- 04 Dec, 2020 40 commits
-
-
Lorenzo Bianconi authored
Rely on mt76_queue instead of qid in tx_queue_skb signature. This is a preliminary patch to move data queues in mt76_phy and add dbdc support to mt7915 driver Signed-off-by:
Lorenzo Bianconi <lorenzo@kernel.org> Signed-off-by:
Felix Fietkau <nbd@nbd.name>
-
Lorenzo Bianconi authored
This is a preliminary patch to move data queues in mt76_phy and properly support dbdc Signed-off-by:
-
Lorenzo Bianconi authored
This is a preliminary patch to move data queues in mt76_phy and properly support dbdc for mt7915 Signed-off-by:
-
Lorenzo Bianconi authored
This is a preliminary patch to move data queues in mt76_phy and properly support dbdc for mt7915 Signed-off-by:
-
Lorenzo Bianconi authored
This is a preliminary patch to move hw data queues in mt76_phy for mt7915 dbdc support Signed-off-by:
-
Lorenzo Bianconi authored
Move mt76_init_tx_queue in mac80211.c since it is shared by all drivers. Signed-off-by:
-
Lorenzo Bianconi authored
In order to make the code more readable, rely on mt7915_eeprom_field definitions for eeprom parsing Signed-off-by:
-
Lorenzo Bianconi authored
Since wtbl workqueue is used only for rate handling, refactor code to make it more clear Signed-off-by:
-
Ryder Lee authored
When looking for a MAC address slot, start by using main BSSID slots 1-3, afterwards use 16 repeater mode BSSID slots, then start using the slots usually used for AP mode. This search order should prevent unnecessary conflicts with AP mode interfaces on the same PHY. Note that two PHYs share global 32 omac slots with each other. Signed-off-by:
Ryder Lee <ryder.lee@mediatek.com> Signed-off-by:
-
Ryder Lee authored
mt7915_mcu_bss_sync_tlv() is no longer used, so remove it. Signed-off-by:
-
Ryder Lee authored
The omac_idx variable is u64 so we should use the 64-bit BIT_ULL(). Signed-off-by:
-
Lorenzo Bianconi authored
Make mt7915_eeprom_read routine static since it is used only in eeprom.c Signed-off-by:
-
Shayne Chen authored
Support to set tx frequency offset in testmode, which is usally used in the pre-calibration stage. Reviewed-by:
Shayne Chen <shayne.chen@mediatek.com> Signed-off-by:
-
Shayne Chen authored
Support tx_power setting in testmode. Note that the tx power value of antenna 1-3 equal to antenna 0. Reviewed-by:
-
Shayne Chen authored
Support testmode rx and display rx statistic by parsing RXV packet type, which is currently only enabled in testmode. Reviewed-by:
-
Shayne Chen authored
Support testmode tx for MT7915A, including tx streams and HE rate settings. Reviewed-by:
-
Shayne Chen authored
Extend enum mt76_testmode_tx_mode to support various HE rate modes. Reviewed-by:
-
Shayne Chen authored
Correct the bitfields of tx rateval and bw in tx descriptor. Reviewed-by:
-
Shayne Chen authored
Prepare for setting different LTF (1x, 2x, and 4x) and GI (0.8us, 1.6us, 3.2us) combinations in HE rate mode. Reviewed-by:
-
Shayne Chen authored
Add the parameter to control STBC function in testmode. Reviewed-by:
-
Shayne Chen authored
Support to display snr value when dumping rx statistics. Reviewed-by:
-
Shayne Chen authored
