Skip to content

L
linux
Switch branch/tag
  1. 26 Jan, 2017 6 commits
  3. 18 Jan, 2017 9 commits
  5. 17 Jan, 2017 5 commits
  7. 13 Jan, 2017 3 commits
    • Linus Walleij's avatar
      Merge tag 'sh-pfc-for-v4.11-tag1' of... · 537e18b2
      Linus Walleij authored 
      Merge tag 'sh-pfc-for-v4.11-tag1' of git://git.kernel.org/pub/scm/linux/kernel/git/geert/renesas-drivers into devel

pinctrl: sh-pfc: Updates for v4.11

  - Add bias handling for non-GPIO pins for R-Car H3,
  - Add drive-strength and bias handling for R-Car M3-W,
  - Add CAN, CAN FD, MSIOF, and HSCIF pin groups for R-Car M3-W,
  - Add SDHI voltage switching for R-Car M2-N.
      537e18b2
    • Thierry Reding's avatar
      pinctrl: Initialize pinctrl_dev.node · 46daed6e
      Thierry Reding authored 
      The struct pinctrl_dev's node field is not properly set up, which means
the .prev and .next fields will be NULL. That's not something that the
linked list code can deal with, so extra care must be taken when using
these fields. An example of this is introduced in commit 3429fb3c
("pinctrl: Fix panic when pinctrl devices with hogs are unregistered")
where list_del() is made conditional on the pinctrl device being part
of the pinctrl device list. This is to ensure that list_del() won't
crash upon encountering a NULL pointer in .prev and/or .next.

After initializing the list head there's no need to jump through these
extra hoops and list_del() will work unconditionally. This is because
the initialized list head points to itself and therefore the .prev and
.next fields can be properly dereferenced.
Signed-off-by: default avatarThierry Reding <treding@nvidia.com>
Acked-by: default avatarJon Hunter <jonathanh@nvidia.com>
Tested-by: default avatarJon Hunter <jonathanh@nvidia.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
      46daed6e
    • Tony Lindgren's avatar
      pinctrl: core: Fix regression caused by delayed work for hogs · 950b0d91
      Tony Lindgren authored 
      Commit df61b366af26 ("pinctrl: core: Use delayed work for hogs") caused a
regression at least with sh-pfc that is also a GPIO controller as
noted by Geert Uytterhoeven <geert@linux-m68k.org>.

As the original pinctrl_register() has issues calling pin controller
driver functions early before the controller has finished registering,
we can't just revert commit df61b366af26. That would break the drivers
using GENERIC_PINCTRL_GROUPS or GENERIC_PINMUX_FUNCTIONS.

So let's fix the issue with the following steps as a single patch:

1. Revert the late_init parts of commit df61b366af26.

   The late_init clearly won't work and we have to just give up
   on fixing pinctrl_register() for GENERIC_PINCTRL_GROUPS and
   GENERIC_PINMUX_FUNCTIONS.

2. Split pinctrl_register() into two parts

   By splitting pinctrl_register() into pinctrl_init_controller()
   and pinctrl_create_and_start() we have better control over when
   it's safe to call pinctrl_create().

3. Introduce a new pinctrl_register_and_init() function

   As suggested by Linus Walleij <linus.walleij@linaro.org>, we
   can just introduce a new function for the controllers that need
   pinctrl_create() called later.

4. Convert the four known problem cases to use new function

   Let's convert pinctrl-imx, pinctrl-single, sh-pfc and ti-iodelay
   to use the new function to fix the issues. The rest of the drivers
   can be converted later. Let's also update Documentation/pinctrl.txt
   accordingly because of the known issues with pinctrl_register().

Fixes: df61b366af26 ("pinctrl: core: Use delayed work for hogs")
Reported-by: default avatarGeert Uytterhoeven <geert@linux-m68k.org>
Cc: Gary Bisson <gary.bisson@boundarydevices.com>
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
Tested-by: default avatarGeert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
      950b0d91
  9. 11 Jan, 2017 7 commits
  11. 09 Jan, 2017 5 commits
    • Nishanth Menon's avatar
      pinctrl: Introduce TI IOdelay configuration driver · 003910eb
      Nishanth Menon authored 
      SoC family such as DRA7 family of processors have, in addition
to the regular muxing of pins (as done by pinctrl-single), a separate
hardware module called IODelay which is also expected to be configured.
The "IODelay" module has it's own register space that is independent
of the control module and the padconf register area.

With recent changes to the pinctrl framework, we can now support
this hardware with a reasonably minimal driver by using #pinctrl-cells,
GENERIC_PINCTRL_GROUPS and GENERIC_PINMUX_FUNCTIONS.

It is advocated strongly in TI's official documentation considering
the existing design of the DRA7 family of processors during mux or
IODelay reconfiguration, there is a potential for a significant glitch
which may cause functional impairment to certain hardware. It is
hence recommended to do as little of muxing as absolutely necessary
without I/O isolation (which can only be done in initial stages of
bootloader).

