- 07 Jun, 2007 27 commits
-
-
Herbert Xu authored
This patch converts the ipv4_devconf config members (everything except sysctl) to an array. This allows easier manipulation which will be needed later on to provide better management of default config values. Signed-off-by:
Herbert Xu <herbert@gondor.apana.org.au> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Herbert Xu authored
When I made the inetdev_init call work on all devices I incorrectly left in the panic call as well. It is obviously undesirable to panic on an allocation failure for a normal network device. This patch moves the panic call under the loopback if clause. Signed-off-by:
-
Patrick McHardy authored
A time_wait socket inherits sk_bound_dev_if from the original socket, but it is not used when sending ACK packets using ip_send_reply. Fix by passing the oif to ip_send_reply in struct ip_reply_arg and use it for output routing. Signed-off-by:
Patrick McHardy <kaber@trash.net> Signed-off-by:
-
Michael Chan authored
Update to version 1.5.11. Signed-off-by:
Michael Chan <mchan@broadcom.com> Acked-by:
Jeff Garzik <jeff@garzik.org> Signed-off-by:
-
Michael Chan authored
The statistics block DMA on 5708 can be messed up occasionally on the average of about once per hour. If the user is reading the counters within one second after the corruption, the counters will be all messed up. One second later, the counters will be ok again until the next corruption occurs. The workaround is to disable the periodic statistics DMA. Instead, we manually trigger the DMA once a second in bnx2_timer(). This manual trigger of the DMA avoids the problem. As a consequence, we can only allow 0 or 1 second settings for ethtool -C statistics block. Thanks to Jean-Daniel Pauget <jd@disjunkt.com> and CaT <cat@zip.com.au> for reporting this rare problem. Signed-off-by:
-
Michael Chan authored
Add missing code to enable DMA on 5709 A1. The bit is a no-op on A0 and therefore can be set on all 5709 chips. Signed-off-by:
-
Michael Chan authored
For correctness, we need to wait for the MEM_INIT bit to be cleared in the BNX2_CTX_COMMAND register before proceeding. [Added return -EBUSY when the MEM_INIT bit doesn't clear, suggested by Jeff Garzik.] Signed-off-by:
-
Michael Chan authored
There's a bug in the driver that only initializes half of the context memory on the 5708. Surprisingly, this works most of the time except for some occasional netdev watchdogs when sending a lot of 64-byte packets. The fix is to add the missing code to initialize the 2nd halves of all context memory. Signed-off-by:
-
Linus Torvalds authored
* 'master' of master.kernel.org:/pub/scm/linux/kernel/git/davem/sparc-2.6: [VIDEO] sunxvr500fb: Fix pseudo_palette array size [VIDEO] sunxvr2500fb: Fix pseudo_palette array size [VIDEO] ffb: The pseudo_palette is only 16 elements long [VIDEO]: Fix section mismatch warning in promcon. [ATA]: Back out bogus (SPARC64 && !PCI) Kconfig depends. [SPARC64]: Fill in gaps in non-PCI dma_*() NOP implementation. [SPARC64]: Fix {mc,smt}_capable(). [SPARC64]: Make core and sibling groups equal on UltraSPARC-IV. [SPARC64]: Proper multi-core scheduling support. [SPARC64]: Provide mmu statistics via sysfs. [SPARC64]: Fix service channel hypervisor function names. [SPARC64]: Export basic cpu properties via sysfs. [SPARC64]: Move topology init code into new file, sysfs.c -
git://git.kernel.org/pub/scm/linux/kernel/git/paulus/powerpcLinus Torvalds authored
* 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/paulus/powerpc: [POWERPC] Fix building of COFF zImages [POWERPC] spufs: Fix error handling in spufs_fill_dir() [POWERPC] Add table of contents to booting-without-of.txt [POWERPC] spufs: Don't yield nosched context [POWERPC] Fix typo in booting-without-of-txt section numbering [POWERPC] scc_sio: Fix link failure [POWERPC] cbe_cpufreq: Limit frequency via cpufreq notifier chain [POWERPC] Fix pci_setup_phb_io_dynamic for pci_iomap [POWERPC] spufs scheduler: Fix wakeup races [POWERPC] spufs: Synchronize pte invalidation vs ps close [POWERPC] spufs: Free mm if spufs_fill_dir() failed [POWERPC] spufs: Fix gang destroy leaks [POWERPC] spufs: Hook up spufs_release_mem [POWERPC] spufs: Refuse to load the module when not running on cell [POWERPC] pasemi: Fix iommu + 64K PAGE_SIZE bug
