ignored because of protocol nastiness.

into home.osdl.org:/home/torvalds/v2.5/linux

started the command - it may not exist any more.

In particular, load the host early in order to do proper
locking without having to access the command structure later.

Noted by Andries Brouwer.

into home.osdl.org:/home/torvalds/v2.5/linux

into kernel.bkbits.net:/home/davem/net-2.6

This patch arranges for the exception tables to be sorted on most
architectures.  It sorts the main kernel exception table on startup
and the module exception tables when they get loaded.  The main table
is sorted reasonably early - just after kmem_cache_init - but that
could be moved even earlier if necessary.

There is now a lib/extable.c which includes the sort_extable()
function from arch/ppc/mm/extable.c and the search_extable() function
from arch/i386/mm/extable.c, which had been copied to many
architectures.  On many architectures, arch/$(ARCH)/mm/extable.c
became empty and so I have removed it.

There are four architectures which do things differently from i386:
alpha, ia64, sparc and sparc64.  Alpha and ia64 store the offset from
the offset from the exception table entry to the instruction, and
sparc and sparc64 have range entries in the table.  For those
architectures I have added empty sort_extable functions.  The
maintainers for those architectures can implement something better if
they care to.  As it is they are no worse off than before.

Although it is a moderately sizable patch, it ends up with a net
reduction of 377 lines in the size of the kernel source. :)

I have tested this on x86 and ppc with a module that uses __get_user
in an init function, deliberately laid out to get the exception table
out of order, and it works (whereas it oopsed without this patch).

This went missing somewhere.  Here's a patch which puts it back.

Sanitize 66MHz clock use: "enable" 66MHz clock before starting UDMA3/4/5
read/write transfer and "disable" it after finishing transfer.

- fixes timings for non-UDMA3/4/5 operations (correct 33MHz timings are used)

- allows using UDMA3/4/5 modes on a capable drive even if non-UDMA3/4/5 drive
  is present on the same channel

- fixes corner case when one drive on the channel was using UDMA66/100 + LBA48
  (so clock was enabled/disabled for each read/write) and other one was using
  UDMA66/100 + LBA28, it could happen that request on LBA48 drive disabled
  66MHz clock and it was not enabled for the next transfer on LBA28 drive

drive->id is now always present even if no device is attached,
therefore check for drive->present instead.

This fixes bugzilla bug #1431.

Always tune controller PIO timings.  This fixes lockup during PIO access
(ie. 'cat /proc/ide/hda/identify') when Promise BIOS is disabled.

into home.osdl.org:/home/torvalds/v2.5/linux

When binding to a link-local address, inet6_bind() and raw6_bind() only
check that an interface is specified and that the address exists, but
they don't check if it actually exists on the specified interface.

Similarly, in datagram_sent_ctl() we don't check for the possibility of a
link-local address when we receive the source address from userspace.

into home.osdl.org:/home/torvalds/v2.5/linux

into home.osdl.org:/home/torvalds/v2.5/linux

The config entries etc were already removed earlier.

From: Chris Mason <mason@suse.com>

The v3 reiserfs_file_write func doesn't do any write throttling, which
leads to a variety of problems.  Here's a patch that makes
reiserfs_file_write call balance_dirty_pages_ratelimited, and exports that
func for module usage.

Remove now-unused 2.4 back-compat code.

gcc miscompiles this. Scary.

- A couple of them are using alloca (via DECLARE_BITMAP) and this generates
  a cannot-inline warning with -Winline.

- These functions are too big to inline anwyay.

From: Andries.Brouwer@cwi.nl

Remove obsolete CLONE_DETACHED

From: Sam Ravnborg <sam@ravnborg.org>

Modify MAINTAINERS to reflect the reality in maintainership for kbuild.
This is ack'ed with Michael Elizabeth Chastain and Kai Germaschewski.

I removed the list and web-site since they are not actively used today.

From: risto.sandvik@helsinki.fi

Everything freezes when trying to play sounds using the alsa driver opl3sa2
(kernel supplied or 1.0.0rc2) on an Acer Extensa series laptop with the Ali
M1533 PCI to ISA bridge.  Problem exists both in the 2.6 and 2.4 series of
kernels.

Adding AL_M1533 to drivers/pci/quirks.c fixes the problem for both.  This has
been a known problem since 2.2.x (see
http://www.mfn.unipmn.it/~sitta/linux503.html)

From: David Howells <dhowells@redhat.com>

Here's a patch to improve the AFS linux support. It:

 (1) Includes Pete's patch to skip the colon in the volume name, compile
     directly into the kernel, and not try to access non-existent caching
     routines.

 (2) Changes if (...) BUG() to BUG_ON()

 (3) Gets rid of typedefs.

 (4) Changes list_for_each() into list_for_each_entry().

 (5) Adds more whitespace and wraps lines to please the CodingStyle sticklers.

From: David Howells <dhowells@redhat.com>

Here's a patch to fix some bugs in my RxRPC code, including the fix for the
transport initialisation failure recovery spotted by Pete Zaitcev.

It also inserts some extra spaces in a few places.

From: Jes Sorensen <jes@trained-monkey.org>

The included patch removes the usage of weak symbols from sgiioc4.c now
that we have the Kconfig issue sorted as well as cleans up the error no
handling (instead of return 1 on error) and adds a check for the return
value on snia_pci_endian_set as suggested by Christoph.

From: James Morris <jmorris@redhat.com>

AFS has an unused strdup() implementation.

From: Xavier Bestel <xavier.bestel@free.fr>

Within the body of this macro we are accessing rq->bio, but `bio' is an arg
to the macro.  If someone uses this macro with some variable which is not
named `bio' it won't compile.

So use a more-likely-to-be-unique identifier for the macro.

From: Jeff Muizelaar <muizelaar@rogers.com>

The attached patch lets the seq_file api take care of buffer allocation
instead of doing it by hand.