- 17 Nov, 2010 40 commits
-
-
Joe Perches authored
Using %pR standardizes the struct resource output. Signed-off-by:
Joe Perches <joe@perches.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Joe Perches authored
Signed-off-by:
Jon Mason <jon.mason@exar.com> Signed-off-by:
-
Joe Perches authored
Signed-off-by:
-
Anirban Chakraborty authored
Signed-off-by:
Anirban Chakraborty <anirban.chakraborty@qlogic.com> Signed-off-by:
-
Sony Chacko authored
Log LRO off message while disabling rx checksum only when LRO is already enabled. Signed-off-by:
Sony Chacko <sony.chacko@qlogic.com> Signed-off-by:
-
Sritej Velaga authored
Add description for CN1000Q adapter Signed-off-by:
Sritej Velaga <sritej.velaga@qlogic.com> Signed-off-by:
-
Rajesh Borundia authored
In case of kdump environment the function may be in unknown state. Reset the function using PCI FLR before initializing it. Signed-off-by:
Rajesh Borundia <rajesh.borundia@qlogic.com> Signed-off-by:
-
Sucheta Chakraborty authored
Allow minimum bandwidth to be set zero Signed-off-by:
Sucheta Chakraborty <sucheta.chakraborty@qlogic.com> Signed-off-by:
-
Thomas Graf authored
IPv6 already exposes some address family data via netlink in the IFLA_PROTINFO attribute if RTM_GETLINK request is sent with the address family set to AF_INET6. We take over this format and reuse all the code. Signed-off-by:
Thomas Graf <tgraf@infradead.org> Cc: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org> Signed-off-by:
-
Thomas Graf authored
Implements the AF_INET link address family exposing the per device configuration settings via netlink using the attribute IFLA_INET_CONF. The format of IFLA_INET_CONF differs depending on the direction the attribute is sent. The attribute sent by the kernel consists of a u32 array, basically a 1:1 copy of in_device->cnf.data[]. The attribute expected by the kernel must consist of a sequence of nested u32 attributes, each representing a change request, e.g. [IFLA_INET_CONF] = { [IPV4_DEVCONF_FORWARDING] = 1, [IPV4_DEVCONF_NOXFRM] = 0, } libnl userspace API documentation and example available from: http://www.infradead.org/~tgr/libnl/doc-git/group__link__inet.htmlSigned-off-by: -
Thomas Graf authored
Define IPV4_DEVCONF_MAX to get rid of MAX - 1 notation. Signed-off-by:
-
Thomas Graf authored
Each net_device contains address family specific data such as per device settings and statistics. We already expose this data via procfs/sysfs and partially netlink. The netlink method requires the requester to send one RTM_GETLINK request for each address family it wishes to receive data of and then merge this data itself. This patch implements a new API which combines all address family specific link data in a new netlink attribute IFLA_AF_SPEC. IFLA_AF_SPEC contains a sequence of nested attributes, one for each address family which in turn defines the structure of its own attribute. Example: [IFLA_AF_SPEC] = { [AF_INET] = { [IFLA_INET_CONF] = ..., }, [AF_INET6] = { [IFLA_INET6_FLAGS] = ..., [IFLA_INET6_CONF] = ..., } } The API also allows for address families to implement a function which parses the IFLA_AF_SPEC attribute sent by userspace to implement address family specific link options. Signed-off-by: -
Jeremy Eder authored
This patch helps clarify documentation for net.ipv4.igmp_max_memberships by providing a formula for calculating the maximum number of multicast groups that can be subscribed to, plus defining the theoretical limit. Signed-off-by:
Jiri Pirko <jpirko@redhat.com> Signed-off-by:
Jeremy Eder <jeder@redhat.com> Signed-off-by:
-
Joe Perches authored
Add __attribute__((format... to several functins Make formats and arguments match. Signed-off-by:
-
Eric Paris authored
The SELinux netfilter hooks just return NF_DROP if they drop a packet. We want to signal that a drop in this hook is a permanant fatal error and is not transient. If we do this the error will be passed back up the stack in some places and applications will get a faster interaction that something went wrong. Signed-off-by:
Eric Paris <eparis@redhat.com> Signed-off-by:
-
Eric Paris authored
The current tcp_connect code completely ignores errors from sending an skb. This makes sense in many situations (like -ENOBUFFS) but I want to be able to immediately fail connections if they are denied by the SELinux netfilter hook. Netfilter does not normally return ECONNREFUSED when it drops a packet so we respect that error code as a final and fatal error that can not be recovered. Based-on-patch-by:
Patrick McHardy <kaber@trash.net> Signed-off-by:
-
Eric Paris authored
SELinux would like to pass certain fatal errors back up the stack. This patch implements the generic netfilter support for this functionality. Based-on-patch-by:
-
Joe Perches authored
Signed-off-by:
-
Joe Perches authored
Signed-off-by:
-
Joe Perches authored
Signed-off-by:
-
Joe Perches authored
Signed-off-by:
-
Joe Perches authored
Signed-off-by:
-
Joe Perches authored
Signed-off-by:
-
Joe Perches authored
Signed-off-by:
-
Joe Perches authored
Signed-off-by:
-
Joe Perches authored
Signed-off-by:
-
David S. Miller authored
-
Dongdong Deng authored
With enabling CONFIG_PCI_MSI, e1000e could work in MSI/MSI-X IRQ mode, and netpoll controller didn't deal with those IRQ modes on e1000e. This patch add the handling MSI/MSI-X IRQ modes to netpoll controller, so that netconsole could work with those IRQ modes. Signed-off-by:
Dongdong Deng <dongdong.deng@windriver.com> Signed-off-by:
Jeff Kirsher <jeffrey.t.kirsher@intel.com>
-
Bruce Allan authored
The driver can fail initializing the hardware when manageability firmware is performing concurrent MDIO operations because the hardware semaphore scheme to prevent concurrent operations between software and firmware is incorrect for 82574/82583. Instead of using the SWSM register, the driver should be using the EXTCNF_CTRL register. A software mutex is also added to prevent simultaneous software threads from performing similar concurrent accesses. Signed-off-by:
Bruce Allan <bruce.w.allan@intel.com> Tested-by:
Emil Tantilov <emil.s.tantilov@intel.com> Signed-off-by:
-
Bruce Allan authored
SerDes Link detection on certain 82571 mezzanine cards can fail when the link is forced, the link partner does not recognize forced link and the link partner sends null code words. Detect the null code words and return to auto-negotiation state which causes the link partner to begin responding with valid code words. Within a reasonable interval the link will finally settle as forced by both partners. Signed-off-by:
-
Greg Rose authored
declaration. Reported-by:
Andi Kleen <andi@firstfloor.org> Signed-off-by:
Greg Rose <gregory.v.rose@intel.com> Tested-by:
-
Julian Stecklina authored
Removed unused variable in igbvf. Signed-off-by:
Julian Stecklina <jsteckli@os.inf.tu-dresden.de> Acked-by:
Greg Rose <greg.v.rose@intel.com> Tested-by:
-
Greg Rose authored
Update version string and copyright notice Signed-off-by:
-
Greg Rose authored
The driver is calling netif_carrier_off and netif_tx_stop_all_queues before the netdevice is registered which causes an Oops. Move call to netif_carrier_off after the netdevice is registered and remove call to netif_tx_stop_all_queues because there aren't any TX queues yet. Signed-off-by:
-
Eric Dumazet authored
I noticed ring variable was initialized before allocations, and that memory node management was a bit ugly. We also leak memory in case of ring allocations error. Signed-off-by:
Eric Dumazet <eric.dumazet@gmail.com> Signed-off-by:
-
Don Skidmore authored
This patch adds support for the x540 MAC which is the next MAC in the 82598/82599 line. Signed-off-by:
Don Skidmore <donald.c.skidmore@intel.com> Signed-off-by:
-
Don Skidmore authored
Adds the new x540.c file and Aquantia 1202 PHY for X540 support. Signed-off-by:
Stephen Ko <stephen.s.ko@intel.com> Signed-off-by:
-
Don Skidmore authored
The new MAC type X540 shares much of the same functionality of some silicon specific functions. To reduce duplicate code, made these functions generic. Signed-off-by:
-
Yi Zou authored
When invalidating the DDP context is invalidated, the HW may not be done with the user buffer right away. In which case, we poll the FCBUFF register to check if the buffer valid bit is cleared or not, if not, we wait for max 100us that is guaranteed by the HW. Signed-off-by:
Yi Zou <yi.zou@intel.com> Tested-by:
Ross Brattain <ross.b.brattain@intel.com> Signed-off-by:
-
Yi Zou authored
The hw automatically invalidates the context if DDP is successful or there is error detected. In case there is no error status available from the hw, initializing the per context error status to be 1 allows the DDP context to be still invalidated via the upper layer call to ddp_put(). Signed-off-by:
-