-
Roland McGrath authored
This patch should get a few birds. It prevents sigaction calls from clearing TIF_SIGPENDING in other threads, which could leak -ERESTART*. And It fixes ptrace_stop not to clear it, which done at the syscall exit stop could leak -ERESTART*. It probably removes the harm from signalfd, at least assuming it never calls dequeue_signal on kernel threads that might have used block_all_signals. Signed-off-by:
Roland McGrath <roland@redhat.com> Cc: Andrew Morton <akpm@linux-foundation.org> Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org> Cc: Paul Mackerras <paulus@samba.org> Cc: Satoru Takeuchi <takeuchi_satoru@jp.fujitsu.com> Signed-off-by:
Linus Torvalds <torvalds@linux-foundation.org>
-
Andy Whitcroft authored
scripts/checkpatch.pl should be executable, make it so. Signed-off-by:
Andy Whitcroft <apw@shadowen.org> Acked-by:
Andrew Morton <akpm@linux-foundation.org> Acked-by:
Joel Schopp <jschopp@austin.ibm.com> Signed-off-by:
-
Paul Mackerras authored
The COFF zImage (for booting oldworld powermacs) wasn't being built correctly because the procedure descriptor in crt0.S for the zImage entry point wasn't declared as .globl, and therefore wasn't getting pulled in from wrapper.a by the linker. This adds the necessary .globl statement. Signed-off-by:Paul Mackerras <paulus@samba.org>
-
Sebastian Siewior authored
The error path in spufs_fill_dir() is broken. If d_alloc_name() or spufs_new_file() fails, spufs_prune_dir() is getting called. At this time dir->inode is not set and a NULL pointer is dereferenced by mutex_lock(). This bugfix replaces spufs_prune_dir() with a shorter version that does not touch dir->inode but simply removes all children. Signed-off-by:
Sebastian Siewior <bigeasy@linux.vnet.ibm.com> Signed-off-by:
Jeremy Kerr <jk@ozlabs.org> Acked-by:
Arnd Bergmann <arnd.bergmann@de.ibm.com> Signed-off-by:
-
Stuart Yoder authored
Add table of contents. Signed-off-by:
Stuart Yoder <stuart.yoder@freescale.com> Signed-off-by:
-
Christoph Hellwig authored
Nosched context sould never be scheduled out, thus we must not deactivate them in spu_yield ever. Signed-off-by:
Christoph Hellwig <hch@lst.de> Signed-off-by:
-
Stuart Yoder authored
Fix typo in section numbering. Signed-off-by:
David Gibson <david@gibson.dropbear.id.au> Signed-off-by:
-
Christoph Hellwig authored
scc_sio.o should only be built if the txx9 serial driver is actually built into the kernel. Signed-off-by:
-
Thomas Renninger authored
... and get rid of cpufreq_set_policy call that caused a build failure due interfering commits. Signed-off-by:
Thomas Renninger <trenn@suse.de> Signed-off-by:
Christian Krafft <krafft@de.ibm.com> Signed-off-by:
-
Arnd Bergmann authored
We had a problem on a system with only dynamically allocated PCI buses (using of_pci_phb_driver) in combination with libata. This setup ended up having no "primary" phb, which means that pci_io_base never got initialized and all IO port numbers are 64 bit numbers, which is larger than the PIO_MASK limit. Signed-off-by:
Benjamin Herrenschmidt <benh@kernel.crashing.org> Signed-off-by:
-
Christoph Hellwig authored
Fix the race between checking for contexts on the runqueue and actually waking them in spu_deactive and spu_yield. The guts of spu_reschedule are split into a new helper called grab_runnable_context which shows if there is a runnable thread below a specified priority and if yes removes if from the runqueue and uses it. This function is used by the new __spu_deactivate hepler shared by preemption and spu_yield to grab a new context before deactivating a specified priority and if yes removes if from the runqueue and uses it. This function is used by the new __spu_deactivate hepler shared by preemption and spu_yield to grab a new context before deactivating the old one. Signed-off-by:
-
Christoph Hellwig authored
Make sure the mapping_lock also protects access to the various address_space pointers used for tearing down the ptes on a spu context switch. Because unmap_mapping_range can sleep we need to turn mapping_lock from a spinlock into a sleeping mutex. Signed-off-by:
