- 19 Feb, 2018 40 commits
-
-
Eric Huang authored
mmhub PG is enabled by SMU FW only for Raven. Signed-off-by:
Eric Huang <JinHuiEric.Huang@amd.com> Reviewed-by:
Alex Deucher <alexander.deucher@amd.com> Signed-off-by:
-
Eric Huang authored
Signed-off-by:
-
Dan Carpenter authored
We deleted some code in e154162e ("drm/amd/powerplay: refine pp code for raven") but there were a few related bits that were missed. Let's delete them as well. Signed-off-by:
Dan Carpenter <dan.carpenter@oracle.com> Signed-off-by:
-
Tom St Denis authored
Since 12 of the 16 bytes are not initialized with anything let's ensure they're sensibly zeroed out otherwise debugfs callers will read back garbage (because they assume debugfs wrote sensible data back...) Signed-off-by:
Tom St Denis <tom.stdenis@amd.com> Reviewed-by:
-
Yongqiang Sun authored
Signed-off-by:
Yongqiang Sun <yongqiang.sun@amd.com> Reviewed-by:
Tony Cheng <Tony.Cheng@amd.com> Acked-by:
Harry Wentland <harry.wentland@amd.com> Signed-off-by:
-
Charlene Liu authored
Signed-off-by:
Charlene Liu <charlene.liu@amd.com> Reviewed-by:
-
Tony Cheng authored
Signed-off-by:
-
Krunoslav Kovac authored
There are several optimizations: 1) Use predefined SRGB, don't calculate. This is the most common case. 2) Precompute HW X points at boot since they're fixed in ColModule 3) Precompute PQ - it never changes and is very CPU intensive in fixed pt. 4) Reduce number of points in ColModule to 512 (32x16) from 1024. This also requires reducing some regions for legacy DCEs to 16 pts at most. Performance 1) is super-fast, build_output_tf is 1-2us, down from 25000-30000. Programming also fast since only one reg write. 2)+3) gives build_output_tf for PQ in ~100us range, down from ~80000-110000 2) + 4) results in slightly over 50% improvement. It gives an idea of the savings when we can't use SRGB or PQ table (e.g. sdr white level > 80). There's also a bit of refactoring: renaming some stuff that was misleading and removing a lot of magic numbers that novices might not be able to understand where they come from and what they mean. Signed-off-by:
Krunoslav Kovac <Krunoslav.Kovac@amd.com> Reviewed-by:
-
Charlene Liu authored
Signed-off-by:
-
Charlene Liu authored
Signed-off-by:
-
Tony Cheng authored
Signed-off-by:
-
John Barberiz authored
Signed-off-by:
John Barberiz <jbarberi@amd.com> Reviewed-by:
-
Yongqiang Sun authored
System soft hang when hotplug specific 4K DP panel due to link caps read error and incorrect link setting parmas to enable dp. Add status check for DPCD read and add return value for detect dp, in case of false, return from caller, avoid further false operation. Signed-off-by:
-
Roman Li authored
Fixing null-deref on Vega10 due to regression after 'fix cursor related Pstate hang' change. Added null checks in setting cursor position. Signed-off-by:
Roman Li <Roman.Li@amd.com> Reviewed-by:
Eric Yang <eric.yang2@amd.com> Reviewed-by:
-
Nikola Cornij authored
Signed-off-by:
Nikola Cornij <nikola.cornij@amd.com> Reviewed-by:
-
Eric Yang authored
As a precaution to prevent cases where cursor is enabled on a pipe that is disabled, always turn off cursor when disconnecting plane. Signed-off-by:
-
Eric Bernstein authored
Signed-off-by:
Eric Bernstein <eric.bernstein@amd.com> Reviewed-by:
-
Ken Chalmers authored
* Previous code did some calculations with a mix of normal integers and integers aligned as U2.24 fixed-point values. * There were bugs in the conversion of the final result into the S4.19 values required for the registers. Signed-off-by:
Ken Chalmers <ken.chalmers@amd.com> Reviewed-by:
-
Eric Yang authored
Signed-off-by:
-
Eric Yang authored
Move cursor programming to inside the OTG_MASTER_UPDATE_LOCK If graphics plane go from 1 pipe to hsplit, the cursor updates after mpc programming and unlock. Which means there is a window of time where cursor is enabled on the wrong pipe if it's on the right side of the screen (i.e. case where cursor need to move from pipe 0 to pipe 3 post split). This will cause pstate hang. Solution is to program the cursor while still locked. Signed-off-by:
-
Mikita Lipski authored
