document for btcvsd driver
Signed-off-by: KaiChieh Chuang <kaichieh.chuang@mediatek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Set the channel number on each AIF widget to allow unused channels not
to be powered up across AIFs.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Renesas sound card need to judge that whether it is using
"TDM Split mode". To judge it and for other purpose, it has
rsnd_parse_connect_simple() and rsnd_parse_connect_graph(),
but these are using different judgement policy for
TDM Split mode.
It is pointless and confusable.
This patch add new rsnd_parse_tdm_split_mode() and use common
judgement policy for simple-card/audio-graph.

Without this patch, CTU will be judged as TDM Split mode
on audio-graph card.
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Current rsnd driver has below function to check connection
	rsnd_parse_connect_simple()
	rsnd_parse_connect_graph()
But these have different parameters. This patch synchronize these
for cleanup.
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

The Spreadtrum DMA engine uses the link-list mode to support audio playback
or capture, thus this patch adds audio DMA platform support for CPU DAI to
trigger DMA link-list transfer.
Signed-off-by: Baolin Wang <baolin.wang@linaro.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add documentation for Spreadtrum DMA platform driver.
Signed-off-by: Baolin Wang <baolin.wang@linaro.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

struct snd_soc_dapm_route has been modified to be a dynamic
object so that it can be used to save driver specific
data while parsing topology and clean up
driver-specific data during driver unloading.

This patch makes the following changes to accomplish the above:
1. Set the dobj member of snd_soc_dapm_route during the
SOC_TPLG_PASS_GRAPH pass of topology parsing.
2. Add the remove_route() routine that will be called while
removing all dynamic objects from the component driver.
Signed-off-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add a new dobj type SND_SOC_DOBJ_GRAPH for dapm routes
and add snd_soc_dobj member to struct snd_soc_dapm_route.
This enables device drivers to save driver specific
data pertaining to dapm routes and also be able
to clean up the data when the driver module is unloaded.

Also, reorder the snd_soc_dobj_type types to align with
matching topology header types.
Signed-off-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

template.sname and template.name are only freed when an error occur.
They should be freed in the success return case, too.
Signed-off-by: Bard liao <yung-chuan.liao@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

dtexts is two dimensional array, so we also need to free it after
freeing its fields.
Signed-off-by: Amadeusz Sławiński <amadeuszx.slawinski@intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Currently when we unload and reload machine driver few times we end with
corrupted list and try to cleanup no longer existing objects. Fix this
by removing dobj from the list.
Signed-off-by: Amadeusz Sławiński <amadeuszx.slawinski@intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

We already have passed dobj, there is no reason to access it through
containing structs.
Signed-off-by: Amadeusz Sławiński <amadeuszx.slawinski@intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

For some reason we test if the machine is passed as a parameter before
fixing up the codec name. This is unnecessary, generates false
positives in static analysis tools and done only in this machine
driver, remove and adjust indentation.
Reported-by: Colin Ian King <colin.king@canonical.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add a codec driver to control ChromeOS EC codec.

Use EC Host command to enable/disable I2S recording and control other
configurations.
Signed-off-by: Cheng-Yi Chiang <cychiang@chromium.org>
Reviewed-by: Enric Balletbo i Serra <enric.balletbo@collabora.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add documentation for Chrome EC codec driver.
Signed-off-by: Cheng-Yi Chiang <cychiang@chromium.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

Linux 5.0-rc4

Signed-off-by: Mark Brown <broonie@kernel.org>

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

This patch adds audio routing for both playback and capture.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

This patch adds required dapm widgets for capture path.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

This patch adds required dapm widgets for playback.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

This patch adds basic controls found in wcd9335 codec.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

CLASS-H controller/Amplifier is common accorss Qualcomm WCD codec series.
This patchset adds basic CLASS-H controller apis for WCD codecs after
wcd9335 to use.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

Qualcomm WCD9335 Codec is a standalone Hi-Fi audio codec IC,
It supports both I2S/I2C and SLIMbus audio interfaces.
On slimbus interface it supports two data lanes; 16 Tx ports
and 8 Rx ports. It has Seven DACs and nine dedicated interpolators,
Seven (six audio ADCs, and one VBAT ADC), Multibutton headset
control (MBHC), Active noise cancellation and Sidetone paths
and processing.

This patchset adds very basic support for playback and capture
via the 9 interpolators and ADC respectively.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

This patch updates wcd9335 bindings with recommended properties.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Add helper to override dailink platform name, if passed as parameter
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

To reuse the same machine drivers with Atom/SST, Skylake and SOF, we
need to change the default platform_name (or platforms->name in the
"modern" representation).

So far, this override was done with an automatic override, which was
broken by a set of changes for DT platforms related to deferred probe
handling.

This automatic override is actually not really needed, the machine
driver can already receive the platform name as a platform_data
parameter. This is used e.g. for HDaudio support where we have
different PCI aliases used for different platforms. We can reuse the
same mechanism and modify the machine drivers to override the dailinks
prior to registrating the card.

This will require additional work for SOF, but with this helper it'll
be just two lines of additional code per machine driver which is
reused, not the end of the world.

This helper can be simplified when all drivers have transitioned to
the "modern" representation of dailinks.
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>