-
Sebastian Siewior authored
In case spufs_fill_dir() fails only put_spu_context() gets called for cleanup and the acquired mm_struct never gets freed. Signed-off-by:
-
Jeremy Kerr authored
Previously, closing a SPE gang that still has contexts would trigger a WARN_ON, and leak the allocated gang. This change fixes the problem by using the gang's reference counts to destroy the gang instead. The gangs will persist until their last reference (be it context or open file handle) is gone. Also, avoid using statements with side-effects in a WARN_ON(). Signed-off-by:
-
Christoph Hellwig authored
Currently spufs_mem_release and the mem file doesn't have any release method hooked up, leading to leaks everytime is used. Signed-off-by:
-
Arnd Bergmann authored
As noticed by David Woodhouse, it's currently possible to mount spufs on any machine, which means that it actually will get mounted by fedora. This refuses to load the module on platforms that have no support for SPUs. Cc: David Woodhouse <dwmw2@infradead.org> Signed-off-by:
-
Olof Johansson authored
The powerpc iommu code was refactored by Linas back in the 2.6.20 time frame to map 4K pages from the generic code, but I had forgotten to go back and fix my platform driver before submitting it. Signed-off-by:
Olof Johansson <olof@lixom.net> Signed-off-by:
-
- 05 Jun, 2007 13 commits
-
-
Antonino Daplas authored
- the pseudo_palette is only 16 elements long. - the pseudo_palette has only 16 elements. Do not write if regno (the array index) is more than 15. Signed-off-by:
Antonino Daplas <adaplas@gmail.com> Signed-off-by:
-
Antonino Daplas authored
- the pseudo_palette is only 16 elements long. - the pseudo_palette has only 16 elements. Do not write if regno (the array index) is more than 15. Signed-off-by:
-
Antonino Daplas authored
The pseudo_palette is only 16 elements long. Signed-off-by:
-
Sam Ravnborg authored
Fix the following warnings in promcon: WARNING: o-sparc64/drivers/video/console/built-in.o(.text+0x480): Section mismatch: reference to .init.data:promfont_unitable (between 'promcon_init_unimap' and 'promcon_init') WARNING: o-sparc64/drivers/video/console/built-in.o(.text+0x488): Section mismatch: reference to .init.data:promfont_unitable (between 'promcon_init_unimap' and 'promcon_init') WARNING: o-sparc64/drivers/video/console/built-in.o(.text+0x48c): Section mismatch: reference to .init.data:promfont_unicount (between 'promcon_init_unimap' and 'promcon_init') WARNING: o-sparc64/drivers/video/console/built-in.o(.text+0x490): Section mismatch: reference to .init.data:promfont_unicount (between 'promcon_init_unimap' and 'promcon_init') The warnings happens because the function: promcon_init_unimap() references promfont_unitable and promfont_unicount which are marked __initdata by the conmakehash command in the drivers/video/console/Makefile Fix the warning by removing the __initdata marker on the two variables. Signed-off-by:
Sam Ravnborg <sam@ravnborg.org> Signed-off-by:
-
David S. Miller authored
Signed-off-by: -
David S. Miller authored
Signed-off-by: -
David S. Miller authored
It's not just sun4v hypervisor platforms that should return true for this, sun4u with UltraSPARC-IV should return true too. Signed-off-by: -
David S. Miller authored
Signed-off-by: -
David S. Miller authored
The scheduling domain hierarchy is: all cpus --> cpus that share an instruction cache --> cpus that share an integer execution unit Signed-off-by: -
David Miller authored
If the system supports hypervisor based statistics, allow them to be fetched, enabled, and disabled via sysfs. Enable and disable via the boolean: /sys/devices/systems/cpu/cpuN/mmustat_enable Statistic values are provided under: /sys/devices/systems/cpu/cpuN/mmu_status/ Signed-off-by: -
David Miller authored
sed 's/scv/svc/' Signed-off-by: -
David S. Miller authored
Cache sizes, udelay_val, and clock_tick. Signed-off-by: -
David S. Miller authored
Also, use per-cpu data for struct cpu. Calling kmalloc for each cpu in topology_init() is just plain clumsy. Signed-off-by:
-
