_nodes/
        fw_node_event
      - itself during retries, e.g. while a node is powering up

iso_resource.work:
  - accesses registers at the Isochronous Resource Manager node
  - usually does not (but may in corner cases) sleep for long
  - is scheduled via schedule_iso_resource() by
      - the owning userspace driver at addition and removal of the
        resource
      - firewire-core's fw_device.work instances after bus reset
      - itself in case of resource allocation if necessary to obey the
        1000ms reallocation period after bus reset

fw_card.br_work instances should not, and instances of the others must
not, be executed in parallel by multiple CPUs -- but were not protected
against that.  Hence allocate a non-reentrant workqueue for them.

fw_device.work may be used in the memory reclaim path in case of SBP-2
device updates.  Hence we need a workqueue with rescuer and cannot use
system_nrt_wq.
Signed-off-by: default avatarStefan Richter <stefanr@s5r6.in-berlin.de>
Reviewed-by: default avatarTejun Heo <tj@kernel.org>
      6ea9e7bb
    • Clemens Ladisch's avatar
      firewire: optimize iso queueing by setting wake only after the last packet · 13882a82
      Clemens Ladisch authored 
      When queueing iso packets, the run time is dominated by the two
MMIO accesses that set the DMA context's wake bit.  Because most
drivers submit packets in batches, we can save much time by
removing all but the last wakeup.

The internal kernel API is changed to require a call to
fw_iso_context_queue_flush() after a batch of queued packets.
The user space API does not change, so one call to
FW_CDEV_IOC_QUEUE_ISO must specify multiple packets to take
advantage of this optimization.

In my measurements, this patch reduces the time needed to queue
fifty skip packets from userspace to one sixth on a 2.5 GHz CPU,
or to one third at 800 MHz.
Signed-off-by: default avatarClemens Ladisch <clemens@ladisch.de>
Signed-off-by: default avatarStefan Richter <stefanr@s5r6.in-berlin.de>
      13882a82
    • Stefan Richter's avatar
      firewire: octlet AT payloads can be stack-allocated · f30e6d3e
      Stefan Richter authored 
      We do not need slab allocations anymore in order to satisfy
streaming DMA mapping constraints, thanks to commit da28947e
"firewire: ohci: avoid separate DMA mapping for small AT payloads".

(Besides, the slab-allocated buffers that firewire-core, firewire-sbp2,
and firedtv used to provide for 8-byte write and lock requests were
still not fully portable since they crossed cacheline boundaries or
shared a cacheline with unrelated CPU-accessed data.  snd-firewire-lib
got this aspect right by using an extra kmalloc/ kfree just for the
8-byte transaction buffer.)

This change replaces kmalloc'ed lock transaction scratch buffers in
firewire-core, firedtv, and snd-firewire-lib by local stack allocations.
Perhaps the most notable result of the change is simpler locking because
there is no need to serialize usages of preallocated per-device buffers
anymore.  Also, allocations and deallocations are simpler.
Signed-off-by: default avatarStefan Richter <stefanr@s5r6.in-berlin.de>
Acked-by: default avatarClemens Ladisch <clemens@ladisch.de>
      f30e6d3e
    • Stefan Richter's avatar
      Merge tag 'v2.6.39-rc7' · 020abf03
      Stefan Richter authored 
      in order to pull in changes in drivers/media/dvb/firewire/ and
sound/firewire/.
      020abf03
    • Linus Torvalds's avatar
      Linux 2.6.39-rc7 · 693d92a1
      Linus Torvalds authored
      693d92a1
    • Hugh Dickins's avatar
      vm: fix vm_pgoff wrap in upward expansion · 42c36f63
      Hugh Dickins authored 
      Commit a626ca6a ("vm: fix vm_pgoff wrap in stack expansion") fixed
the case of an expanding mapping causing vm_pgoff wrapping when you had
downward stack expansion.  But there was another case where IA64 and
PA-RISC expand mappings: upward expansion.

This fixes that case too.
Signed-off-by: default avatarHugh Dickins <hughd@google.com>
Cc: stable@kernel.org
Signed-off-by: default avatarLinus Torvalds <torvalds@linux-foundation.org>
      42c36f63
  7. 09 May, 2011 26 commits
GitLab Nexedi Edition | About GitLab | About Nexedi | 沪ICP备2021021310号-2 | 沪ICP备2021021310号-7