NOTE: with the system wide I/O isolation scheme present in DRA7 SoC
family, it is not reasonable to do stop all I/O operations for every
such pad configuration scheme. So, we will let it glitch when used in
this mode.

Even with the above limitation, certain functionality such as MMC has
mandatory need for IODelay reconfiguration requirements, depending on
speed of transfer. In these cases, with careful examination of usecase
involved, the expected glitch can be controlled such that it does not
impact functionality.

In short, IODelay module support as a padconf driver being introduced
here is not expected to do SoC wide I/O Isolation and is meant for
a limited subset of IODelay configuration requirements that need to
be dynamic and whose glitchy behavior will not cause functionality
failure for that interface.

IMPORTANT NOTE: we take the approach of keeping LOCK_BITs cleared
to 0x0 at all times, even when configuring Manual IO Timing Modes.
This is done by eliminating the LOCK_BIT=1 setting from Step
of the Manual IO timing Mode configuration procedure. This option
leaves the CFG_* registers unprotected from unintended writes to the
CTRL_CORE_PAD_* registers while Manual IO Timing Modes are configured.

This approach is taken to allow for a generic driver to exist in kernel
world that has to be used carefully in required usecases.
Signed-off-by: default avatarNishanth Menon <nm@ti.com>
Signed-off-by: default avatarLokesh Vutla <lokeshvutla@ti.com>
[tony@atomide.com: updated to use generic pinctrl functions, added
 binding documentation, updated comments]
Acked-by: default avatarRob Herring <robh@kernel.org>
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
      003910eb
    • Tony Lindgren's avatar
      pinctrl: core: Make dt_free_map optional · 92c2b671
      Tony Lindgren authored 
      If the pin controller driver is using devm_kzalloc, there may not be
anything to do for dt_free_map. Let's make it optional to avoid
unncessary boilerplate code.
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
      92c2b671
    • Maxime Ripard's avatar
      pinctrl: sunxi: Remove old sun5i pinctrl drivers · d83bb5a4
      Maxime Ripard authored 
      Now that we have a common pinctrl driver for all the sun5i SoCs, we can
remove the old, separate drivers.
Signed-off-by: default avatarMaxime Ripard <maxime.ripard@free-electrons.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
      d83bb5a4
    • Maxime Ripard's avatar
      pinctrl: sunxi: Add common sun5i pinctrl driver · 858f559f
      Maxime Ripard authored 
      The sun5i SoCs (A10s, A13, GR8) are all based on the same die fit in
different packages. Hence, the pins and functions available are just the
based on the same set, each SoC having a different subset.

Introduce a common pinctrl driver that supports multiple variants to allow
to put as much as we can in common.
Signed-off-by: default avatarMaxime Ripard <maxime.ripard@free-electrons.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
      858f559f
    • Maxime Ripard's avatar
      pinctrl: sunxi: Add pinctrl variants · 578db85f
      Maxime Ripard authored 
      Some SoCs are either supposed to be pin compatible (A10 and A20 for
example), or are just repackaged versions of the same die (A10s, A13, GR8).

In those case, having a full blown pinctrl driver just introduces
duplication in both data size and maintainance effort.

Add a variant option to both pins and functions to be able to limit the
pins and functions described only to a subset of the SoC we support with a
given driver.
Signed-off-by: default avatarMaxime Ripard <maxime.ripard@free-electrons.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
      578db85f
  13. 05 Jan, 2017 1 commit
    • Jon Hunter's avatar
      pinctrl: Fix panic when pinctrl devices with hogs are unregistered · 3429fb3c
      Jon Hunter authored 
      Commit df61b366af26 ('pinctrl: core: Use delayed work for hogs')
deferred part of the registration for pinctrl devices if the pinctrl
device has hogs. This introduced a window where if the pinctrl device
with hogs was sucessfully registered, but then unregistered again
(which could be caused by parent device being probe deferred) before
the delayed work has chanced to run, then this will cause a kernel
panic to occur because:

1. The 'pctldev->p' has not yet been initialised and when unregistering
   the pinctrl device we only check to see if it is an error value, but
   now it could also be NULL.
2. The pinctrl device may not have been added to the 'pinctrldev_list'
   list and we don't check to see if it was added before removing.

Fix up the above by checking to see if the 'pctldev->p' pointer is an
error value or NULL before putting the pinctrl device and verifying
that the pinctrl device is present in 'pinctrldev_list' before removing.

Fixes: df61b366af26 ('pinctrl: core: Use delayed work for hogs')
Signed-off-by: default avatarJon Hunter <jonathanh@nvidia.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
      3429fb3c
  15. 03 Jan, 2017 4 commits
GitLab Nexedi Edition | About GitLab | About Nexedi | 沪ICP备2021021310号-2 | 沪ICP备2021021310号-7