Change ib_rssi and wb_rssi into array type, since they could be reported by per-antenna. Reviewed-by:
-
Lorenzo Bianconi authored
Split tx and status path in mt76-usb module relying on mt76 workers APIs Signed-off-by:
-
Lorenzo Bianconi authored
In order to improve parallelism, convert rx path in mt76-usb module to mt76 workers APIs Signed-off-by:
-
Lorenzo Bianconi authored
Since rate configuration is run holding dev mutex, we can run key configuration in mt7615_set_key for usb/sdio devices avoiding to schedule the workqueue Tested-by:
Tested-by: YN Chen <yn.chen@mediatek.com> Signed-off-by:
-
Lorenzo Bianconi authored
Fix Tx-Rx MIC overwrite during TKIP hw key configuration Fixes: 01cfc1b4 ("mt76: mt7615: add BIP_CMAC_128 cipher support") Tested-by:
-
Lorenzo Bianconi authored
Switch to wep sw crypto for mt7615/mt7915 since wtbl require a sta reference and wep key is not pairwise Tested-by:
-
Sean Wang authored
SDIO-based WiFi would rely on an additional GPIO pin to wake up the host. Co-developed-by:
Sean Wang <sean.wang@mediatek.com> Signed-off-by:
-
Lorenzo Bianconi authored
Move mt76_mcu_send_firmware routine in common code since it is actually shared between mt7615, mt7663, mt7603 and mt7915 devices Signed-off-by:
-
David Bauer authored
Some newer MT7628 based routers (notably the TP-Link Archer C50 v4) are shipped with a chip-id of 0x7600 in the on-flash EEPROM. Add this as a possible valid ID. Ref: https://bugs.openwrt.org/index.php?do=details&task_id=2781Suggested-by:
Ron Asimi <ron.asimi@gmail.com> Signed-off-by:
David Bauer <mail@david-bauer.net> Signed-off-by:
-
Lorenzo Bianconi authored
Run mt76_free_device instead of ieee80211_free_hw if device probing fails in order to remove the already allocated mt76 workqueue Fixes: a86f1d01 ("mt76: move mt76 workqueue in common code") Fixes: f1d96236 ("mt76: mt7915: implement HE per-rate tx power support") Signed-off-by:
-
Ryder Lee authored
drivers/net/wireless/mediatek/mt76/mt7915/init.c:339:26: sparse: sparse: cast from restricted __le16 Fixes: 00b2e16e ("mt76: mt7915: add TxBF capabilities") Reported-by:
kernel test robot <lkp@intel.com> Signed-off-by:
-
Lorenzo Bianconi authored
Fix the following possible deadlock reported by lockdep disabling BH running mt76_free_pending_txwi() ================================ WARNING: inconsistent lock state 5.9.0-rc6 #14 Not tainted -------------------------------- inconsistent {IN-SOFTIRQ-W} -> {SOFTIRQ-ON-W} usage. rmmod/1227 [HC0[0]:SC0[0]:HE1:SE1] takes: ffff888156a83530 (&dev->lock#2){+.?.}-{2:2}, at: mt76_dma_cleanup+0x125/0x150 [mt76] {IN-SOFTIRQ-W} state was registered at: __lock_acquire+0x20c/0x6b0 lock_acquire+0x9d/0x220 _raw_spin_lock+0x2c/0x70 mt76_dma_tx_cleanup+0xc7/0x200 [mt76] mt76x02_poll_tx+0x31/0xb0 [mt76x02_lib] napi_poll+0x3a/0x100 net_rx_action+0xa8/0x200 __do_softirq+0xc4/0x430 asm_call_on_stack+0xf/0x20 do_softirq_own_stack+0x49/0x60 irq_exit_rcu+0x9a/0xd0 common_interrupt+0xa4/0x190 asm_common_interrupt+0x1e/0x40 irq event stamp: 9915 hardirqs last enabled at (9915): [<ffffffff8124e286>] __free_pages_ok+0x336/0x3b0 hardirqs last disabled at (9914): [<ffffffff8124e24e>] __free_pages_ok+0x2fe/0x3b0 softirqs last enabled at (9912): [<ffffffffa03aa672>] mt76_dma_rx_cleanup+0xa2/0x120 [mt76] softirqs last disabled at (9846): [<ffffffffa03aa5ea>] mt76_dma_rx_cleanup+0x1a/0x120 [mt76] other info that might help us debug this: Possible unsafe locking scenario: CPU0 ---- lock(&dev->lock#2); <Interrupt> lock(&dev->lock#2); *** DEADLOCK *** 1 lock held by rmmod/1227: #0: ffff88815b5eb240 (&dev->mutex){....