Signed-off-by: David S. Miller <davem@davemloft.net>

Fix interrupt test handler by adding check for IRQ assertion in
PCI_STATE register in addition to the status block updated bit.

Add test for valid ethernet address in tg3_set_mac_addr().

Add tg3_bus_string() to setup the PCI bus speed/width string for all
PCI/PCIX/PCI Express devices. This is used to print the bus type
during init_one().
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Fix 5780 PHY related problems:

1. MAC_RX_MODE reset must be done before setting up the MAC_MODE
   register on 5705_PLUS chips or the chip will stop receiving after
   a while. The MAC_RX_MODE reset is needed to prevent intermittently
   losing the first receive packet on serdes chips.

2. Skip MAC loopback test on 5780 because of hardware errata. Normal
   traffic including PHY loopback is not affected by the errata.

3. PHY loopback fails intermittently on 5708S and this is fixed by
   putting the PHY in loopback mode first before programming the MAC
   mode register. A MAC_RX_MODE reset is also added.

4. Return -EINVAL in tg3_nway_reset() if device is in TBI mode. Allow
   nway_reset if 5780S is in parallel detect mode.

5. Add missing PHY IDs in KNOWN_PHY_ID() macro.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

If we double-add a neighbour entry timer, which should be
impossible but has been reported, dump the current state of
the entry so that we can debug this.
Signed-off-by: David S. Miller <davem@davemloft.net>

When you've enabled conntrack and NAT as a module (standard case in all
distributions), and you've also enabled the new conntrack netlink
interface, loading ip_conntrack_netlink.ko will auto-load iptable_nat.ko.
This causes a huge performance penalty, since for every packet you iterate
the nat code, even if you don't want it.

This patch splits iptable_nat.ko into the NAT core (ip_nat.ko) and the
iptables frontend (iptable_nat.ko).  Threfore, ip_conntrack_netlink.ko will
only pull ip_nat.ko, but not the frontend.  ip_nat.ko will "only" allocate
some resources, but not affect runtime performance.

This separation is also a nice step in anticipation of new packet filters
(nf-hipac, ipset, pkttables) being able to use the NAT core.
Signed-off-by: Harald Welte <laforge@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

These broke existing apps, and the checks are superfluous
as the values being verified aren't even used.
Signed-off-by: David S. Miller <davem@davemloft.net>

> Steps to reproduce:
> 1. Boot Linux, do NOT setup any IPv6 routes
> 2. ip route get 2001::1 (or any unroutable address)

Well caught.  We never set rt6i_idev on ip6_null_entry.
This patch should make the problem go away.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Acked-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

If input message rate from userspace is too high, do not drop them,
but try to deliver using work queue allocation.

Failing there is some kind of congestion control.

It also removes warn_on on this condition, which scares people.
Signed-off-by: Evgeniy Polyakov <johnpol@2ka.mipt.ru>
Signed-off-by: David S. Miller <davem@davemloft.net>

It's on the stack and declared as "unsigned char[]", but pointers
and similar can be in here thus we need to give it an explicit
alignment attribute.
Signed-off-by: Alex Williamson <alex.williamson@hp.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

The GRE, SCTP and TCP protocol helpers did not call
ip_conntrack_event_cache() when updating ct->status.  This patch adds
the respective calls.
Signed-off-by: Harald Welte <laforge@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

* Remove useless comment.
* Remove useless assertions.
* Remove useless comparison.
Signed-off-by: Alexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Alexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

From: Amos Waterland <apw@us.ibm.com>

If CONFIG_PROC_FS is not selected, the compiler emits this warning:

 net/core/neighbour.c:64: warning: `neigh_stat_seq_fops' defined but not used

Which is correct, because neigh_stat_seq_fops is in fact only
initialized and used by code that is protected by CONFIG_PROC_FS.  So
this patch fixes that up.
Signed-off-by: Amos Waterland <apw@us.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

We have to introduce a separate Kconfig menu entry for the NFQUEUE targets.
They cannot "just" depend on nfnetlink_queue, since nfnetlink_queue could
be linked into the kernel, whereas iptables can be a module.
Signed-off-by: Harald Welte <laforge@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

