- 12 May, 2020 40 commits
-
-
Ryder Lee authored
The capabilities for the HE interfaces are generated from the capabilities reported by the firmware. This should move to common file once we got other HE devices support. Signed-off-by:
Ryder Lee <ryder.lee@mediatek.com> Signed-off-by:
Felix Fietkau <nbd@nbd.name>
-
Ryder Lee authored
Use firmware support for applying per-rate limit and power offsets. This can support all HE RU types. Signed-off-by:
Shayne Chen <shayne.chen@mediatek.com> Signed-off-by:
Chih-Min Chen <chih-min.chen@mediatek.com> Tested-by:
Evelyn Tsai <evelyn.tsai@mediatek.com> Acked-by:
Yiwei Chung <yiwei.chung@mediatek.com> Acked-by:
YF Luo <yf.luo@mediatek.com> Signed-off-by:
-
Ryder Lee authored
Enable HE rate reporting in Rx path Signed-off-by:
-
Ryder Lee authored
Add support for the MediaTek latest generation IEEE 802.11ax 4x4 device MT7915E, which supports concurrent dual-band operation at both 5GHz and 2.4GHz. Note that this patch just add basic part and will add more HE capabilities support in the further patches. The driver supports AP, Station, Mesh and monitor mode. Signed-off-by:
Shihwei Lin <shihwei.lin@mediatek.com> Tested-by:
-
Ryder Lee authored
This is a preliminary patch to support 11ax deivces. Signed-off-by:
-
Ryder Lee authored
The newer 802.11ax devices (i.e. MT7915E) can connect to much more peers than previous generations. Signed-off-by:
-
Ryder Lee authored
HE deivces need to add Rx radiotap header. Signed-off-by:
-
Ryder Lee authored
Add support for encoding and reporting HE RX rates. Signed-off-by:
-
Ryder Lee authored
Enlarge slot to support 11ax 256 BA (256 MPDUs in an AMPDU) Signed-off-by:
-
Lorenzo Bianconi authored
Configure the mcu to scan all available channels if mac80211 does not provide any frequency list Signed-off-by:
Lorenzo Bianconi <lorenzo@kernel.org> Signed-off-by:
-
Sean Wang authored
Add support to sched scan with randomise addr Co-developed-by:
Wan-Feng Jiang <Wan-Feng.Jiang@mediatek.com> Signed-off-by:
Soul Huang <Soul.Huang@mediatek.com> Signed-off-by:
Sean Wang <sean.wang@mediatek.com> Co-developed-by:
-
Sean Wang authored
Introduce WoW with net detect support Co-developed-by:
-
Lorenzo Bianconi authored
Fix mt7663 eeprom definitions for delta tx power parsing Signed-off-by:
-
Lorenzo Bianconi authored
Fix target parsing from eeprom/efuse partition for 7663 chipsets Fixes: f40ac0f3 ("mt76: mt7615: introduce mt7663e support") Signed-off-by:
-
Lorenzo Bianconi authored
Fix the following kernel warning adding an adhoc interface to a mt7663e device [ 233.363394] WARNING: CPU: 0 PID: 2345 at drivers/net/wireless/mt76/mt7615/mcu.c:1449 mt7615_mcu_uni_add_bss+0x15f/0x24e [mt7615_common] [ 233.363432] CPU: 0 PID: 2345 Comm: iw Tainted: G W 4.14.171 #12 [ 233.363434] Hardware name: HP Meep/Meep, BIOS Google_Meep.11297.75.0 06/17/2019 [ 233.363436] task: ffff9a1a4020e3c0 task.stack: ffffb9124113c000 [ 233.363441] RIP: 0010:mt7615_mcu_uni_add_bss+0x15f/0x24e [mt7615_common] [ 233.363443] RSP: 0018:ffffb9124113f730 EFLAGS: 00010246 [ 233.363446] RAX: 0000000000000024 RBX: ffff9a1a788c74e8 RCX: 41826d413aea9200 [ 233.363448] RDX: 0000000000000007 RSI: 0000000000000006 RDI: ffff9a1a7fc15418 [ 233.363450] RBP: ffffb9124113f7c0 R08: 0000000000000356 R09: 00000000ffff0a10 [ 233.363452] R10: 0000001000000000 R11: ffffffff93f2a4be R12: 0000000000000000 [ 233.363454] R13: ffff9a1a7383bd48 R14: