- 21 May, 2007 40 commits
-
-
git://git390.osdl.marist.edu/pub/scm/linux-2.6Linus Torvalds authored
* 'for-linus' of git://git390.osdl.marist.edu/pub/scm/linux-2.6: [S390] More verbose show_mem() like other architectures. [S390] Make use of kretprobe_assert. [S390] Wire up signald, timerfd and eventfd syscalls. [S390] Wire up sys_utimensat. [S390] cio: Update documentation.
-
Linus Torvalds authored
* 'master' of master.kernel.org:/pub/scm/linux/kernel/git/davem/net-2.6: [NET]: Fix race condition about network device name allocation. [IPV4]: icmp: fix crash with sysctl_icmp_errors_use_inbound_ifaddr [NETFILTER]: nf_conntrack_ipv4: fix incorrect #ifdef config name [NETFILTER]: nf_conntrack: fix use-after-free in helper destroy callback invocation [IPSEC] pfkey: Load specific algorithm in pfkey_add rather than all [TCP] FRTO: Prevent state inconsistency in corner cases [TCP] FRTO: Add missing ECN CWR sending to one of the responses [NET]: Fix net/core/skbuff.c gcc-3.2.3 compilation error [RFKILL]: Fix check for correct rfkill allocation [IPV6]: Add ip6_tunnel.h to headers_install
-
Linus Torvalds authored
* master.kernel.org:/home/rmk/linux-2.6-arm: (22 commits) [ARM] spelling fixes [ARM] at91_adc parenthesis balance [ARM] 4400/1: S3C24XX: Add high-speed MMC device definition [ARM] 4399/2: S3C2443: Fix SMDK2443 nand timings [ARM] 4398/1: S3C2443: Fix watchdog IRQ number [ARM] 4397/1: S3C2443: remove SDI0/1 IRQ ambiguity [ARM] 4396/1: S3C2443: Add missing HCLK clocks [ARM] 4395/1: S3C24XX: add include of <linux/sysdev.h> to relevant machines [ARM] 4388/1: no need for arm/mm mmap range checks for non-mmu [ARM] 4387/1: fix /proc/cpuinfo formatting for pre-ARM7 parts [ARM] ARMv6: add CPU_HAS_ASID configuration [ARM] integrator: fix pci_v3 compile error with DEBUG_LL [ARM] gic: Fix gic cascade irq handling [ARM] Silence OMAP kernel configuration warning [ARM] Update ARM syscalls [ARM] 4384/1: S3C2412/13 SPI registers offset correction [ARM] 4383/1: iop: fix usage of '__init' and 'inline' in iop files [ARM] 4382/1: iop13xx: fix msi support [ARM] Remove Integrator/CP SMP platform support [ARM] 4378/1: KS8695: Serial driver fix ...
-
Anton Altaparmakov authored
This fixes the LDM driver so that it works with Windows Vista dynamic disks which are subtly different to Windows 2000/XP ones. The patch was needed to get a Vista formatted dynamic disk to be recognized and parsed successfully. Thanks go to Chris Teachworth for the report and testing. Cc: Richard Russon <ldm@flatcap.org> Signed-off-by:
Anton Altaparmakov <aia21@cantab.net> Signed-off-by:
Linus Torvalds <torvalds@linux-foundation.org>
-
Brian Gerst authored
cr4 is a 32-bit register, so casting the mask to an unsigned char is wrong, as it clears more than the PGE bit. Signed-off-by:
Brian Gerst <bgerst@didntduck.org> Signed-off-by:
Andi Kleen <ak@suse.de> Signed-off-by:
-
john stultz authored
The vsyscall time() function basically returns the second portion of xtime directly. This however means that there is about a ticks worth of time each second where time() will return a second value less then what gettimeofday() does. Additionally, this window where vtime() is behind vgettimeofday() grows when dynticks is enabled, so its probably good to get this in before dynticks lands. Big thanks to Sripathi for noticing this issue and creating a test case to work with! This patch changes the vtime() implemenation to call vgettimeofday(), much as syscall time() implementation calls gettimeofday(). 2.6.21 stable candidate too Signed-off-by:
John Stultz <johnstul@us.ibm.com> Signed-off-by:
-
Yinghai Lu authored
In commit d358788f Author: Russell King <rmk@dyn-67.arm.linux.org.uk> Date: Mon Mar 20 20:00:09 2006 +0000 Glen Turner reported that writing LFCR rather than the more traditional CRLF causes issues with some terminals. Since this afflicts many serial drivers, extract the common code to a library function (uart_console_write) and arrange for each driver to supply a "putchar" function. but early_printk is left out. Signed-off-by:
Yinghai Lu <yinghai.lu@sun.com> Cc: Russell King <rmk@arm.linux.org.uk> Signed-off-by:
-
Andi Kleen authored
Fix boot failures with the early CPUID checking on VIA C3 Includes fixes from Christian Volkmann Signed-off-by:
-
Christian Volkmann authored
