- 16 Nov, 2005 1 commit
-
-
KOVACS Krisztian authored
Fix nf_conntrack statistics proc file removal. Looks like the old bug was forward-ported from ip_conntrack. :-] Signed-off-by:
KOVACS Krisztian <hidden@balabit.hu> Signed-off-by:
Harald Welte <laforge@netfilter.org> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
- 15 Nov, 2005 39 commits
-
-
Stephen Hemminger authored
From Joe Perches Signed-off-by:
Stephen Hemminger <shemminger@osdl.org> Signed-off-by:
-
Jochen Friedrich authored
Signed-off-by:
Jochen Friedrich <jochen@scram.de> Acked-by:
Arnaldo Carvalho de Melo <acme@mandriva.com> Signed-off-by:
-
Jochen Friedrich authored
Signed-off-by:
-
Jochen Friedrich authored
Signed-off-by:
-
Luiz Capitulino authored
The patch below fixes the following sparse warning: net/ipv6/ipv6_sockglue.c:291:13: warning: Using plain integer as NULL pointer Signed-off-by:
Luiz Capitulino <lcapitulino@mandriva.com.br> Signed-off-by:
-
Yan Zheng authored
The "score.rule++" doesn't make any sense for me. According to codes above, I think it should be "hiscore.rule++;" . Signed-off-by: Yan Zheng<yanzheng@21cn.com> Acked-by:
YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org> Signed-off-by:
-
Linus Torvalds authored
-
Bob Picco authored
Fix up booting with sparse mem enabled. Otherwise it would just cause an early PANIC at boot. Signed-off-by:
Bob Picco <bob.picco@hp.com> Signed-off-by:
Andi Kleen <ak@suse.de> Signed-off-by:
Linus Torvalds <torvalds@osdl.org>
-
Andi Kleen authored
This is needed for large multinode IBM systems which have a sparse APIC space in clustered mode, fully covering the available 8 bits. The previous kernels would limit the local APIC number to 127, which caused it to reject some of the CPUs at boot. I increased the maximum and shrunk the apic_version array a bit to make up for that (the version is only 8 bit, so don't need an full int to store) Cc: Chris McDermott <lcm@us.ibm.com> Signed-off-by:
-
Andi Kleen authored
CONFIG_CHECKING covered some debugging code used in the early times of the port. But it wasn't even SMP safe for quite some time and the bugs it checked for seem to be gone. This patch removes all the code to verify GS at kernel entry. There haven't been any new bugs in this area for a long time. Previously it also covered the sysctl for the page fault tracing. That didn't make much sense because that code was unconditionally compiled in. I made that a boot option now because it is typically only useful at boot. Signed-off-by:
-
Magnus Damm authored
The current x86_64 NUMA memory code is inconsequent when it comes to node memory ranges. The exact behaviour varies depending on which config option that is used. setup_node_bootmem() has start and end as arguments and these are used to calculate the size of the node like this: (end - start). This is all fine if end is pointing to the first non-available byte. The problem is that the current x86_64 code sometimes treats it as the last present byte and sometimes as the first non-available byte. The result is that some configurations might lose a page at the end of the range. This patch tries to fix CONFIG_ACPI_NUMA, CONFIG_K8_NUMA and CONFIG_NUMA_EMU so they all treat the end variable as the first non-available byte. This is the same way as the single node code. The patch is boot tested on dual x86_64 hardware with the above configurations, but maybe the removed code is needed as some workaround? Signed-off-by:
Magnus Damm <magnus@valinux.co.jp> Signed-off-by:
-
Andi Kleen authored
The logging for boot errors was turned off because it was broken on some AMD systems. But give Intel EM64T systems a chance because they are supposed to be correct there. The advantage is that there is a chance to actually log uncorrected machine checks after the reset. Signed-off-by:
-
Ravikiran G Thirumalai authored