ffffb9124113f77a R15: 0000000000000000 [ 233.363456] FS: 00007f203314ab80(0000) GS:ffff9a1a7fc00000(0000) knlGS:0000000000000000 [ 233.363458] CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 [ 233.363460] CR2: 00005a13d647c950 CR3: 0000000171238000 CR4: 00000000003406f0 [ 233.363462] Call Trace: [ 233.363470] mt7615_bss_info_changed+0x98/0xf4 [mt7615_common] [ 233.363484] ieee80211_bss_info_change_notify+0x139/0x1d4 [mt76_mac80211] [ 233.363496] ieee80211_ibss_disconnect+0x183/0x1bb [mt76_mac80211] [ 233.363507] ieee80211_ibss_leave+0x14/0xa0 [mt76_mac80211] [ 233.363519] __cfg80211_leave_ibss+0xa6/0x13a [cfg80211] [ 233.363528] cfg80211_netdev_notifier_call+0x8b/0x631 [cfg80211] [ 233.363535] ? packet_notifier+0x196/0x1a3 [ 233.363540] raw_notifier_call_chain+0x39/0x58 [ 233.363544] __dev_close_many+0x6b/0xf0 [ 233.363548] dev_close_many+0x62/0xe8 [ 233.363552] ? _raw_spin_unlock_irq+0xe/0x21 [ 233.363555] rollback_registered_many+0xf6/0x35c [ 233.363560] ? __rcu_read_unlock+0x4a/0x4a [ 233.363563] unregister_netdevice_queue+0x7f/0x105 [ 233.363573] ieee80211_del_iface+0x12/0x16 [mt76_mac80211] [ 233.363582] nl80211_del_interface+0xa8/0x124 [cfg80211] [ 233.363588] genl_rcv_msg+0x40b/0x481 [ 233.363592] ? genl_unbind+0xb8/0xb8 [ 233.363595] netlink_rcv_skb+0x85/0xf8 [ 233.363598] genl_rcv+0x28/0x36 [ 233.363601] netlink_unicast+0x165/0x1f8 [ 233.363604] netlink_sendmsg+0x35f/0x3a6 [ 233.363608] sock_sendmsg+0x38/0x48 [ 233.363611] ___sys_sendmsg+0x1bf/0x267 [ 233.363615] ? __inode_wait_for_writeback+0x72/0xd7 [ 233.363619] ? dentry_kill+0x69/0x76 [ 233.363622] ? dput+0xd1/0x170 [ 233.363624] __sys_sendmsg+0x52/0x8f [ 233.363628] do_syscall_64+0x6b/0xf7 [ 233.363632] entry_SYSCALL_64_after_hwframe+0x3d/0xa2 [ 233.363635] RIP: 0033:0x7f2032ca1264 [ 233.363637] RSP: 002b:00007ffec3668e38 EFLAGS: 00000246 ORIG_RAX: 000000000000002e [ 233.363639] RAX: ffffffffffffffda RBX: 000058f7175e7880 RCX: 00007f2032ca1264 [ 233.363641] RDX: 0000000000000000 RSI: 00007ffec3668e98 RDI: 0000000000000003 [ 233.363643] RBP: 00007ffec3668e70 R08: 0000000000000001 R09: 00007f2032ce1fd0 [ 233.363645] R10: 000058f7175e2010 R11: 0000000000000246 R12: 000058f7175e7740 [ 233.363646] R13: 00007ffec3668ff0 R14: 000058f7175e2350 R15: 00007ffec3668e98 Fixes: f40ac0f3 ("mt76: mt7615: introduce mt7663e support") Signed-off-by:
-
Lorenzo Bianconi authored
mt7615_eeprom_get_power_index can return negative error value. Check mt7615_eeprom_get_power_index return value before using it Signed-off-by:
-
Lorenzo Bianconi authored
Read tx stream configuration from eeprom/efuse Signed-off-by:
-
Lorenzo Bianconi authored
If device has enabled beacon hw filter rx beacons are not reported to the host. Introduce beacon_loss mcu event to trigger mac80211 mlme connection state machine in this configuration. IEEE80211_VIF_BEACON_FILTER has not set in vif flags since hw beacon filter is not enabled yet Co-developed-by:
-
Lorenzo Bianconi authored
Add KCK and KEK offload support to mt7615 driver in order to support GTK rekeying during PM suspend Co-developed-by:
-
Lorenzo Bianconi authored
Introduce suspend/resume to mt7615e driver Co-developed-by:
-
Sean Wang authored
Tested on Chromebok by "echo mem to /sys/power/state" to suspend and then waked up by keyboard keystrokes to resume system. Signed-off-by:
-
Lorenzo Bianconi authored
