Skip to content

L
linux
Switch branch/tag
  1. 21 Aug, 2004 2 commits
  3. 20 Aug, 2004 1 commit
  5. 19 Aug, 2004 3 commits
    • James Bottomley's avatar
      [PATCH] fix for Domain Validation hang on some devices with sym_2 · afe57355
      James Bottomley authored 
      There's a bad hang where the driver locks the system solid trying to do
domain validation with certain devices.  The one I've managed to
reproduce it with is a Quantum Atlas.

What happens is that setting the offset to zero is an async negotiation
message.  However, the driver still seems to have DT set (which is
illegal).  Most devices just reject this as stupid, but the Quantum
seems to try to obey it and hangs the bus.

The simple fix is to reset all PPR options when the offset is set to
zero.
Signed-off-by: default avatarJames Bottomley <James.Bottomley@SteelEye.com>
      afe57355
    • Brian King's avatar
      [PATCH] Allow TCQ depth to be lowered properly · 74a84824
      Brian King authored 
      Ran into a couple small issues with the patch. First,
blk_queue_resize_tags wasn't getting exported, so I sent Jens a patch to
fix this, which he has now sent upstream. Second, the comment above
blk_queue_resize_tags says the queue_lock must be held when calling this
routine. Attached is an updated patch that grabs the lock. Other than
that, it looks good.

James Bottomley wrote:
> On Tue, 2004-08-03 at 10:50, Brian King wrote:
>>Currently, it is possible to call scsi_activate_tcq with a small queue depth,
>>then later call scsi_adjust_queue_depth with a larger queue depth. This results
>>in the scsi layer having a larger queue depth than the block layer knows about.
>>This results in these additional commands being issued as untagged ops rather than
>>tagged ops. This patch changes scsi_activate_tcq to call blk_queue_init_tags with
>>the maximum supported number of tags so this cannot occur.
>
>
> Sorry, been away at conferences with not enough time to remember what
> went on here.
>
> The reason it looks the way it does is historical...when the blk layer
> tcq interfaces were created, there was no way to resize the queue.  Jens
> later added resize (for me) and I forgot to incorporate it into the
> code.
>
> Another small point is that the max number of tags can be greater than
> 256.  256 is a SPI limit only (and even the qla1280, a SPI card which
> could use the tag as its global queue index would take > 256).  The
> limit in scsi_adjust_queue_depth has long since been obsoleted by our
> dynamic command allocation.
>
> I think the attached should work correctly (as long as it compiles...I
> coded it up on the flight home).
Signed-off-by: default avatarBrian King <brking@us.ibm.com>
Signed-off-by: default avatarJames Bottomley <James.Bottomley@SteelEye.com>
      74a84824
    • James Bottomley's avatar
      get the kernel to warn about deprecated SCSI ioctls · 59fbf85b
      James Bottomley authored 
      The non unique SCSI ioctls:

SCSI_IOCTL_SEND_COMMAND
SCSI_IOCTL_TEST_UNIT_READY
SCSI_IOCTL_BENCHMARK_COMMAND
SCSI_IOCTL_SYNC
SCSI_IOCTL_START_UNIT
SCSI_IOCTL_STOP_UNIT

Have been deprecated for a while now.  We should make the kernel
complain when a program actually uses one of them, so users have had
adequate warning before they are removed.
Signed-off-by: default avatarJames Bottomley <James.Bottomley@SteelEye.com>
      59fbf85b
  7. 18 Aug, 2004 2 commits
  9. 17 Aug, 2004 1 commit
  11. 16 Aug, 2004 2 commits
    • Mike Anderson's avatar
      [PATCH] reorder call in scsi_remove_host · 44d90463
      Mike Anderson authored 
      This patch against scsi-misc-2.6 reorders a call to scsi_forget_host in
the scsi_remove_host function. This removes the error message
"Synchronizing SCSI cache..." on rmmod of a scsi host driver module as
shown in example output 1 and 2 below.

I had previous created a much more complicated patch to work around this
problem. In response Christoph mention a simpler solution (pointer to
thread below) which is this patch.

http://marc.theaimsgroup.com/?l=linux-scsi&m=108720042210331&w=2

Example output.

1.) Before patch.

elm:~# scsi1 : scsi_debug, version 1.73 [20040518], dev_size_mb=8,
opts=0x0
  Vendor: Linux     Model: scsi_debug        Rev: 0004
  Type:   Direct-Access                      ANSI SCSI revision: 03
SCSI device sdc: 16384 512-byte hdwr sectors (8 MB)
SCSI device sdc: drive cache: write back
 sdc: unknown partition table
Attached scsi disk sdc at scsi1, channel 0, id 0, lun 0
Attached scsi generic sg4 at scsi1, channel 0, id 0, lun 0,  type 0
Synchronizing SCSI cache for disk sdc: <4>FAILED
  status = 0, message = 00, host = 1, driver = 00

2.) After patch.

elm:~# scsi1 : scsi_debug, version 1.73 [20040518], dev_size_mb=8, opts=0x0
  Vendor: Linux     Model: scsi_debug        Rev: 0004
  Type:   Direct-Access                      ANSI SCSI revision: 03
SCSI device sdc: 16384 512-byte hdwr sectors (8 MB)
SCSI device sdc: drive cache: write back
 sdc: unknown partition table
Attached scsi disk sdc at scsi1, channel 0, id 0, lun 0
Attached scsi generic sg4 at scsi1, channel 0, id 0, lun 0,  type 0
Synchronizing SCSI cache for disk sdc:
Signed-off-by: default avatarMike Anderson <andmike@us.ibm.com>
Signed-off-by: default avatarJames Bottomley <James.Bottomley@SteelEye.com>
      44d90463
    • James Bottomley's avatar
      MPT Fusion driver 3.01.15 update · dd424b0a
      James Bottomley authored 
      Highlights of this release:
- Patch provided by Christoph Hellwig to remove the isense code.
- Fix compile errors when CONFIG_PROC_FS=n.
- A fix for the module parameter "mptscsih" which was not being exported.
- The port of the 2.05.17 thru 2.05.23 of the lk 2.4 mpt driver.
Signed-off-by: default avatarJames Bottomley <James.Bottomley@SteelEye.com>
      dd424b0a
  13. 14 Aug, 2004 24 commits
  15. 13 Aug, 2004 4 commits
  17. 01 Aug, 2004 1 commit
GitLab Nexedi Edition | About GitLab | About Nexedi | 沪ICP备2021021310号-2 | 沪ICP备2021021310号-7