After the patch "spi/s3c64xx: Fix non-dmaengine usage"
with commit id 563b444e
submitted by Mark Brown, the spi device detection in polling
mode breaks. This revealed the missing check for polling during
dma prepare. This patch adds the missing check.
Signed-off-by: Girish K S <ks.giri@samsung.com>
Signed-off-by: Mark Brown <broonie@linaro.org>

This should work with modern compilers, isn't that much of an issue if
it goes wrong and it ensures that the DT-only hardware variants don't
leave unreferenced parameters structures lying around.
Signed-off-by: Mark Brown <broonie@linaro.org>

This patch adds support for the exynos5440 spi controller.
The integration of the spi IP in exynos5440 is different from
other SoC's. The I/O pins are no more configured via gpio, they
have dedicated pins.
Signed-off-by: Girish K S <ks.giri@samsung.com>
Signed-off-by: Mark Brown <broonie@linaro.org>

The existing driver supports gpio based /cs signal.
For controller's that have one device per controller,
the slave device's /cs signal might be internally controlled
by the chip select bit of slave select register. They are not
externally asserted/deasserted using gpio pin.

This patch adds support for controllers with dedicated /cs pin.
if "cs-gpio" property doesnt exist in a spi dts node, the controller
would treat the /cs pin as dedicated.
Signed-off-by: Girish K S <ks.giri@samsung.com>
Signed-off-by: Mark Brown <broonie@linaro.org>

The binding definition is based on the generic DMA request binding
Signed-off-by: Matt Porter <mporter@ti.com>
Signed-off-by: Joel A Fernandes <joelagnel@ti.com>
Signed-off-by: Sourav Poddar <sourav.poddar@ti.com>
Signed-off-by: Mark Brown <broonie@linaro.org>

Convert dmaengine channel requests to use
dma_request_slave_channel_compat(). This supports the DT case of
platforms requiring channel selection from either the OMAP DMA or
the EDMA engine. AM33xx only boots from DT and is the only user
implementing EDMA so in the !DT case we can default to the OMAP DMA
filter.
Signed-off-by: Matt Porter <mporter@ti.com>
Acked-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: Joel A Fernandes <joelagnel@ti.com>
Signed-off-by: Sourav Poddar <sourav.poddar@ti.com>
Signed-off-by: Mark Brown <broonie@linaro.org>

Pull ARM SoC fixes from Arnd Bergmann:
 "These are two fixes that came in this week, one for a regression we
  introduced in 3.10 in the GIC interrupt code, and the other one fixes
  a typo in newly introduced code"

* tag 'fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc:
  irqchip: gic: call gic_cpu_init() as well in CPU_STARTING_FROZEN case
  ARM: dts: Correct the base address of pinctrl_3 on Exynos5250

Merge tag 'driver-core-3.10-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/driver-core

Pull driver core fix from Greg Kroah-Hartman:
 "Here's a single patch for the firmware core that resolves a reported
  oops in the firmware core that people have been hitting."

* tag 'driver-core-3.10-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/driver-core:
  firmware loader: fix use-after-free by double abort

Pull USB fixes from Greg Kroah-Hartman:
 "Here are two USB patches for 3.10.

  One updates the Kconfig wording for CONFIG_USB_PHY to make it,
  hopefully, more obvious what this option is (I know you complained
  about this when it hit the tree.) The other is a new device id for a
  driver"

* tag 'usb-3.10-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/usb:
  USB: serial: ti_usb_3410_5052: new device id for Abbot strip port cable
  usb: phy: Improve Kconfig help for CONFIG_USB_PHY

Pul tty fixes from Greg Kroah-Hartman:
 "Here are two tty core fixes that resolve some regressions that have
  been reported recently.  Both tiny fixes, but needed"

* tag 'tty-3.10-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/tty:
  tty: Fix transient pty write() EIO
  tty/vt: Return EBUSY if deallocating VT1 and it is busy

Pull SCSI target fixes from Nicholas Bellinger:
 "Included is the recent tcm_qla2xxx residual underrun length fix from
  Roland, along with Joern's iscsi-target patch for session_lock
  breakage within iscsit_stop_time2retain_timer() code.  Both are CC'ed
  to stable.

  The remaining two are specific to recent iscsi-target + iser
  conversion changes.  One drops some left-over debug noise, and Andy's
  patch fixes configfs attribute handling during an explicit network
  portal feature bit disable when iser-target is unsupported."

* git://git.kernel.org/pub/scm/linux/kernel/git/nab/target-pending:
  iscsi-target: Remove left over v3.10-rc debug printks
  target/iscsi: Fix op=disable + error handling cases in np_store_iser
  tcm_qla2xxx: Fix residual for underrun commands that fail
  target/iscsi: don't corrupt bh_count in iscsit_stop_time2retain_timer()

Pull media fixes from Mauro Carvalho Chehab:
 "Another set of fixes for Kernel 3.10.

  This series contain:
   - two Kbuild fixes for randconfig
   - a buffer overflow when using rtl28xuu with r820t tuner
   - one clk fixup on exynos4-is driver"

* 'v4l_for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/mchehab/linux-media:
  [media] Fix build when drivers are builtin and frontend modules
  [media] s5p makefiles: don't override other selections on obj-[ym]
  [media] exynos4-is: Fix FIMC-IS clocks initialization
  [media] rtl28xxu: fix buffer overflow when probing Rafael Micro r820t tuner

Pull vfs fixes from Al Viro:
 "Several fixes for bugs caught while looking through f_pos (ab)users"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/viro/vfs:
  aout32 coredump compat fix
  splice: don't pass the address of ->f_pos to methods
  mconsole: we'd better initialize pos before passing it to vfs_read()...

dump_seek() does SEEK_CUR, not SEEK_SET; native binfmt_aout
handles it correctly (seeks by PAGE_SIZE - sizeof(struct user),
getting the current position to PAGE_SIZE), compat one seeks
by PAGE_SIZE and ends up at PAGE_SIZE + already written...
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>

Pull x86 fixes from Peter Anvin:
 "This series fixes a couple of build failures, and fixes MTRR cleanup
  and memory setup on very specific memory maps.

  Finally, it fixes triggering backtraces on all CPUs, which was
  inadvertently disabled on x86."

* 'x86/urgent' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  x86/efi: Fix dummy variable buffer allocation
  x86: Fix trigger_all_cpu_backtrace() implementation
  x86: Fix section mismatch on load_ucode_ap
  x86: fix build error and kconfig for ia32_emulation and binfmt
  range: Do not add new blank slot with add_range_with_merge
  x86, mtrr: Fix original mtrr range get for mtrr_cleanup