into intel.com:/home/lenb/src/linux-acpi-test-2.6.2

into intel.com:/home/lenb/src/linux-acpi-test-2.6.2

The attached patch updates the acpi4asus driver to 0.27 through the
following changes:
- add support for M1300A, S5200N, L8400L,
- remove WLED support for certain models, since it is not controlled by
  AML,
- add LCD backlight switching for L2E / L3H,
- C99 initializers,
- generic LED handlers,
- the output of ASYM method to provide battery state information (might be
  more accurate under certain conditions) in /proc/acpi/asus/info,
- fix several oddities, various clean-ups and other minor changes.

The patch itself is quite big, which is mostly due to the C99 initializers
and the fact that diff doesn't like moving code around.

This has been compile-tested in various configurations, the substantive
changes were discussed on the acpi4asus mailing list.

The code should apply to current bk (both for 2.4 and 2.6). The patch is
also available here:
http://hell.org.pl/~sziwan/asus/acpi4asus-0.26-0.27.diff

Thanks to all the contributors (notably Pontus Fuchs) to this release.

Fix remote chance of invalid buffer access in write_video.
Support alternate HCI method path (recent "Phoenix BIOS" Toshiba's).
Signal more proc-write errors.
On proc-reads, report errors via printk instead of proc output.
Add log level and driver name prefix to all printk's.
Add missing __init and __exit function attributes.
Be explicit about vars for which code relies on zero-init of BSS.

from Martin Hicks

into intel.com:/home/lenb/src/linux-acpi-test-2.6.2

See http://www.cse.unsw.edu.au/~gernot/persona/hobbies/dunnart.html
for more information about Dunnarts, in case you've never heard of
them before. Courtesy of Gernot Heiser.

the size to "vsnprintf()".

That's a pretty clear case of overflow.

into home.osdl.org:/home/torvalds/v2.5/linux

into home.osdl.org:/home/torvalds/v2.5/linux

into kernel.bkbits.net:/home/davem/tg3-2.6

into intel.com:/home/lenb/src/linux-acpi-test-2.6.2

  http://bugzilla.kernel.org/show_bug.cgi?id=1766

into kernel.bkbits.net:/home/davem/tg3-2.6

sparc_do_fault assumes that pmd_val(*pmd) = pmd_val(*pmd_k) will
duplicate a PMD entry.  With large soft-PMDs this doesn't work.

Align the pkmap area on a 4MB region so that a single
large pagetable can be used.  Fixes random killing of
processes which used high memory.

This has been in -mm since 2.6.1-mm5

 - IDE can be used as module again (compiles and works),
   this fixes bugzilla bugs #576 and #1700
 - separate module for probing is no longer required
 - generic/default host driver is available as ide_generic module

This contains the build fixes by Adrian Bunk and Andrew Morton.

Thanks to Eric Brower for spotting this.

into nuts.davemloft.net:/disk1/davem/BK/sparc-2.6

From: Davin McCall <davmac@ozonline.com.au>

Set hwif->chipset to ide_forced if it was forced by kernel parameters.

Set hwif->chipset to ide_generic for hwifs controlled by generic IDE
code, so they wont be taken by setup_pci.c:ide_match_hwif().

Patch also fixes /proc/ide/ideX/model to report "generic" instead of
"(none)" for default hwifs.

This has been in -mm since 2.6.1-mm1.

You can't just cast cpumasks.  It doesn't compile if NR_CPUS is greater than
4 * BITS_PER_LONG.

into home.osdl.org:/home/torvalds/v2.5/linux

into nuts.davemloft.net:/disk1/davem/BK/sparc-2.6

This should fix some picky USB devices.

From Tom Rini <trini@kernel.crashing.org>

On the MBX the kernel made an assumption about where the MAC address would
be in the VPD (Vital Product Data).  However, the documentation for the
firmware (EPPC-Bug) describes the format of the VPD and makes no
guarrantees about the location of any VPD record.  It does however describe
the format of each record type and the MAC address record will be of type
'08' and of size 6.  This changes the code so that instead of assuming a
position, it searches for the record, which I assume is also what EPPC-Bug
does.

From: "H. Peter Anvin" <hpa@zytor.com>

Apparently, on x86-64, the stack isn't always aligned properly (16 bytes)
in the kernel at the moment.  This causes the RAID-6 code to crash the
system.  This patch is a workaround for that; the right thing is to muck
with the assembly entrypoints to enforce proper stack alignment.  However,
that's not anything I feel comfortable doing in an evening, especially
since I don't have a machine on which I can test the resulting kernels.

From: Martin Schwidefsky <schwidefsky@de.ibm.com>

SCLP console/tty fixes:

- Fix incorrect state change of SCLP_RUNNING flag in interrupt handler

- Suppress emission of empty buffers to prevent stack overflow

- Fix off by one error in sclp_write (used to return # of chars written + 1)

- Prevent sclp_tty_write_string from waiting in interrupt (during flush)

- Fix deadlock after TIOCSCLPSNL ioctl

- Fix sclp_tty_chars_in_buffer calculation

From: Martin Schwidefsky <schwidefsky@de.ibm.com>

s390 inline assembly bug-fixes:

- Add memory barriers to spinlocks, atomic variable functions and to
  test_and_{set,clear,change}_bit.

- Add "=m" and "m" contraints to tell gcc that the content of a variable
  is in fact used.

- Replace "+m" constraints by "=m" on the output and "m" on the input list.

- Use c-implemtation for ffz and __ffs.

- Use generic c-implemtation for ffs and fls.

From: Martin Schwidefsky <schwidefsky@de.ibm.com>

s390 general update:

- Add archhelp for "make image".

- 32-bit execve fix.

- Export some symbols: sys_ioctl, put_files_struct & ccw_device_work.

- Minor cleanups in arch/s390/mm/init.c & drivers/s390/net/ctctty.c.