- 15 Jul, 2016 40 commits
-
-
Don Brace authored
Was not alloting for FW Flash times. Reviewed-by:
Scott Teel <scott.teel@microsemi.com> Reviewed-by:
Kevin Barnett <kevin.barnett@microsemi.com> Signed-off-by:
Don Brace <don.brace@microsemi.com> Signed-off-by:
Martin K. Petersen <martin.petersen@oracle.com>
-
Don Brace authored
The SA controller spins down RAID drive spares. A REGNEWD event causes an inquiry to be sent to all physical drives. This causes the SA controller to spin up the spare. The controller suspends all I/O to a logical volume until the spare is spun up. The spin-up can take over 50 seconds. This can result in one or both of the following: - SML sends down aborts and resets to the logical volume and can cause the logical volume to be off-lined. - a negative impact on the logical volume's I/O performance each time a REGNEWD is triggered. Reviewed-by:
-
Himanshu Madhani authored
Signed-off-by:
Himanshu Madhani <himanshu.madhani@qlogic.com> Signed-off-by:
Giridhar Malavali <giridhar.malavali@qlogic.com> Reviewed-by:
Hannes Reinecke <hare@suse.com> Signed-off-by:
-
Sawan Chandak authored
Fixes: 969a6199 ("qla2xxx: Add support for buffer to buffer credit value for ISP27XX.") Signed-off-by:
Sawan Chandak <sawan.chandak@qlogic.com> Signed-off-by:
-
Sawan Chandak authored
Signed-off-by:
-
Sawan Chandak authored
If there is error recovery going on due to command timeout and there is register disconnect, then disable the adapter. Signed-off-by:
-
Joe Carnuccio authored
Signed-off-by:
Joe Carnuccio <joe.carnuccio@qlogic.com> Signed-off-by:
-
Joe Carnuccio authored
Signed-off-by:
-
Joe Carnuccio authored
Signed-off-by:
-
Joe Carnuccio authored
Signed-off-by:
-
Sawan Chandak authored
[mkp: Folded in compile fix] Signed-off-by:
-
Joe Carnuccio authored
Signed-off-by:
-
Sawan Chandak authored
During hot swap of PCI device, there can be PCI error on device, during normal driver unload. The race between normal driver unload and driver unload due to PCI error, can lead to system crash.Fix is to check if there is unload going on and allow that function to unload the driver. Signed-off-by:
-
Joe Carnuccio authored
Signed-off-by:
-
Joe Carnuccio authored
Properly initialize IO statistics to avoid initial 0xFFFFFFF (-1) values. Cleanup/simplify usage of pointer to statistics structure. Signed-off-by:
-
Joe Carnuccio authored
Signed-off-by:
-
Joe Carnuccio authored
Signed-off-by:
-
Giridhar Malavali authored
When VP decoupling enabled, there could be a window where, FLOGI from initiators can be dropped before VP0 is enabled, causing link level recovery. Retry FLOGI to avoid link level recovery. Signed-off-by:
-
Joe Carnuccio authored
Signed-off-by:
-
Joe Carnuccio authored
Signed-off-by:
-
Joe Carnuccio authored
Signed-off-by:
-
James Smart authored
Update lpfc version to 11.2.0.0 Signed-off-by:
Dick Kennedy <dick.kennedy@broadcom.com> Signed-off-by:
James Smart <james.smart@broadcom.com> Reviewed-by:
-
James Smart authored
Copyright updates Signed-off-by:
-
James Smart authored
Disable FDMI probing if not connected to a fabric Signed-off-by:
-
James Smart authored
Correct issue with ioremap() call on 32bit kernel Signed-off-by:
-
James Smart authored
Re-organize source for easier driver attribute management Signed-off-by:
-
James Smart authored
Remove global lpfc_sli_mode attribute in leiu of per-hba lpfc_sli_mode Signed-off-by:
-
James Smart authored
Remove global lpfc_delay_discovery attribute in leiu of per-hba lpfc_delay_discovery Signed-off-by:
-
James Smart authored
Remove global lpfc_enable_npiv attribute in leiu of per-hba lpfc_enable_npiv Signed-off-by:
-
James Smart authored
Correct Port reset resulting in FC port going offline Signed-off-by:
-
James Smart authored
Add support for XLane LUN priority Signed-off-by:
-
James Smart authored
Correct RDP response Revision location Signed-off-by:
-
James Smart authored
Re-organize source for easier device-id management Signed-off-by:
-
James Smart authored
Correct FCOE discovery to avoid loss of storage devices after system reboot Signed-off-by:
-
James Smart authored
Fix SLI mode 2 config failure Signed-off-by:
-
James Smart authored
Add MDS Diagnostics Support Signed-off-by:
-
James Smart authored
Add sysfs proc_name support Signed-off-by:
-
James Smart authored
Reject RDP ELS if port has no login Signed-off-by:
-
James Smart authored
Correct Buffer credit descriptor values in RDP response Signed-off-by:
-
James Smart authored
Add recovery from adapter parity errors on some SLI4 adapters Signed-off-by:
-