The wwitch bitmap was added to input_device_id structure and we should
check it when matching handlers and input devices.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Add 'volatile' to the __iomem pointers for these functions as
per x86.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

ucb1x00-ts declared a couple of one-bit 'int' bitfields.
Make them unsigned.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

This is one of those workarounds sucked over from sk98lin driver.
The skge driver needs to detect the Yukon-Lite A0 chip properly,
and turn of Rx FIFO Flush.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

We accidentally corrupted the TLS value when clearing out the ARMv6
exclusive monitor.  Avoid doing so.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

As davem points out, this wasn't such a great idea.  There may be some code
which does:

	size = 1024*1024;
	while (kmalloc(size, ...) == 0)
		size /= 2;

which will now explode.

Cc: "David S. Miller" <davem@davemloft.net>
Cc: Christoph Lameter <christoph@lameter.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Harald Welte <laforge@netfilter.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

I found an inconsistent spin_lock usage in ipmi_smi_msg_received.
Signed-off-by: Hironobu Ishii <hishii@soft.fujitsu.com>
Cc: Corey Minyard <minyard@acm.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Current kernel has a couple of sneaky bugs in the ppc64 hugetlb code that
cause huge pages to be potentially left stale in the hash table and TLBs
(improperly invalidated), with all the nasty consequences that can have.

One is that we forgot to set the "secondary" bit in the hash PTEs when
hashing a huge page in the secondary bucket (fortunately very rare).

The other one is on non-LPAR machines (like Apple G5s), flush_hash_range()
which is used to flush a batch of PTEs simply did not work for huge pages.
Historically, our huge page code didn't batch, but this was changed without
fixing this routine.  This patch fixes both.
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

- fix this:

  drivers/video/aty/xlinit.c: In function `atyfb_xl_init':
  drivers/video/aty/xlinit.c:256: warning: ISO C90 forbids mixed declarations and code

- repair some kooky coding style

- Use ARRAY_SIZE()

Cc: Tom 'spot' Callaway <tcallawa@redhat.com>
Cc: "Antonino A. Daplas" <adaplas@pol.net>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

usb_unlink_urb is always async now, so URB_ASYNC_UNLINK was removed from
core USB and we must do as well.
Signed-off-by: Karsten Keil <kkeil@suse.de>
Cc: Greg KH <greg@kroah.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Bhavesh P. Davda <bhavesh@avaya.com> noticed that SIGKILL wouldn't
properly kill a process under just the right cicumstances: a stopped
task that already had another signal queued would get the SIGKILL
queued onto the shared queue, and there it would remain until SIGCONT.

This simplifies the signal acceptance logic, and fixes the bug in the
process.

Losely based on an earlier patch by Bhavesh.
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

cifsd had been preventing software suspend from completing.

Signed-off-by: pavel@suse.de
Signed-off-by: Steve French <sfrench@us.ibm.com>  lightly modified
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

I believe the change that broke things is introduction of
pci_fixup_parent_subordinate_busnr().

The patch here does two things:
- hunk #1 should fix the problems you've seen when you boot without
  additional "pci" kernel options;
- hunk #2 supposedly fixes boot with "pci=assign-busses" option which
  otherwise hangs Acer TM81xx machines as reported.

Please try this with and without "pci=assign-busses". If it boots,
I'd like to see 'lspci -vvx' for both cases.
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

While this is true, E8390_CMD is zero on i386, and thus there should be no
effect for these machines.  Machines like Mac, Amiga etc. which use Alan's
clever register mapping may have a non-zero E8390_CMD and result in bogus
"transmitter busy" type messages from this bug.

Fixes BUG# 3991.

Fix to allow SCTP_SHUTDOWN notifications to be received on 1-1 style
SCTP SOCK_STREAM sockets.

Add SCTP_SHUTDOWN notification to the receive queue before updating
the state of the association.
Signed-off-by: Sridhar Samudrala <sri@us.ibm.com>
Signed-off-by: Neil Horman <nhorman@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>