ICE1712 driver
Instead of muting the AC97 chip and thus eliminating the possibility of recording,
muting is done by setting front playback to DAC only instead of DAC+AUX.
Signed-off-by: Peter Christensen <ungod@developers.dk>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Intel8x0 driver
Fixed SPDIF support on ICH4/5/6.  The driver name of these chipsets
is set as 'ICH4' to tell from the older ICHs.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

AC97 Codec Core
CM9761 support patch is added.
At least, SPDIF and 4.0 output seems working.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

PCI drivers,BT87x driver
adds CONFIG_SND_BT87X_OVERCLOCK to enable sample rates
up to 1792000 Hz when recording from the analog input
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>

Documentation,NM256 driver
- The workaround for some laptops like Dell Latitude LS can be
  specified via reset_workaround module option, too.
- The check of reset_workaround is merged into the quirk table.
- The spinlock in AC97 reset callback is removed.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

ICE1712 driver
This patch adds support of the STAC9744 chip located on Aureon cards,
enabling volume control for analogue input channels.
It also adds the posibility of listening to both the analogue inputs
and the digital audio.
Signed-off-by: Peter Christensen <peter@developers.dk>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

ICE1712 driver
Clean up of ice1712 chip struct.  The board-specific data are moved
to spec union.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

RME HDSP driver
Fixed the data transfer of peakmeter ioctl on big-endian architectures.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

USB generic driver
Use usb_kill_urb() instead of deprecated usb_unlink_urb() for sync'ed URBs.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

USB generic driver,USB USX2Y
Use usb_kill_urb() instead of deprecated usb_unlink_urb()
Signed-off-by: Karsten Wiese <annabellesgarden@yahoo.de>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

PCM Midlevel
This patch fixes the dead-locking of linked PCM streams when
drain/drop is called.  The counter field is added to pcm group
struct to handle link/unlink more easily.

When the PCM streams are linked, start/drain/drop are operated
to all linked streams.  The drain will wait until draining of all
linked streams are finished.

The XRUN triggers stopping of all linked streams and changes the
state of all of them to XRUN even if only one of them is actually
in XRUN.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

ICE1712 driver
GPIO directions changed
   * GPIO>22 not configured as they do not exist
   * GPIO22 set to output (CS8415A CS pin)
   * GPIO21 set to input. (SPI MISO pin)

Init sequence of CS8415A changed:
  * SWCLK is set to 1 (OMCK output to RMCK pin)
  * MUX2:0 is set to 001 (S/PDIF input on RXP1)
  * SODEL is set to 1 (MSB of SDOUT data occurs if the second OSCLK period after the OLRCK edge)
  * SOLRPOL is set to 1 (SDOUT data is for the right channel with OLRCK is high)
Signed-off-by: Peter Christensen <peter@christensen>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

ICE1712 driver
Fix GPIO pin directions and use RXP1 instead of RXP0 as S/PDIF source on CS8415A
Signed-off-by: Peter Christensen <peter@developers.dk>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

VIA82xx driver
From: 1 1 <anoy@mail.ru>

I have tested my MB GA-7VAX and want to say you that you should use
VIA_DXS_ENABLE instead VIA_DXS_NO_VRA.  On the maximum volume output level
with VIA_DXS_NO_VRA there is abnormal loud noise, and with VIA_DXS_ENABLE
there are much less noises.  And I have detected unused code section.
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

RME HDSP driver
Fixes and clean up of GET_PEAK_RMS ioctl.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

au88x0 driver
cleanup au88x0 equalizer code by factoring out a sign_invert function
that ensures all negative integers become positive.
Signed-off-by: Jeff Muizelaar <muizelaar@rogers.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

RME HDSP driver
The variable types are declared explicitly like u32 and u64
to avoid ambiguity.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

BT87x driver
don't stop capture on errors because there's too much broken hardware out there
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>

ALSA sequencer
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>

into suse.cz:/home/perex/bk/linux-sound/linux-sound

au88x0 driver
use CARD_NAME_SHORT as driver name to allow different configuration file aliases in alsa-lib
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>

Intel8x0 driver
Force to set SPDIF rate when PCMOUT is used on ICH[1-3].
ICH4, NFORCE and ALI uses a separate DMA for SPDIF.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

RME HDSP driver
Fixed the loading of firmware data and the handling of meter mmap
on 64bit architectures.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

RME32 driver
- disables buffer prefill in halfduplex mode, which fixes segmentation fault
  of rme32 for playback in halfduplex mode
Signed-Off-By: Martin Langer <martin-langer@gmx.de>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

ICE1712 driver
The support for Lionstracs Mediastation is added.
The model name is 'mediastation'.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Documentation,ALSA Core,MPU401 UART,OPL3,CS46xx driver,YMFPCI driver
ATIIXP driver,ATIIXP-modem driver,CS4281 driver,Intel8x0 driver
Intel8x0-modem driver,RME32 driver,RME96 driver,au88x0 driver
KORG1212 driver,MIXART driver,NM256 driver,RME HDSP driver
RME9652 driver,PPC Tumbler driver
The type of iomem variables is changed to void __iomem *.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

ALSA sequencer
Allow auto-loading of sequencer modules except for module init time
(which may cause blocking).
Signed-off-by: Takashi Iwai <tiwai@suse.de>

IOCTL32 emulation
Signed-off-by: Takashi Iwai <tiwai@suse.de>

Intel8x0 driver
Improved the clock measurement routine to allow the longer sleep time.
Now it invokes schedule_timeout() instead of a long mdelay().
Signed-off-by: Takashi Iwai <tiwai@suse.de>

ES1968 driver
- Removed mdelay() in ac97 codec handling.
- Improved the clock measurement routine to allow the longer sleep time.
  Now it invokes schedule_timeout() instead of a long mdelay().
Signed-off-by: Takashi Iwai <tiwai@suse.de>

EMU10K1/EMU10K2 driver
This patch changes default constraint on 'EFX voices mask' control and
allow capture of 1, 2, 4, 8, 16, 32, 64 channels instead of 1, 2, 4, 8.
Signed-off-by: Peter Zubaj <pzad@pobox.sk>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

PCM Midlevel,IOCTL32 emulation
- Size mismatch of control element struct due to packed attribute
  is removed.
- A typo in PCM syncptr definition is fixed.
- Suppress the mmap of PCM status/control records on 32bit emulation
  mode since the record size doesn't match.
Signed-off-by: Takashi Iwai <tiwai@suse.de>

PCI drivers
modify ali5451 and intel8x0 help texts to better distinguish
between M5451 and M5455 AC97 controllers
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>

USB
make ISA, PCI and USB device look the same in {q,x,menu}config
Signed-off-by: Thierry Vignaud <tvignaud@mandrakesoft.com>
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>

ARM,ALSA Core,Generic drivers,ISA,PARISC,PCI drivers,PCMCIA Kconfig,PPC
USB
add module names and references to other documentation files
add more help for generic options
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>

Documentation
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>

AC97 Codec Core,ATIIXP driver,Intel8x0 driver,VIA82xx driver
Include the AC97 codec name in the card longname of
motherboard controllers.
(to enhance the chance of getting useful bug reports :)
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>

Intel8x0-modem driver
Driver name is always ICH-MODEM as defined in alsa-lib config.
Cosmetic cleanups: unused include files, MODULE_DEVICE update.
Signed-off-by: Sasha Khapyorsky <sashak@smlink.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>

ICE1712 driver
Signed-off-by: Kouichi ONO <co2b@ceres.dti.ne.jp>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>