Because AMDGPU_CRTC_IRQ_VLINE1 = 6, it expected 6 more crtcs to be programed with disabled irq state in amdgpu_irq_disable_all. That caused errors and accessed the wrong memory location. Signed-off-by:
Mikita Lipski <mikita.lipski@amd.com> Reviewed-by:
-
Yongqiang Sun authored
Signed-off-by:
-
Yongqiang Sun authored
When disable plane, check power gate flag in hubp with pipe_ctx, not with res_pool. Signed-off-by:
-
Christian König authored
Otherwise we might overwrite stuff which is still in use. Signed-off-by:
Christian König <christian.koenig@amd.com> Reviewed-by:
Felix Kuehling <Felix.Kuehling@amd.com> Signed-off-by:
-
Tony Cheng authored
Signed-off-by:
-
John Barberiz authored
If non-standard gamma type detected set identity matrix flag so that we can bypass the gamma mode. Signed-off-by:
-
Charlene Liu authored
Signed-off-by:
-
Leo (Sunpeng) Li authored
If CONFIG_DEBUG_FS is disabled, then CRC should also be disabled. Therefore, amdgpu_dm_crtc_handle_crc_irq was redefined as a no-op function within amdgpu_dm.h. However, since amdgpu_dm.h is included in multiple files, this caused conflicts when linking during compile. Therefore, Use a macro to define the function as a no-op instead. Signed-off-by:
Leo (Sunpeng) Li <sunpeng.li@amd.com> Reviewed-by:
-
Jerry (Fangzhi) Zuo authored
There is no need to call drm_mode_set_crtcinfo() again once crtc timing is decided. Otherwise non-native/unsupported timing might get overwritten. Signed-off-by:
Jerry (Fangzhi) Zuo <Jerry.Zuo@amd.com> Reviewed-by:
-
Martin Tsai authored
Signed-off-by:
Martin Tsai <martin.tsai@amd.com> Reviewed-by:
-
Charlene Liu authored
Signed-off-by:
-
Harry Wentland authored
Signed-off-by:
-
Christian König authored
It also needs to be initialized. Signed-off-by:
Chunming Zhou <david1.zhou@amd.com> Signed-off-by:
-
Christian König authored
Without it we run into a memory leak. Signed-off-by:
-
Alex Deucher authored
No longer used since we changed the MC programming sequence. Reviewed-by:
Michel Dänzer <michel.daenzer@amd.com> Signed-off-by:
-
Alex Deucher authored
Using the wrong mask. Reviewed-by:
Hans de Ruiter <hans@keasigmadelta.com> Signed-off-by:
-
Arnd Bergmann authored
Building the amd display driver with link-time optimizations revealed a bug that caused dal_cmd_tbl_helper_dce80_get_table() and dal_cmd_tbl_helper_dce110_get_table() get called with an incompatible return type between the two callers in command_table_helper.c and command_table_helper2.c: drivers/gpu/drm/amd/amdgpu/../display/dc/bios/dce80/command_table_helper_dce80.h:31: error: type of 'dal_cmd_tbl_helper_dce80_get_table' does not match original declaration [-Werror=lto-type-mismatch] const struct command_table_helper *dal_cmd_tbl_helper_dce80_get_table(void); drivers/gpu/drm/amd/amdgpu/../display/dc/bios/dce80/command_table_helper_dce80.c:351: note: 'dal_cmd_tbl_helper_dce80_get_table' was previously declared here const struct command_table_helper *dal_cmd_tbl_helper_dce80_get_table(void) drivers/gpu/drm/amd/amdgpu/../display/dc/bios/dce110/command_table_helper_dce110.h:32: error: type of 'dal_cmd_tbl_helper_dce110_get_table' does not match original declaration [-Werror=lto-type-mismatch] const struct command_table_helper *dal_cmd_tbl_helper_dce110_get_table(void); drivers/gpu/drm/amd/amdgpu/../display/dc/bios/dce110/command_table_helper_dce110.c:361: note: 'dal_cmd_tbl_helper_dce110_get_table' was previously declared here const struct command_table_helper *dal_cmd_tbl_helper_dce110_get_table(void) The two versions of the structure are obviously derived from the same one, but have diverged over time, before they got added to the kernel. This moves the structure to a new shared header file and uses the superset of the members, to ensure the interfaces are all compatible. Fixes: ae79c310 ("drm/amd/display: Add DCE12 bios parser support") Signed-off-by:
Arnd Bergmann <arnd@arndb.de> Signed-off-by:
-
Christian König authored
Beneficial when a lot of processes are waiting for VMIDs. Signed-off-by:
-
Christian König authored
Now that we have the different cases for grabbing a VMID in separate functions, restructure the top level function to only have one place where VMIDs are assigned to jobs. Signed-off-by:
-
Christian König authored
Let's try this once more. Signed-off-by:
-
