- 10 Feb, 2016 40 commits
-
-
Alex Deucher authored
Generally a good idea between VM sessions. We need a way to detect VM pass-through in general and always run asic_init in that case. Reviewed-by:
Monk Liu <monk.liu@amd.com> Reviewed-by:
Christian König <christian.koenig@amd.com> Signed-off-by:
Alex Deucher <alexander.deucher@amd.com>
-
Alex Deucher authored
Required to make desicions about certain code pathes. Reviewed-by:
-
Alex Deucher authored
This table is found on boards that support SR-IOV. This will be used to determine if the board supports SR-IOV and allow the driver to take specific action in certain cases. Reviewed-by:
-
Alex Deucher authored
amdgpu_boot_test_post_card() is not used anywhere. Probably a leftover from the original port from radeon. Reviewed-by:
Tom St Denis <tom.stdenis@amd.com> Signed-off-by:
-
Maruthi Srinivas Bayyavarapu authored
ACP IP have internal DMA controller, DW I2S controller and DSPs as separate power tiles. DMA and I2S devices are added to generic pm domain, so that entire IP can be powered off/on at appropriate times. Unused DSPs are made to be powered off though they are powered on during ACP pm domain power on sequence. Signed-off-by:
Maruthi Bayyavarapu <maruthi.bayyavarapu@amd.com> Reviewed-by:
-
Maruthi Bayyavarapu authored
This adds the ACP (Audio CoProcessor) IP driver and wires it up to the amdgpu driver. The ACP block provides the DMA engine for i2s based ALSA driver. This is required for audio on APUs that utilize an i2s codec. Reviewed-by:
Jammy Zhou <Jammy.Zhou@amd.com> Reviewed-by:
Murali Krishna Vemuri <murali-krishna.vemuri@amd.com> Signed-off-by:
Chunming Zhou <david1.zhou@amd.com> Signed-off-by:
-
Christian König authored
That works with other values as well. Signed-off-by:
-
Christian König authored
Don't calculate the end address multiple times. Signed-off-by:
-
Christian König authored
Neither the global nor the local mutex exists any more and amdgpu doesn't support cayman. Signed-off-by:
-
Christian König authored
No need to fence every page table, just the page directory is enough. Signed-off-by:
-
Christian König authored
If we can't copy entries from the GTT or fill them with one command split up the mapping operation into multiple ones. v2: agd: rebase on upstream v3: squash in Christian's fix Signed-off-by:
-
Christian König authored
That allows the VM code to use GART BOs from other driver instances. v2: don't use copy optimization for foreign GARTs, that won't work. v3: some more comment cleanups v4: agd: rebase on upstream Signed-off-by:
-
Christian König authored
No need to duplicate that code over and over again. Also stop using the flags to determine if we need to map the addresses. v2: constify the pages_addr v3: rebased, fix typo in commit message Signed-off-by:
-
Christian König authored
Those are just leftovers from the time we wrote the VM updates directly to the ring. Signed-off-by:
-
Christian König authored
Crashing the system doesn't helps at all. Also properly return -EINVAL if size or alignment are outside valid ranges. Signed-off-by:
-
Monk Liu authored
since the dependency job is also scheduled by the same scheduler with the job depended on it, no need to call wake up scheduler when the dep is scheduled. Signed-off-by:
-
Alex Deucher authored
This adds the DCE8 enum header. Acked-by:
Harry Wentland <harry.wentland@amd.com> Acked-by:
-
Eric Huang authored
Reviewed-by:
Eric Huang <JinHuiEric.Huang@amd.com> Signed-off-by:
-
Eric Huang authored
These add the interfaces for manual clock control. Reviewed-by:
-
Eric Huang authored
These add the interfaces for manual clock control. Reviewed-by:
-
Eric Huang authored
The new sysfs interfaces: pp_num_states: Read-only, return the number of all pp states, 0 if powerplay is not available. pp_cur_state: Read-only, return the index number of current pp state. pp_force_state: Read-write, to write a power state index will switch to selected state forcedly and enable forced state mode, disable forced state mode. such as "echo >...". pp_table: Read-write, binary output, to be used to read or write the dpm table, the maximum file size is 4KB of page size. pp_dpm_sclk: Read-write, reading will return a dpm levels list, to write an index number will force powerplay to set the corresponding dpm level. pp_dpm_mclk: same as sclk. pp_dpm_pcie: same as sclk. And add new setting "manual" to the existing interface power_dpm_force_performance_level. Reviewed-by:
-
Christian König authored
With the scheduler enabled we don't need that any more. Signed-off-by:
-
Christian König authored
It's not needed any more because all access goes through the scheduler now. v2: Update commit message. Signed-off-by:
-
Christian König authored
With the scheduler enabled managing per ring LRUs don't make much sense any more. Signed-off-by:
-
Christian König authored
No need for an extra function any more. v2: comment cleanups Signed-off-by:
-
Christian König authored
This allows the scheduler to handle the dependencies on ID contention as well. v2: grab id only once v3: use a separate lock for the VMIDs v4: cleanup after semaphore removal v5: minor coding style change Signed-off-by:
-
Christian König authored
Because of the scheduler all traces come from the same thread now and can't be distincted otherwise. Signed-off-by:
-
Alex Deucher authored
It doesn't currently do anything and there's no need for it going forward since pci config reset will be required as a fallback even when we have fine grained reset implemented. Signed-off-by: -
Alex Deucher authored
Ported from similar code in radeon. Reviewed-by:
Junwei Zhang <Jerry.Zhang@amd.com> Reviewed-by:
Ken Wang <Qingqing.Wang@amd.com> Signed-off-by:
-
Alex Deucher authored
Posting is required after a pci config reset. Reviewed-by:
-
Alex Deucher authored
Drop soft reset, always use pci config reset. Reviewed-by:
-
Alex Deucher authored
Drop soft reset, always use pci config reset. Reviewed-by:
-
Christian König authored
Not used any more without semaphores Signed-off-by:
-
Christian König authored
Not needed any more without semaphores. v2: remove unused variables as well Signed-off-by:
-
Alex Deucher authored
No longer needed since semaphores were removed. Reviewed-by:
-
Chunming Zhou authored
Non-scheduler code is longer supported. v2: agd: rebased on upstream Signed-off-by:
-
Chunming Zhou authored
No longer needed now that semaphores are gone. V2: remove the first amdgpu_sync_wait in amdgpu_ib_schedule Signed-off-by:
-
Chunming Zhou authored
No longer used. Signed-off-by:
-
Christian König authored
The other ones don't have any VAs assigned anyway or are uninteresting to us. Signed-off-by:
-
Christian König authored
Make UVD/VCE VM emulation more efficient. Signed-off-by:
-