On x86_64 arches, there is no way to choose ACPI_NUMA without having to choose K8_NUMA. CONFIG_K8_NUMA is not needed for Intel EM64T NUMA boxes. It also looks odd if you have to select ACPI_NUMA from the power management menu. This patch fixes those oddities. Patch does the following: 1. Makes NUMA a config option like other arches 2. Makes topology detection options like K8_NUMA dependent on NUMA 3. Choosing ACPI NUMA detection can be done from the standard "Processor type and features" menu AK: I fixed up the dependencies and changed the help texts a bit on top of Kiran's patch. Signed-off-by:
Ravikiran Thirumalai <kiran@scalex86.org> Signed-off-by:
Shai Fultheim <shai@scalex86.org> Signed-off-by:
-
Paolo 'Blaisorblade' Giarrusso authored
Keeping this function does not makes sense because it's a copied (and buggy) copy of sys_time. The only difference is that now.tv_sec (which is a time_t, i.e. a 64-bit long) is copied (and truncated) into a int (32-bit). The prototype is the same (they both take a long __user *), so let's drop this and redirect it to sys_time (and make sure it exists by defining __ARCH_WANT_SYS_TIME). Only disadvantage is that the sys_stime definition is also compiled (may be fixed if needed by adding a separate __ARCH_WANT_SYS_STIME macro, and defining it for all arch's defining __ARCH_WANT_SYS_TIME except x86_64). Acked-by:
Paolo 'Blaisorblade' Giarrusso <blaisorblade@yahoo.it> Signed-off-by:
Andrew Morton <akpm@osdl.org> Signed-off-by:
-
Paolo 'Blaisorblade' Giarrusso authored
The current value was correct before the introduction of Intel EM64T support - but now L1_CACHE_SHIFT_MAX can be less than L1_CACHE_SHIFT, which _is_ funny! Between the few users of ____cacheline_maxaligned_in_smp, we also have (for example) rcu_ctrlblk, and struct zone, with zone->{lru_,}lock. I.e. we have a lot of excess cacheline bouncing on them. No correctness issues, obviously. So this could even be merged for 2.6.14 (I'm not a fan of this idea, though). CC: Andi Kleen <ak@suse.de> Signed-off-by: -
Andi Kleen authored
Not needed since x86-64 always uses the spinlock based rwsems. Signed-off-by:
-
Andi Kleen authored
B stepping were the first shipping Opterons. memcpy/memset/copy_page/ clear_page had special optimized version for them. These are really old and in the minority now and the difference to the generic versions (using rep microcode) is not that big anyways. So just remove them. TODO: figure out optimized versions for Intel Netburst based EM64T Signed-off-by:
-
Andi Kleen authored
Old code could retry for 10 seconds worst time. Only try it for one second now. Suggested by Yinghai Lu Cc: Yinghai.Lu@amd.com Signed-off-by:
-
Siddha, Suresh B authored
Fix the Intel cache detection code assumption that number of threads sharing the cache will either be equal to number of HT or core siblings. This also cleans up the code in general a bit. Signed-off-by:
Suresh Siddha <suresh.b.siddha@intel.com> Signed-off-by:
-
Siddha, Suresh B authored
Fields obtained through cpuid vector 0x1(ebx[16:23]) and vector 0x4(eax[14:25], eax[26:31]) indicate the maximum values and might not always be the same as what is available and what OS sees. So make sure "siblings" and "cpu cores" values in /proc/cpuinfo reflect the values as seen by OS instead of what cpuid instruction says. This will also fix the buggy BIOS cases (for example where cpuid on a single core cpu says there are "2" siblings, even when HT is disabled in the BIOS. http://bugzilla.kernel.org/show_bug.cgi?id=4359) Signed-off-by:
-
Andi Kleen authored
Signed-off-by:
-
Andi Kleen authored
When they were disabled before (e.g. after a panic) it's better to keep them off, otherwise followon panics can happen from timer interrupt handlers etc. Drawback is that pageup in the console won't work anymore though. Signed-off-by:
-
Andi Kleen authored
No functional changes. Signed-off-by:
-
Andi Kleen authored
Signed-off-by:
-
Shaohua Li authored