- boot/setup.S did not print "PANIC: CPU too old for this kernel" ( not visible, also the message did not match ) - I add "# missed before: set ds" => somebody should check if I am right with the way to set. => seems to be a generic error in setup.S not to set "ds" for error messages. AK: extracted patch out of other changes AK: also couldn't find any other case where ds is wrong Signed-off-by:
-
Andi Kleen authored
It reports machine check capability in CPUID, but doesn't actually implement all the necessary MSRs of the standard Intel machine check architecture. This fixes a boot failure on K6s recently introduced. Signed-off-by:
-
Andi Kleen authored
The ifdef tests were broken. Assume it acts like gcc 4 Signed-off-by:
-
Andi Kleen authored
Only try to allocate MSRs once instead of for every CPU. This assumes the MSRs are the same on all CPUs which is currently true. P4-HT is a special case for different SMT threads, but the code always saves/restores all MSRs so it works identical. Signed-off-by:
-
Andi Kleen authored
Signed-off-by:
-
Andi Kleen authored
Signed-off-by:
-
Andi Kleen authored
Signed-off-by:
-
Bryan Wu authored
a) platorm_driver_probe(...) instead of platform_driver_register(&driver); b) set bfin_spi_enable and bfin_spi_disable static c) Why is the width flag a u32? d) maybe use dev_dbg() instead of pr_debug() Signed-off-by:
Bryan Wu <bryan.wu@analog.com> Signed-off-by:
-
Mike Frysinger authored
properly setting up and respecting the read_status_mask / ignore_status_mask fields of the serial core Signed-off-by:
Mike Frysinger <michael.frysinger@analog.com> Signed-off-by:
-
Aubrey Li authored
Signed-off-by:
Aubrey Li <aubrey.li@analog.com> Signed-off-by:
-
Bryan Wu authored
Signed-off-by:
-
Bryan Wu authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Sonic Zhang authored
Signed-off-by:
Sonic Zhang <sonic.zhang@analog.com> Signed-off-by:
-
Bernd Schmidt authored
There's a forum thread at https://blackfin.uclinux.org/gf/project/uclinux-dist/forum/?action=ForumBrowse&_forum_action=MessageReply&message_id=24741 which has a testcase involving signal handling that crashes quite readily. Inspecting the code I believe what happens is that signal handling can become confused when it is invoked on return from an interrupt, if the contents of P0 and R0 at the time of the interrupt happen to be such that P0 is larger than zero (indicating to the signal code that we're in a syscall), and R0 happens to have a value of something like -EINTR or -ERESTARTSYS. Fixed by setting orig_p0 to -1 if we're returning from an interrupt. The testcase now seems to run without problems. Signed-off-by:
Bernd Schmidt <bernd.schmidt@analog.com> Signed-off-by:
-
Mike Frysinger authored
Blackfin arch: cache SWRST value at bootup so other things like watchdog can non-destructively query it Signed-off-by:
-
Bryan Wu authored
a) add new processor BF52x/BF54x header files b) update blackfin BF533/BF537/BF561 header files to latest one in VDSP. c) scrub watchdog/rtc masks from headers as we dont need/want them (too generic and the drivers dont use them) Signed-off-by:
Roy Huang <roy.huang@analog.com> Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Aubrey Li authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Blackfin arch: move board specific setup out of common init code and into the board specific init code Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Michael Hennerich authored
Without conswitchp preset, we have the following situation: - During initcalls: con_init is called, and returns because of !display_desc. - At this point there is no memory allocated for vc_cons[].d A bit later vty_init calls kbd_init. - From now on events are passed to kbd_event which will then call kbd_keycode. - kbd_keycode will oops on a NULL pointer dereference on vc->vc_tty Signed-off-by:
Michael Hennerich <michael.hennerich@analog.com> Cc: Pekka Enberg <penberg@cs.helsinki.fi> Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Michael Hennerich authored
Signed-off-by:
-
Michael Hennerich authored
1) Disable Interrupts during DMA memcpy to avoid raise conditions. 2) Mark MDMA channel 0 as reserved, since were using it internally. 3) Add DMA based equivalents for insX and outsX. 4) Our insX and outsX only handles len <= 2^16. Signed-off-by:
-
Michael Hennerich authored
Signed-off-by:
-
