We were only requesting renewal after our tickets expire; do so before
that.  Most of the low-level logic for this was already there; just use
it.
Signed-off-by: Sage Weil <sage@newdream.net>

We only want to send pending mon requests when we successfully
authenticate.  If we are already authenticated, like when we renew our
ticket, there is no need to resend pending requests.
Signed-off-by: Sage Weil <sage@newdream.net>

fs/ceph/auth.c: linux/slab.h is included more than once.
fs/ceph/super.h: linux/slab.h is included more than once.
Acked-by: Christoph Lameter <cl@linux-foundation.org>
Signed-off-by: Andrea Gelmini <andrea.gelmini@gelma.net>
Signed-off-by: Sage Weil <sage@newdream.net>

ac->ops may be null; use protocol id in error message instead.
Reported-by: Dan Carpenter <error27@gmail.com>
Signed-off-by: Sage Weil <sage@newdream.net>

The underlying problem is that many mds requests can't be restarted.  For
example, a restarted create() would return -EEXIST if the original request
succeeds.  However, we do not want a hung MDS to hang the client too.  So,
use the _killable wait_for_completion variants to abort on SIGKILL but
nothing else.
Signed-off-by: Sage Weil <sage@newdream.net>

Add missing _killable_timeout variant for wait_for_completion that will
return when a timeout expires or the task is killed.

CC: Ingo Molnar <mingo@elte.hu>
CC: Andreas Herrmann <andreas.herrmann3@amd.com>
CC: Thomas Gleixner <tglx@linutronix.de>
CC: Mike Galbraith <efault@gmx.de>
Acked-by: Peter Zijlstra <a.p.zijlstra@chello.nl>
Signed-off-by: Sage Weil <sage@newdream.net>

Use the same message, allocated during startup.  No need to reallocate a
new one each time around (and potentially ENOMEM).
Signed-off-by: Sage Weil <sage@newdream.net>

The auth_reply handler will (re)send any pending requests.  For the
initial mon authenticate phase, that's correct, but when a auth ticket
renewal races with an in-flight request, we may resend a request message
that is already in flight.  Avoid this by revoking the message before
sending it.

We should also avoid resending requests at all during ticket renewal; that
will come soon.
Signed-off-by: Sage Weil <sage@newdream.net>

The C99 specification states in section 6.11.5:

The placement of a storage-class specifier other than at the beginning
of the declaration specifiers in a declaration is an obsolescent
feature.
Signed-off-by: Tobias Klauser <tklauser@distanz.ch>
Signed-off-by: Sage Weil <sage@newdream.net>

This is essential, as for the rados block device we'll need
to run in different contexts that would need flags that
are other than GFP_NOFS.
Signed-off-by: Yehuda Sadeh <yehuda@hq.newdream.net>
Signed-off-by: Sage Weil <sage@newdream.net>

Specify max bytes in request to bound size of reply.  Add associated
mount option with default value of 512 KB.
Signed-off-by: Sage Weil <sage@newdream.net>

Signed-off-by: Sage Weil <sage@newdream.net>

Use kzalloc rather than the combination of kmalloc and memset.

The semantic patch that makes this change is as follows:
(http://coccinelle.lip6.fr/)

// <smpl>
@@
expression x,size,flags;
statement S;
@@

-x = kmalloc(size,flags);
+x = kzalloc(size,flags);
 if (x == NULL) S
-memset(x, 0, size);
// </smpl>
Signed-off-by: Julia Lawall <julia@diku.dk>
Signed-off-by: Sage Weil <sage@newdream.net>

We invalidate I_COMPLETE and dentry leases in two places: on aborted mds
request and on request replay.  Use common helper to avoid duplicate code.
Signed-off-by: Sage Weil <sage@newdream.net>

Signed-off-by: Sage Weil <sage@newdream.net>

These are used for adjusting behavior, such as conditionally encoding a
newer message format.
Signed-off-by: Sage Weil <sage@newdream.net>

Notable changes include pool op defines and types, FLOCK feature bit, and
new CMPXATTR osd ops.
Signed-off-by: Sage Weil <sage@newdream.net>

Drop the 'user.' prefix and use just 'ceph.' for fs virtual xattrs.
Signed-off-by: Sage Weil <sage@newdream.net>

The remove_session_caps() helper is called when an MDS closes out our
session (either normally, or as a result of a failed reconnect), and when
we tear down state for umount.  If we remove the last cap, and there are
no cap migrations in progress, then there is little hope of us flushing
out that data to the mds (without heroic efforts to reconnect and flush).

So, to avoid leaving inodes pinned (due to dirty state) and crashing after
umount, throw out dirty caps state and unpin the inodes.  Print a warning
to the console so we know something was lost.