}-{3:3}, at: driver_detach+0xb5/0x110 stack backtrace: CPU: 1 PID: 1227 Comm: rmmod Kdump: loaded Not tainted 5.9.0-rc6-wdn-src+ #14 Hardware name: Dell Inc. Studio XPS 1340/0K183D, BIOS A11 09/08/2009 Call Trace: dump_stack+0x77/0xa0 mark_lock_irq.cold+0x15/0x39 mark_lock+0x1fc/0x500 mark_usage+0xc7/0x140 __lock_acquire+0x20c/0x6b0 ? find_held_lock+0x2b/0x80 ? sched_clock_cpu+0xc/0xb0 lock_acquire+0x9d/0x220 ? mt76_dma_cleanup+0x125/0x150 [mt76] _raw_spin_lock+0x2c/0x70 ? mt76_dma_cleanup+0x125/0x150 [mt76] mt76_dma_cleanup+0x125/0x150 [mt76] mt76x2_cleanup+0x5a/0x70 [mt76x2e] mt76x2e_remove+0x18/0x30 [mt76x2e] pci_device_remove+0x36/0xa0 __device_release_driver+0x16c/0x220 driver_detach+0xcf/0x110 bus_remove_driver+0x56/0xca pci_unregister_driver+0x36/0x80 __do_sys_delete_module.constprop.0+0x127/0x200 ? syscall_enter_from_user_mode+0x1d/0x50 ? trace_hardirqs_on+0x1c/0xe0 do_syscall_64+0x33/0x80 entry_SYSCALL_64_after_hwframe+0x44/0xa9 RIP: 0033:0x7ff0da54e36b Code: 73 01 c3 48 8b 0d 2d 0b 0c 00 f7 d8 64 89 01 48 83 c8 ff c3 66 2e 0f 1f 84 00 00 00 00 00 90 f3 0f 1e fa b8 b0 00 00 00 0f 05 <48> 3d 01 f0 ff ff 73 01 c3 48 8b 0d fd 0a 0c 00 f7 d8 64 89 01 48 Fixes: dd57a95c ("mt76: move txwi handling code to dma.c, since it is mmio specific") Signed-off-by: -
Taehee Yoo authored
If THIS_MODULE is not set, the module would be removed while debugfs is being used. It eventually makes kernel panic. Fixes: e57b7901 ("mt76: add mac80211 driver for MT7915 PCIe-based chipsets") Signed-off-by:
Taehee Yoo <ap420073@gmail.com> Signed-off-by:
-
Ryder Lee authored
Avoid confusion with rx rate query function. Signed-off-by:
-
Ryder Lee authored
Update ppe_thresh capability to sync SDK setting. Signed-off-by:
-
Taehee Yoo authored
If THIS_MODULE is not set, the module would be removed while debugfs is being used. It eventually makes kernel panic. Fixes: ec9742a8 ("mt76: mt7915: add .sta_add_debugfs support") Signed-off-by:
-
Allen Pais authored
In preparation for unconditionally passing the struct tasklet_struct pointer to all tasklet callbacks, switch to using the new tasklet_setup() and from_tasklet() to pass the tasklet pointer explicitly. Signed-off-by:
Romain Perier <romain.perier@gmail.com> Signed-off-by:
Allen Pais <apais@linux.microsoft.com> Signed-off-by:
-
Lorenzo Bianconi authored
sched quota is now updated in mt7663s_txrx_worker so there is no more need of sched.lock mutex Signed-off-by:
-
Lorenzo Bianconi authored
Properly account current consumed ple quota in mt7663s_tx_pick_quota routine and avoid possible underflow. Fixes: 6ef2d665 ("mt76: mt7663s: split mt7663s_tx_update_sched in mt7663s_tx_{pick,update}_quota") Signed-off-by:
-
