Skip to content

L
linux
Switch branch/tag
  1. 22 Jan, 2015 33 commits
  3. 21 Jan, 2015 2 commits
    • David Vrabel's avatar
      xen-netfront: use correct linear area after linearizing an skb · 02db7d0c
      David Vrabel authored 
      commit 11d3d2a1 upstream.

Commit 97a6d1bb (xen-netfront: Fix
handling packets on compound pages with skb_linearize) attempted to
fix a problem where an skb that would have required too many slots
would be dropped causing TCP connections to stall.

However, it filled in the first slot using the original buffer and not
the new one and would use the wrong offset and grant access to the
wrong page.

Netback would notice the malformed request and stop all traffic on the
VIF, reporting:

    vif vif-3-0 vif3.0: txreq.offset: 85e, size: 4002, end: 6144
    vif vif-3-0 vif3.0: fatal error; disabling device
Reported-by: default avatarAnthony Wright <anthony@overnetdata.com>
Tested-by: default avatarAnthony Wright <anthony@overnetdata.com>
Signed-off-by: default avatarDavid Vrabel <david.vrabel@citrix.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
Cc: Stefan Bader <stefan.bader@canonical.com>
Signed-off-by: default avatarLuis Henriques <luis.henriques@canonical.com>
      02db7d0c
    • Zoltan Kiss's avatar
      xen-netfront: Fix handling packets on compound pages with skb_linearize · de2d6357
      Zoltan Kiss authored 
      commit 97a6d1bb upstream.

There is a long known problem with the netfront/netback interface: if the guest
tries to send a packet which constitues more than MAX_SKB_FRAGS + 1 ring slots,
it gets dropped. The reason is that netback maps these slots to a frag in the
frags array, which is limited by size. Having so many slots can occur since
compound pages were introduced, as the ring protocol slice them up into
individual (non-compound) page aligned slots. The theoretical worst case
scenario looks like this (note, skbs are limited to 64 Kb here):
linear buffer: at most PAGE_SIZE - 17 * 2 bytes, overlapping page boundary,
using 2 slots
first 15 frags: 1 + PAGE_SIZE + 1 bytes long, first and last bytes are at the
end and the beginning of a page, therefore they use 3 * 15 = 45 slots
last 2 frags: 1 + 1 bytes, overlapping page boundary, 2 * 2 = 4 slots
Although I don't think this 51 slots skb can really happen, we need a solution
which can deal with every scenario. In real life there is only a few slots
overdue, but usually it causes the TCP stream to be blocked, as the retry will
most likely have the same buffer layout.
This patch solves this problem by linearizing the packet. This is not the
fastest way, and it can fail much easier as it tries to allocate a big linear
area for the whole packet, but probably easier by an order of magnitude than
anything else. Probably this code path is not touched very frequently anyway.
Signed-off-by: default avatarZoltan Kiss <zoltan.kiss@citrix.com>
Cc: Wei Liu <wei.liu2@citrix.com>
Cc: Ian Campbell <Ian.Campbell@citrix.com>
Cc: Paul Durrant <paul.durrant@citrix.com>
Cc: netdev@vger.kernel.org
Cc: linux-kernel@vger.kernel.org
Cc: xen-devel@lists.xenproject.org
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
Cc: Stefan Bader <stefan.bader@canonical.com>
Signed-off-by: default avatarLuis Henriques <luis.henriques@canonical.com>
      de2d6357
  5. 20 Jan, 2015 1 commit
  7. 19 Jan, 2015 4 commits
    • Govindarajulu Varadarajan's avatar
      enic: fix rx skb checksum · 969d621e
      Govindarajulu Varadarajan authored 
      commit 17e96834 upstream.

Hardware always provides compliment of IP pseudo checksum. Stack expects
whole packet checksum without pseudo checksum if CHECKSUM_COMPLETE is set.

This causes checksum error in nf & ovs.

kernel: qg-19546f09-f2: hw csum failure
kernel: CPU: 9 PID: 0 Comm: swapper/9 Tainted: GF          O--------------   3.10.0-123.8.1.el7.x86_64 #1
kernel: Hardware name: Cisco Systems Inc UCSB-B200-M3/UCSB-B200-M3, BIOS B200M3.2.2.3.0.080820141339 08/08/2014
kernel: ffff881218f40000 df68243feb35e3a8 ffff881237a43ab8 ffffffff815e237b
kernel: ffff881237a43ad0 ffffffff814cd4ca ffff8829ec71eb00 ffff881237a43af0
kernel: ffffffff814c6232 0000000000000286 ffff8829ec71eb00 ffff881237a43b00
kernel: Call Trace:
kernel: <IRQ>  [<ffffffff815e237b>] dump_stack+0x19/0x1b
kernel: [<ffffffff814cd4ca>] netdev_rx_csum_fault+0x3a/0x40
kernel: [<ffffffff814c6232>] __skb_checksum_complete_head+0x62/0x70
kernel: [<ffffffff814c6251>] __skb_checksum_complete+0x11/0x20
kernel: [<ffffffff8155a20c>] nf_ip_checksum+0xcc/0x100
kernel: [<ffffffffa049edc7>] icmp_error+0x1f7/0x35c [nf_conntrack_ipv4]
kernel: [<ffffffff814cf419>] ? netif_rx+0xb9/0x1d0
kernel: [<ffffffffa040eb7b>] ? internal_dev_recv+0xdb/0x130 [openvswitch]
kernel: [<ffffffffa04c8330>] nf_conntrack_in+0xf0/0xa80 [nf_conntrack]
kernel: [<ffffffff81509380>] ? inet_del_offload+0x40/0x40
kernel: [<ffffffffa049e302>] ipv4_conntrack_in+0x22/0x30 [nf_conntrack_ipv4]
kernel: [<ffffffff815005ca>] nf_iterate+0xaa/0xc0
kernel: [<ffffffff81509380>] ? inet_del_offload+0x40/0x40
kernel: [<ffffffff81500664>] nf_hook_slow+0x84/0x140
kernel: [<ffffffff81509380>] ? inet_del_offload+0x40/0x40
kernel: [<ffffffff81509dd4>] ip_rcv+0x344/0x380

