Add sctp_chunk->source, sctp_sockaddr_entry->a, sctp_transport->ipaddr
and sctp_transport->saddr, maintain them as net-endian mirrors of
their host-endian counterparts.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

Part 1: rename sctp_chunk->source, sctp_sockaddr_entry->a,
sctp_transport->ipaddr and sctp_transport->saddr (to ..._h)

The next patch will reintroduce these fields and keep them as
net-endian mirrors of the original (renamed) ones.  Split in
two patches to make sure that we hadn't forgotten any instanes.

Later in the series we'll eliminate uses of host-endian variants
(basically switching users to net-endian counterparts as we
progress through that mess).  Then host-endian ones will die.

Other embedded host-endian sctp_addr will be easier to switch
directly, so we leave them alone for now.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

Again, invalid sockaddr passed to userland - host-endiand sin_port.
Potential leak, again, but less dramatic than in previous case.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

a) struct sockaddr_storage * passed to sctp_ulpevent_make_peer_addr_change()
actually points at union sctp_addr field in a structure.  Then that sucker
gets copied to userland, with whatever junk we might have there.

b) it's actually having host-endian sin_port.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

It expects (and gets) laddr with net-endian sin_port.  And then it calls
sctp_bind_addr_match(), which *does* care about port numbers in case of
ipv6 and expects them to be host-endian.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

That's going to be a long series.  Introduced temporary helpers
doing copy-and-convert for sctp_addr; they are used to kill
flip-in-place in global data structures and will be used
to gradually push host-endian uses of sctp_addr out of existence.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

also always get __be16 protocol error; switch to SCTP_PERR()
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

argument stored for SCTP_CMD_INIT_FAILED is always __be16
(protocol error).  Introduced new field and accessor for
it (SCTP_PERR()); switched to their use (from SCTP_U32() and
.u32)
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

This patch makes two needlessly global functions static.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: David S. Miller <davem@davemloft.net>

Make copy_to_user_policy_type take a type instead a policy and
fix its users to pass the type
Signed-off-by: Jamal Hadi Salim <hadi@cyberus.ca>
Signed-off-by: David S. Miller <davem@davemloft.net>

Removes dependency on buggy rta_buf, fixes a memory corruption bug due to
a unvalidated netlink attribute, and simplifies the code.
Signed-off-by: Thomas Graf <tgraf@suug.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>

This one got lost on the way from Ian to Gerrit to me, fix it.
Signed-off-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>

This removes a non-referenced variable.
Signed-off-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>

This patch just updates DCCP documentation a bit.
Signed-off-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>

This makes the code of the dccp_probe module more portable.
Signed-off-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>

This adds documentation to the CCID 3 rx/tx socket fields, plus some
minor re-formatting.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>

This reaps the benefit of the earlier patch, which changed the type of
CCID 3 states to use enums, in that many conditions are now simplified
and the number of possible (unexpected) values is greatly reduced.

In a few instances, this also allowed to simplify pre-conditions; where
care has been taken to retain logical equivalence.

[DCCP]: Introduce a consistent BUG/WARN message scheme

This refines the existing set of DCCP messages so that
 * BUG(), BUG_ON(), WARN_ON() have meaningful DCCP-specific counterparts
 * DCCP_CRIT (for severe warnings) is not rate-limited
 * DCCP_WARN() is introduced as rate-limited wrapper

Using these allows a faster and cleaner transition to their original
counterparts once the code has matured into a full DCCP implementation.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>

Previously the transmit queue was unbounded.

This patch:
	* puts a limit on transmit queue length
	  and sends back EAGAIN if the buffer is full
	* sets the TX queue length to a sensible default
	* implements tx buffer sysctls for DCCP
Signed-off-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>

This adds a CCID3 debug option to the configuration menu
which is missing in Kconfig, but already used by the code.

CCID 2 already provides such an entry.

To enable debugging, set CONFIG_IP_DCCP_CCID3_DEBUG=y

NOTE: The use of ccid3_{t,r}x_state_name is safe, since
      now only enum values can appear.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>

This patch
  * makes debugging (when configured) work both for static / module build
  * provides generic debugging macros for use in other DCCP / CCID modules
  * adds missing information about debug parameters to Kconfig
  * performs some code tidy-up
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>

Update version to 1.5.1.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Add PCI ID and detection for 5709 copper and SerDes chips.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Add basic support to initialize the 5709 chip.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Re-organize the firmware handling code and declarations a bit to make
the code more compact.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Change a long udelay() in bnx2_setup_copper_phy() to msleep().
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>