Introduce WoW support to mt7615 driver. Current supported trigger are: - magic-packet - disconnect - user-pattern Co-developed-by:
-
Sean Wang authored
Introduce the mt7615_mcu_set_hif_suspend mcu command, which is usually used to configure the interface including PCIe, USB or SDIO to the right state during operation suspend / resume. Signed-off-by:
-
Lorenzo Bianconi authored
Introduce support for hw beacon filter if available in the firmware Co-developed-by:
-
Lorenzo Bianconi authored
Always free pci irq vector if mt7615_pci_probe routine fails Moreover free irq in mt7615_pci_remove routine Co-developed-by:
-
Lorenzo Bianconi authored
Introduce support for passive frequency scanning to mt7615_mcu_hw_scan Tested-by:
-
Lorenzo Bianconi authored
For the moment offload firmware supports just one entry in the scheduled scan plan and so it runs till it is disabled by the userspace. Do not mark the hw scheduled scan as disabled in mt7615_scan_work after receiving a scan result Signed-off-by:
-
Lorenzo Bianconi authored
Introduce mt7615_check_offload_capability routine to set hw/wiphy offload capabilities according to the running firmware Signed-off-by:
-
Lorenzo Bianconi authored
Fix SSID configuration performing hw frequency scanning Signed-off-by:
-
Dejin Zheng authored
it will print an error message by itself when devm_platform_ioremap_resource() goes wrong. so remove the duplicate error message. Signed-off-by:
Dejin Zheng <zhengdejin5@gmail.com> Signed-off-by:
-
Felix Fietkau authored
On top of the EEPROM target power, each rate can also has a power offset. On many devices, this power offset is used to boost the tx power of lower rates. Take this into account when parsing rate power. The assumption here is, that the first rate (OFDM 6M or CCK 1M) has the highest tx power Signed-off-by: -
Felix Fietkau authored
The vendor driver sets this in firmware rate control (which we don't use) Signed-off-by: -
Lorenzo Bianconi authored
Get rid of useless check in mt7663_load_n9 since it is used only for mt7663 devices Signed-off-by:
-
Lorenzo Bianconi authored
mt7663 firmware v2 is used for embedded devices since it has more completed features in AP mode. Add the capability to specify which firmware load first (v3 or v2) using prefer_offload_fw kernel parameter and fallback to the other one if the selected firmware fails to load Signed-off-by:
-
Lorenzo Bianconi authored
Enable MCS8 and MCS9 for mt76x0{u,e} devices Signed-off-by: -
Lorenzo Bianconi authored
Currently mt7663 devices do not support DBDC so fw events have no info about it. Fix mt7615_mcu_bss_event that wrongly use bss_idx as DBDC band_idx while it is vif index. Signed-off-by:
-
Lorenzo Bianconi authored
Introduce sta pointer to mt7615_mcu_add_bss_info signature in order to avoid sta lookup in mt7615_mcu_bss_basic_tlv routine Signed-off-by:
-
Sean Wang authored
BMC entry for MT7663 unicmd firmware should be a broadcast/multicast entry, not a unicast entry, that is GTK rekey offload would rely on. Fixes: 13886067 ("mt76: mt7615: add more uni mcu commands") Cc: Soul Huang <Soul.Huang@mediatek.com> Suggested-by:
-
Lorenzo Bianconi authored
Enable mac80211 TDLS support by default. Disable TDLS hw filtering for mt7615 devices Signed-off-by:
-
Lorenzo Bianconi authored
Run mt7615_mcu_add_bss_info routine before mt7615_mcu_sta_add since the firmware requires the bss is created before the relative sta Tested-by:
Lucy Hsu <lucy.hsu@mediatek.com> Co-developed-by:
-