NOTE: Although we drop wrbuffer refs, we don't actually mark pages clean;
maybe a truncate should be queued?
Signed-off-by: Sage Weil <sage@newdream.net>

Currently, if our session is closed (due to a timeout, or explicit close,
or whatever), we just sit there doing nothing unless/until the MDS
restarts, at which point we try to reconnect.

Change client to attempt an immediate reconnect if our session is closed.

Note that currently the MDS doesn't support this, and our attempt will
fail.  We'll get a session CLOSE, our caps and dirty cap state will be
dropped, and the client will be free to attempt to reconnect.  That's
clearly not as nice as a successful reconnect, but it at least allows us
to try to carry on, and in the future the MDS will support a reconnect
and we will fare better.
Signed-off-by: Sage Weil <sage@newdream.net>

Pass a ceph_mds_session, since the caller has it.

Remove the dead code for sending empty reconnects.  It used to be used
when the MDS contacted _us_ to solicit a reconnect, and we could reply
saying "go away, I have no session."  Now we only send reconnects based
on the mds map, and only when we do in fact have an open session.
Signed-off-by: Sage Weil <sage@newdream.net>

We used to infer reconnect success by watching the MDS state, essentially
assuming that hearing nothing meant things were ok.  That wasn't
particularly reliable.  Instead, the MDS replies with an explicit OPEN
message to indicate success.

Strictly speaking, this is a protocol change, but it is a backwards
compatible one that does not break new clients + old servers or old
clients + new servers.  At least not yet.

Drop unused @all argument from kick_requests while we're at it.
Signed-off-by: Sage Weil <sage@newdream.net>

On OPENING we shouldn't have any caps (or releases).
On CLOSING, we should wait until we succeed (and throw it all out), or
don't (and are OPEN again).
On RECONNECTING we can wait until we are OPEN.
Signed-off-by: Sage Weil <sage@newdream.net>

If the MDS restarts, the expire caps state is no longer shared, and can be
thrown out.  Caps state will be rebuilt on the MDS during the reconnect
process that follows.  Zero out any release messages and adjust the
release counter accordingly.
Signed-off-by: Sage Weil <sage@newdream.net>

This is being done so that we could reuse the statfs
infrastructure with other requests that return values.
Signed-off-by: Yehuda Sadeh <yehuda@hq.newdream.net>
Signed-off-by: Sage Weil <sage@newdream.net>

The CEPH_FEATURE_NOSRCADDR protocol feature avoids putting the full source
address in each message header (twice).  This patch switches the client to
the new scheme, and _requires_ this feature on the server.  The server
will support both the old and new schemes.  That means an old client will
work with a new server, but a new client will not work with an old server.
Signed-off-by: Sage Weil <sage@newdream.net>

We don't ever use "dirty" so we can remove it.
Signed-off-by: Dan Carpenter <error27@gmail.com>
Signed-off-by: Sage Weil <sage@newdream.net>

Signed-off-by: Sage Weil <sage@newdream.net>

The bdi_setup_and_register() helper doesn't help us since we bdi_init() in
create_client() and bdi_register() only when sget() succeeds.
Signed-off-by: Sage Weil <sage@newdream.net>

Signed-off-by: Sage Weil <sage@newdream.net>

Reported-by: Bill Pemberton <wfp5p@virginia.edu>
Signed-off-by: Sage Weil <sage@newdream.net>

Ensure all options are included in /proc/mounts.  Some cleanup.
Signed-off-by: Sage Weil <sage@newdream.net>

We want to assign an offset when the dentry goes from null to linked, which
is always done by splice_dentry().  Notably, we should NOT assign an
offset when a dentry is first created and is still null.

BUG if we try to splice a non-null dentry (we shouldn't).
Signed-off-by: Sage Weil <sage@newdream.net>

This can screw up offsets assigned to new dentries and break dcache
readdir results.
Signed-off-by: Sage Weil <sage@newdream.net>

Signed-off-by: Sage Weil <sage@newdream.net>

Set next_offset to 2 (always 2!), not 0, on readdir finish.
Signed-off-by: Sage Weil <sage@newdream.net>

If the version hasn't changed, don't rebuild the index.
Signed-off-by: Henry C Chang <henry_c_chang@tcloudcomputing.com>
Signed-off-by: Sage Weil <sage@newdream.net>

If we use the xattr_blob, clear the pointer so we don't release the memory
at the bottom of the fuction.
Reported-by: Henry C Chang <henry_c_chang@tcloudcomputing.com>
Signed-off-by: Sage Weil <sage@newdream.net>

Simplify messenger locking, and close race between ceph_con_close() setting
the CLOSED bit and con_work() checking the bit, then taking the mutex.
Signed-off-by: Sage Weil <sage@newdream.net>

Signed-off-by: Sage Weil <sage@newdream.net>