Hardware verifies IP & tcp/udp header checksum but does not provide payload
checksum, use CHECKSUM_UNNECESSARY. Set it only if its valid IP tcp/udp packet.

Cc: Jiri Benc <jbenc@redhat.com>
Cc: Stefan Assmann <sassmann@redhat.com>
Reported-by: default avatarSunil Choudhary <schoudha@redhat.com>
Signed-off-by: default avatarGovindarajulu Varadarajan <_govind@gmx.com>
Reviewed-by: default avatarJiri Benc <jbenc@redhat.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
Signed-off-by: default avatarLuis Henriques <luis.henriques@canonical.com>
      969d621e
    • Jiri Pirko's avatar
      team: avoid possible underflow of count_pending value for notify_peers and mcast_rejoin · 0db432dd
      Jiri Pirko authored 
      commit b0d11b42 upstream.

This patch is fixing a race condition that may cause setting
count_pending to -1, which results in unwanted big bulk of arp messages
(in case of "notify peers").

Consider following scenario:

count_pending == 2
   CPU0                                           CPU1
					team_notify_peers_work
					  atomic_dec_and_test (dec count_pending to 1)
					  schedule_delayed_work
 team_notify_peers
   atomic_add (adding 1 to count_pending)
					team_notify_peers_work
					  atomic_dec_and_test (dec count_pending to 1)
					  schedule_delayed_work
					team_notify_peers_work
					  atomic_dec_and_test (dec count_pending to 0)
   schedule_delayed_work
					team_notify_peers_work
					  atomic_dec_and_test (dec count_pending to -1)

Fix this race by using atomic_dec_if_positive - that will prevent
count_pending running under 0.

Fixes: fc423ff0 ("team: add peer notification")
Fixes: 492b200e  ("team: add support for sending multicast rejoins")
Signed-off-by: default avatarJiri Pirko <jiri@resnulli.us>
Signed-off-by: default avatarJiri Benc <jbenc@redhat.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
Signed-off-by: default avatarLuis Henriques <luis.henriques@canonical.com>
      0db432dd
    • Eric Dumazet's avatar
      alx: fix alx_poll() · 2cdf9e93
      Eric Dumazet authored 
      commit 7a05dc64 upstream.

Commit d75b1ade ("net: less interrupt masking in NAPI") uncovered
wrong alx_poll() behavior.

A NAPI poll() handler is supposed to return exactly the budget when/if
napi_complete() has not been called.

It is also supposed to return number of frames that were received, so
that netdev_budget can have a meaning.

Also, in case of TX pressure, we still have to dequeue received
packets : alx_clean_rx_irq() has to be called even if
alx_clean_tx_irq(alx) returns false, otherwise device is half duplex.
Signed-off-by: default avatarEric Dumazet <edumazet@google.com>
Fixes: d75b1ade ("net: less interrupt masking in NAPI")
Reported-by: default avatarOded Gabbay <oded.gabbay@amd.com>
Bisected-by: default avatarOded Gabbay <oded.gabbay@amd.com>
Tested-by: default avatarOded Gabbay <oded.gabbay@amd.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
Signed-off-by: default avatarLuis Henriques <luis.henriques@canonical.com>
      2cdf9e93
    • Palik, Imre's avatar
      xen-netback: fixing the propagation of the transmit shaper timeout · 58db20fc
      Palik, Imre authored 
      commit 07ff890d upstream.

Since e9ce7cb6 ("xen-netback: Factor queue-specific data into queue struct"),
the transimt shaper timeout is always set to 0.  The value the user sets via
xenbus is never propagated to the transmit shaper.

This patch fixes the issue.

Cc: Anthony Liguori <aliguori@amazon.com>
Signed-off-by: default avatarImre Palik <imrep@amazon.de>
Acked-by: default avatarIan Campbell <ian.campbell@citrix.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
Signed-off-by: default avatarLuis Henriques <luis.henriques@canonical.com>
      58db20fc
GitLab Nexedi Edition | About GitLab | About Nexedi | 沪ICP备2021021310号-2 | 沪ICP备2021021310号-7