They report 40bit, but only have 36bits of physical address space. This caused problems with setting up the correct masks for MTRR. CPUID workaround for steppings 0F33h(supporting x86) and 0F34h(supporting x86 and EM64T). Detail info can be found at: http://download.intel.com/design/Xeon/specupdt/30240216.pdf http://download.intel.com/design/Pentium4/specupdt/30235221.pdf Signed-off-by: Shaohua Li<shaohua.li@intel.com> Signed-off-by:
-
Andi Kleen authored
Ugh! Cc: davej@redhat.com Signed-off-by:
-
Andi Kleen authored
So far all new ones have worked and there isn't much variation because the CPU does all the interesting bits. So enable try unsupported by default. Can be still disabled with try_unsupported=0 (module) or amd64.try_unsupported=0 (boot option) Signed-off-by:
-
Andi Kleen authored
(no name because I'm not sure of the correct name) Cc: davej@redhat.com Signed-off-by:
-
Eric Dumazet authored
Compute the highest possible value for memnode_shift, in order to reduce footprint of memnodemap[] to the minimum, thus making all users (phys_to_nid(), kfree()), more cache friendly. Before the patch : Node 0 MemBase 0000000000000000 Limit 00000001ffffffff Node 1 MemBase 0000000200000000 Limit 00000003ffffffff Using 23 for the hash shift. Max adder is 3ffffffff After the patch : Node 0 MemBase 0000000000000000 Limit 00000001ffffffff Node 1 MemBase 0000000200000000 Limit 00000003ffffffff Using 33 for the hash shift. In this case, only 2 bytes of memnodemap[] are used, instead of 2048 Signed-off-by:
Eric Dumazet <dada1@cosmosbay.com> Signed-off-by:
-
Bryan Ford authored
This allows to run 64bit signal handlers in 64bit processes that run small code snippets in compat mode. Signed-off-by:
-
Andi Kleen authored
With a NR_CPUS==128 kernel with CPU hotplug enabled we would waste 4MB on per CPU data of all possible CPUs. The reason was that HOTPLUG always set up possible map to NR_CPUS cpus and then we need to allocate that much (each per CPU data is roughly ~32k now) The underlying problem is that ACPI didn't tell us how many hotplug CPUs the platform supports. So the old code just assumed all, which would lead to this memory wastage. This implements some new heuristics: - If the BIOS specified disabled CPUs in the ACPI/mptables assume they can be enabled later (this is bending the ACPI specification a bit, but seems like a obvious extension) - The user can overwrite it with a new additionals_cpus=NUM option - Otherwise use half of the available CPUs or 2, whatever is more. Cc: ashok.raj@intel.com Cc: len.brown@intel.com Signed-off-by:
-
Andi Kleen authored
Pointed out by Eric Dumazet Signed-off-by:
-
Andi Kleen authored
I got some questions on this, so just fix up the documentation. Signed-off-by:
-
Andi Kleen authored
Minor victory on the continuous quest against all stray extern. Signed-off-by:
-
Andi Kleen authored
Minor cleanup - remove obsolete extern Signed-off-by:
-
Andi Kleen authored
Adding __initdata_* to asm-generic/sections.h Replaces a lot of open coded externs in arch/x86_64/* I had to change __bss_end to __bss_stop to match the other architectures. Signed-off-by:
-
Andi Kleen authored
It is for physical addresses, not for PFNs. Pointed out by Tejun Heo. Cc: htejun@gmail.com Signed-off-by:
-
Siddha, Suresh B authored
We should zap the low mappings, as soon as possible, so that we can catch kernel bugs more effectively. Previously early boot had NULL mapped and didn't trap on NULL references. This patch introduces boot_level4_pgt, which will always have low identity addresses mapped. Druing boot, all the processors will use this as their level4 pgt. On BP, we will switch to init_level4_pgt as soon as we enter C code and zap the low mappings as soon as we are done with the usage of identity low mapped addresses. On AP's we will zap the low mappings as soon as we jump to C code. Signed-off-by:
Ashok Raj <ashok.raj@intel.com> Signed-off-by:
-
Andi Kleen authored
Not go from the CPU number to an mapping array. Mode number is often used now in fast paths. This also adds a generic numa_node_id to all the topology includes Suggested by Eric Dumazet Signed-off-by:
-
